Whirlpool YGY397LXUS Handleiding

Whirlpool Fornuis YGY397LXUS

Lees hieronder de 📖 handleiding in het Nederlandse voor Whirlpool YGY397LXUS (20 pagina's) in de categorie Fornuis. Deze handleiding was nuttig voor 33 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/20
INSTALLATION INSTRUCTIONS
SLIDE-IN ELECTRIC RANGES
INSTRUCTIONS D’INSTALLATION DES CUISINIÈRES
ÉLECTRIQUES ENCASTRABLE
Table of Contents/Table des matières
RANGE SAFETY .............................................................................2
INSTALLATION REQUIREMENTS................................................3
Tools and Parts ............................................................................3
Location Requirements................................................................3
Electrical Requirements - U.S.A. Only.........................................4
Electrical Requirements - Canada Only.......................................5
Countertop Preparation ...............................................................5
INSTALLATION INSTRUCTIONS..................................................6
Unpack Range..............................................................................6
Adjust Leveling Legs....................................................................6
Install Anti-Tip Bracket.................................................................6
Electrical Connection - U.S.A. Only.............................................7
Verify Anti-Tip Bracket Location ................................................12
Level Range................................................................................12
Complete Installation .................................................................13
Moving the Range......................................................................13
SÉCURITÉ DE LA CUISINIÈRE ...................................................14
EXIGENCES D'INSTALLATION...................................................15
Outillage et pièces......................................................................15
Exigences d'emplacement.........................................................15
Spécifications électriques ..........................................................17
Préparation du plan de travail ....................................................17
INSTRUCTIONS D'INSTALLATION.............................................18
Déballage de la cuisinière ..........................................................18
Réglage des pieds de nivellement .............................................18
Installation de la bride antibasculement ....................................18
Vérification de l'emplacement de la bride antibasculement......19
Réglage de l'aplomb de la cuisinière.........................................19
Achever l'installation ..................................................................19
Déplacement de la cuisinière.....................................................20
IMPORTANT:
Save for local electrical inspector's use.
IMPORTANT :
À conserver pour consultation par l'inspecteur local des installations électriques.
8101P750-60
2
RANGE SAFETY
You can be killed or seriously injured if you don't immediately
You can be killed or seriously injured if you don't follow
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.”
These words mean:
follow instructions.
instructions.
DANGER
WARNING
WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Connect anti-tip bracket to rear range foot.
Reconnect the anti-tip bracket, if the range is moved.
Failure to follow these instructions can result in death or serious burns to children and adults.
3
INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools needed
Parts supplied
Check that all parts are included.
■3 - 10–32 hex nuts (attached to terminal block)
■3 - Terminal lugs
■2 - Oven racks
■2 - #12 x 1⁵⁄₈" screws (for mounting anti-tip bracket)
■Anti-tip bracket (taped inside storage drawer)
Anti-tip bracket must be securely mounted to back wall or
floor. Thickness of floor may require longer screws to anchor
bracket to sub-floor. Longer screws are available from your
local hardware store.
Parts needed
If using a power supply cord:
■A UL listed power supply cord kit marked for use with ranges.
The cord should be rated at 250 volts minimum, 40 amps or
50 amps that is marked for use with nominal 1³⁄₈" (3.5 cm)
diameter connection opening and must end in ring terminals
or open-end spade terminals with upturned ends.
■A UL listed strain relief.
Check local codes. Check existing electrical supply. See
“Electrical Requirements” section.
It is recommended that all electrical connections should be made
by a licensed, qualified electrical installer.
Location Requirements
IMPORTANT: Observe all governing codes and ordinances.
■It is the installer’s responsibility to comply with installation
clearances specified on the model/serial rating plate. The
model/serial rating plate is located on the right-hand side of
the oven frame behind the storage drawer panel.
■The range should be located for convenient use in the
kitchen.
■To eliminate the risk of burns or fire by reaching over heated
surface units, cabinet storage space located above the
surface units should be avoided. If cabinet storage is to be
provided, the risk can be reduced by installing a range hood
that projects horizontally a minimum of 5" (12.7 cm) beyond
the bottom of the cabinets.
■Cabinet opening dimensions that are shown must be used.
Given dimensions are minimum clearances.
■The floor anti-tip bracket must be installed. To install the anti-
tip bracket shipped with the range, see “Install Anti-Tip
Bracket” section.
■Grounded electrical supply is required. See “Electrical
Requirements” section.
IMPORTANT: To avoid damage to your cabinets, check with your
builder or cabinet supplier to make sure that the materials used
will not discolor, delaminate or sustain other damage. This oven
has been designed in accordance with the requirements of UL
and CSA International and complies with the maximum allowable
wood cabinet temperatures of 194°F (90°C).
Mobile Home - Additional Installation Requirements
The installation of this range must conform to the Manufactured
Home Construction and Safety Standard, Title 24 CFR, Part 3280
(formerly the Federal Standard for Mobile Home Construction
and Safety, Title 24, HUD Part 280). When such standard is not
applicable, the Standard for Manufactured Home Installations,
ANSI A225.1/NFPA 501A or with local codes.
Mobile home installations require:
■When this range is installed in a mobile home, it must be
secured to the floor during transit. Any method of securing
the range is adequate as long as it conforms to the standards
listed above.
■Four-wire power supply cord or cable must be used in a
mobile home installation. The appliance wiring will need to be
revised. See “Electrical Connection” section.
Product Dimensions
*Range can be raised approximately 1" (2.5 cm) by adjusting
the leveling legs.
**When installed in a 24" (61 cm) base cabinet with 25" (63.5 cm)
countertop; front of oven door protrudes 2¹⁄₂" (6.4 cm) beyond
24" (61 cm) base cabinet.
■Tape measure
■Level
■Phillips screwdriver
■Flat-blade screwdriver
■Wrench or pliers
■³⁄₈" nut driver
■Hand or electric drill
■¹⁄₈" (3.2 mm) drill bit
A. 30³⁄₄" (78.1 cm)
B. 35³⁄₄" (90.8 cm) height to underside
of cooktop edge with leveling legs
screwed all the way in*
C. Model/serial number plate (located
behind the storage drawer on the
right-hand side of the oven frame
D. 29⁷⁄₈" (75.9 cm)
E. 28⁵⁄₁₆" (71.9 cm) from
handle to standoff at back
of range**
F. 2 3 ³⁄₄" (60.3 cm)
countertop notch to rear
of cooktop
C
B*
A
D
E**
F

Product specificaties

Merk: Whirlpool
Categorie: Fornuis
Model: YGY397LXUS

Heb je hulp nodig?

Als je hulp nodig hebt met Whirlpool YGY397LXUS stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Fornuis Whirlpool

Whirlpool

Whirlpool AKW 7523/NB Handleiding

15 November 2024
Whirlpool

Whirlpool WS S4060 BF Handleiding

15 November 2024
Whirlpool

Whirlpool WVHF83BB UKIT Handleiding

24 September 2024
Whirlpool

Whirlpool WB S4360 CPNE Handleiding

24 September 2024
Whirlpool

Whirlpool WS67V5KHW Handleiding

21 Augustus 2024
Whirlpool

Whirlpool AKT 625/WH Handleiding

8 Augustus 2024
Whirlpool

Whirlpool AKTL 629/NB1 Handleiding

8 Augustus 2024
Whirlpool

Whirlpool POW 75D2/NB Handleiding

7 Augustus 2024
Whirlpool

Whirlpool GMWL 958/IXL Handleiding

6 Augustus 2024
Whirlpool

Whirlpool WFES3330RZ Handleiding

31 Juli 2024

Handleiding Fornuis

Nieuwste handleidingen voor Fornuis

Concept

Concept SDV4360 Handleiding

22 November 2024
LG

LG LDE3017SB Handleiding

22 November 2024
LG

LG CBIZ2435B Handleiding

22 November 2024
Electrolux

Electrolux WOK38TSILO Handleiding

22 November 2024
Electrolux

Electrolux GK38TSILO Handleiding

22 November 2024
Electrolux

Electrolux TY38TSILCN Handleiding

22 November 2024
Bosch

Bosch PKE612CA2E Handleiding

22 November 2024
Candy

Candy CSG64SWGX Handleiding

22 November 2024
Concept

Concept SDV4330 Handleiding

22 November 2024
Concept

Concept IDV3330 Handleiding

22 November 2024