Xiaomi Viomi L1 UV Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Xiaomi Viomi L1 UV (9 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 246 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/9
water input hole
dust protection cover
cartridge
tank for
untreated
water
tank for clear water
cover
life indicator of
cartridge
start button
reminder of cartridge
replacement
remainder of life of
a cartridge
it is time to replace
a cartridge
Ultraviolet
disinfection device
Accessories: 2 cartridges
USB - cable
Water Filter Quick start
1. Unpacking of î‚¿lter and cartridge
Remove a î‚¿lter cartridge from packaging, wash and wipe it
with a dry cloth.
Note: Do not wash the î‚¿lter in a dishwasher, do not immerse
it in water and do not wash hole for charging.
2. First soak of a cartridge
Immerse cartridge in water at room temperature for 10
minutes, gently shake it to remove air pockets. After 10
minutes of total soaking of a cartridge, remove it from the
water.
Recommendation: Use distilled (puriî‚¿ed) water to soak a
cartridge for better ltering eect activation.
Note: please do not soak a cartridge in a tank for treated
water to avoid damaging ultraviolet lamp.
3. Installation and clearing of î‚¿lter
After soaking of cartridge, place it in a
container for untreated water, intended for his
place and make sure it is at against the wall.
Then place a tank for untreated water over
container for puriî‚¿ed water.
Remove a top cover, pour water into the tank
for untreated water, î‚¿lling it completely. Let
water pass through î‚¿lter cartridge. Repeat
procedure 2 times. Then wash cartridge.
Please do not drop a cartridge to tank for
treated water.
4. Turning indicator of life of a cartridge
Hold start button for 3 seconds until a light
turns on, then release a button. Since then
count out the lifetime of a cartridge.
5. Notice
During the î‚¿rst use of a cartridge, puriî‚¿ed water can be gray in color, this is due to the
activation of activated carbon in toner cartridges. This is normal and it will pass after a
single 2-î‚¿ltration cartridge. Do not use water that has been used for î‚¿ltration cartridge for
drinking, it is suitable for domestic use.
Operating Instructions
Adding water
Through the hole for pouring water add
a water from the tap to tank for untreated
water.
1. Limit of the î‚¿lter capacity is 1.5 l. While adding water, please make sure that water
does not extend beyond this limit.
2. If water pressure is insucient to activate an automatic shutter, in this case, open it
yourself.
3. To ensure thorough disinfection of water UV light will burn for 2 minutes.
4. UV LED lights up only when quartz tube disinfection device will be completely
immersed in water.
5. Disinfection device can only use water that meets the «Sanitary norms of drinking
water» (gb5749-2006), please do not use it for other purposes.
Filtration
Completely î‚¿ll a tank for untreated water
(1.5 L), then water will ow through the
cartridge î‚¿lter and fall into tank of puriî‚¿ed
water.
Disinfection
When water not yet reached the level of
UV lamp, press a button to turn the UV
disinfection. After 2 minutes, it automatically
expires. You can just use water.
Quick start
Charging UV disinfection device
Connect micro-USB to a battery of
ultraviolet disinfection device. During
charging, indicator will light red, and when
battery is fully charged, indicator light turns
blue.
Note: Do not use a î‚¿lter during charging.


Product specificaties

Merk: Xiaomi
Categorie: Niet gecategoriseerd
Model: Viomi L1 UV

Heb je hulp nodig?

Als je hulp nodig hebt met Xiaomi Viomi L1 UV stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Xiaomi

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd