Yamaha FGX700SC Handleiding
Lees hieronder de 📖 handleiding in het Nederlandse voor Yamaha FGX700SC (2 pagina's) in de categorie Gitaar. Deze handleiding was nuttig voor 8 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/2
PRECAUTIONS
The output jack is an EIAJ-standard 1/4" phone jack. Be sure to use
an appropriate connection cable.
The built-in preamplifier is automatically turned on when a plug is
inserted into the output jack. When not using the instrument, or when
playing it without amplification, be sure to remove the plug from the
output jack so that the preamplifier power is turned off.
Always set the VOLUME control to “0” when plugging in or
unplugging the connection cable.
The battery check indicator (BATT.) will light briefly when a plug is
inserted or removed from the output jack. This is normal and does not
indicate a malfunction.
Be sure to remove the battery if the instrument will not be used for an
extended period of time in order to prevent possible damage due to
battery leakage.
Owner’s Manual
Thank you for choosing a Yamaha electric-acoustic guitar.
In order to make the most of the advanced features and
performance provided by your guitar, please read this
manual carefully before using the instrument.
BATTERY REPLACEMENT
Be sure to replace the battery as soon as possible when the battery check
indicator lights in order to avoid reduced sound quality.
* Be sure to remove the battery if the instrument will not be used for an extended
period of time in order to prevent possible damage due to battery leakage.
qPress the catch on the battery holder in the direction indicated by the arrow
in the illustration in order to unlock it.
wSlide out the battery case.
eRemove the old battery from the battery case, and insert the new battery
making sure that the (+) and (–) terminals of the battery are positioned as
shown in the illustration. Use only a DC9V, S-006P (6F22) or equivalent
battery.
rSlide the battery case back into the battery holder and press firmly so
that the battery case locks into place.
ELECTRIC
ACOUSTIC GUITAR
Battery Holder
Control Section
Bar Sensor
NOMENCLATURE
Output Jack (with power switch function)
SPECIFICATIONS
System SYSTEM-55T: Monaural 1 way
Pickup Bar Sensor (Piezo type)
Pre-amplifier Controls
VOL., 3 Band (HIGH, MID, LOW) EQ
control, AMF control
Output jack Combination end pin/power switch
Output impedance 1 kΩ
Power supply 9V DC, S-006P (6F22) dry cell battery
Battery life Approx. 150 hours (without tuner)
Approx. 140 hours (with the preamp
switched ON and the tuner used 1 minute
every 1 hour)
Tuner Tuning System: Chromatic type (12
semitones), A4=440Hz
Auto OFF Function: Tuner automatically
switches OFF after 2 minutes.
Input: Built in pickup (bridge bar sensor)
Accuracy: +/– 3 cents
Accessories • Hexagonal wrench for neck adjustment x1
• S-006P (6F22) dry cell battery x1
THE CONTROLS
USING THE TUNER
The guitar is equipped with an A4=440Hz standard pitch tuner. The
tuner’s circuitry is independent from the guitar’s output circuit so
switching the tuner ON/OFF will have no affect on sound output.
qPress the TUNER switch. While the tuner activates the and lamps
light alternately.
wTune the guitar string until the note name of the desired pitch appears in
the tuner’s display.
The lamp indicates the pitch is low.
The lamp indicates the pitch is high.
The pitch indicator ( ) flashes slower as the string’s pitch nears the
note shown in the display.
eThe string is in tune when the and lamps both light.
* The tuner will automatically switch OFF approximately two minutes after the
TUNER switch is pressed (energy saving function). To continue tuning, press
the TUNER switch again.
* It may take a few seconds before the tuner can detect pitches after being switched
ON.
* The note name and displays may have difficulty keeping up with irregular
pitch changes. Gradually change the pitch and check when tuning.
* The tuner may have difficulty detecting notes rich with overtones or with very
short sustain.
qw
rty
e3 Band Equalizer
LOW : Boosts or cuts the level of the low frequencies.
MID : Boosts or cuts the level of the middle frequencies.
The AMF control r adjusts the center frequency of the band
affected by this control.
HIGH : Boosts or cuts the level of the high frequencies.
rAMF Control
Sets the center frequency of the band of frequencies affected by the MID
equalizer control. The range is from 80 Hz to 10 kHz.
* This control has no effect when the MID equalizer control is set to its center
(“0”) position.
tTuner Switch
Switches the tuner ON/OFF.
yTuner Display
Displays tuner information.
qVOL. (Volume) Control
Adjusts the overall output volume level.
* Make sure that the VOL. is turned to “0”
before connecting or disconnecting.
wBATT. (Battery Check) Indicator
This indicator will light when the battery
needs to be replaced.
Please replace the battery as soon as
possible when the BATT. indicator lights.
OPEN
Catch
DC9V S-006P
(6F22)
Battery case
q
OP E
N
w, r e
w
r
Product specificaties
| Merk: | Yamaha |
| Categorie: | Gitaar |
| Model: | FGX700SC |
Heb je hulp nodig?
Als je hulp nodig hebt met Yamaha FGX700SC stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Gitaar Yamaha
4 Juni 2023
31 Mei 2023
29 Mei 2023
24 Mei 2023
24 Mei 2023
23 Mei 2023
21 Mei 2023
9 Mei 2023
6 Mei 2023
5 Mei 2023
Handleiding Gitaar
- Gitaar Behringer
- Gitaar Boss
- Gitaar Fender
- Gitaar Line 6
- Gitaar Peavey
- Gitaar Pyle
- Gitaar Sennheiser
- Gitaar Orange
- Gitaar Aria
- Gitaar Chord
- Gitaar Ibanez
- Gitaar Ultrasound Amplifiers
- Gitaar Epiphone
- Gitaar Bugera
- Gitaar Gretsch
- Gitaar Gretsch Guitars
- Gitaar AER
- Gitaar Warwick
- Gitaar Cordoba
- Gitaar Gallien-Krueger
- Gitaar Traveler Guitar
- Gitaar Carlsbro
Nieuwste handleidingen voor Gitaar
2 Oktober 2024
23 Juli 2024
7 Mei 2024
4 Mei 2024
3 Mei 2024
6 Maart 2024
20 Januari 2024
20 Januari 2024
20 Januari 2024