Whirlpool WEIC 3C26 F Handleiding

Whirlpool Vaatwassers WEIC 3C26 F

Lees hieronder de 📖 handleiding in het Nederlandse voor Whirlpool WEIC 3C26 F (8 pagina's) in de categorie Vaatwassers. Deze handleiding was nuttig voor 48 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/8

DAILY REFERENCE

GUIDE

Before using the appliance carefully read Health and Safety guide.

APPLIANCE

PRODUCT DESCRIPTION

CONTROL PANEL

1. On-O/Reset button with indicator light

2. Program selection button

3. Salt rell indicator light

4. Rinse Aid rell indicator light

5. Program number and delay time indicator

6. Delay indicator light

7. Display

8. Multizone indicator light

9. Delay button

10. Multizone button

11. Tablet (Tab) button with indicator light

THANK YOU FOR BUYING A WHIRLPOOL PRODUCT.

In order to receive a more complete assistance, please

www.whirlpool.eu/register

You can download the Safety Instructions and the

Use and Care Guide, by visiting our website

docs.whirlpool.eu and following

the Instructions on the back of this booklet.

1 2 3 4 5 6 7 8 9 10 11

1. Upper rack

2. Cutlery rack

3. Foldable aps

4. Upper rack height adjuster

5. Upper spray arm

6. Lower rack

7. Lower spray arm

8. Filter Assembly

9. Salt reservoir

10. Detergent and Rinse Aid dispensers

11. Rating plate

12. Control panel

0000 000 00000

Service:

FIRST TIME USE

SALT, RINSE AID AND DETERGENT

ADVICE REGARDING THE FIRST TIME USE

After installation, remove the stoppers from the racks and the reta-

ining elastic elements from the upper rack.

FILLING THE SALT RESERVOIR

The use of salt prevents the formation of LIMESCALE on the dishes and

on the machine’s functional components.

• It is important that the salt reservoir be never empty.

• It is important to set the water hardness.

The salt reservoir is located in the lower part of the dishwasher

(see PRODUCT DESCRIPTION) and should be lled when the SALT

REFILL indicator light in the control panel is lit .

1. Remove the lower rack and unscrew the

reservoir cap (anticlockwise).

2. -Only the rst time you do this: ll the salt re

servoir with water.

3. Position the funnel (see gure) and ll the salt

reservoir right up to its edge (approximately

1 kg); it is not unusual for a little water to leak

out.

4. Remove the funnel and wipe any salt residue

away from the opening.

Make sure the cap is screwed on tightly, so that no detergent can get

into the container during the wash program (this could damage the

water softener beyond repair).

Whenever you need to add salt, it is mandatory to complete the

procedure before the beginning of the washing cycle.

SETTING THE WATER HARDNESS

To allow the water softener to work in a perfect way, it is essential that

the water hardness setting is based on the actual water hardness in

your house. This information can be obtained from your local water

supplier.

The factory setting is for avarage (3) water hardness.

•SwitchontheappliancebypressingtheON/OFF button.

•SwitchotheappliancebypressingtheON/OFF button.

•HolddownbuttonP for 5 seconds, until you hear a beep.

•SwitchontheappliancebypressingtheON/OFF button.

•Thecurrentselectionlevelnumberand thesaltindicatorlightboth

ash.

•PressbuttonP to select the desired hardness level (see WATER

HARDNESS TABLE).

•SwitchotheappliancebypressingtheON/OFF button.

Setting is complete!

As soon as this procedure is complete, run a program without loading.

Only use salt that has been specically designed for dishwashers.

After the salt has been poured into the machine, the SALT REFILL indi-

cator light switches o.

If the salt container is not lled, the water softener and the

heating element may be damaged as a result.

FILLING THE RINSE AID DISPENSER

Rinse aid makes dish DRYING easier. The rinse aid dispenser shouldA

be lled when the in the controlRINSE AID REFILL indicator light

panel is lit.

1. Open the dispenser by pressing and pulling up the tab on the lidB .

2. Pour in the rinse aid (max.110 ml), making sure it does not overow

from the dispenser. If this happens, clean the spill immediately with a

dry cloth.

3. Press the lid down until you hear a click to close it.

NEVER pour the rinse aid directly into the appliance tub.

ADJUSTING THE DOSAGE OF RINSE AID

If you are not completely satised with the drying results, you can ad-

just the quantity of rinse aid used.

•SwitchthedishwasheronusingtheON/OFF button.

•SwitchitousingtheON/OFF button.

•PressbuttonP three times - a beep will be heard.

•SwitchitonusingtheON/OFF button.

•Thecurrentselectionlevelnumberandrinseaidindicatorlightash.

•PressbuttonP to select the level of rinse aid quantity to be

supplied.

•SwitchitousingtheON/OFF button

Setting is complete!

If the rinse aid level is set to ZERO (ECO), no rinse aid will be supplied. The

LOW RINSE AID indicator light will not be lit if you run out of rinse aid.

A maximum of 4 levels can be set according to the dishwasher model. The

factory setting is specic to the model, please follow instruction above

to check this for your machine.

• If you see bluish streaks on the dishes, set a low number (1-2).

• If there are drops of water or limescale marks on the dishes, set a

mid-range number (3-4).

FILLING THE DETERGENT DISPENSER

To open the detergent dispenser

use the opening device A. Introduce

the detergent into the dry dispenser

B only. Place the amount of

detergent for pre-washing directly

inside the tub.

1. When measuring out the detergent re-

fer to the mentioned earlier information

to add the proper quantity. Inside the

dispenser B there are indications to help

the detergent dosing.

2. Remove detergent residues from the edges of the dispenser and

close the cover until it clicks.

3. Close the lid of the detergent dispenser by pulling it up until the

closing device is secured in place.

The detergent dispenser automatically opens up at the right time

according to the program.

If all-in-one detergents are used, we recommend using the TABLET

button, because it adjusts the program so that the best washing and

drying results are always achieved.

Water Hardness Table

Level °dH

German degrees

°fH

French degrees

1 Soft 0 - 6 0 - 10

2 Medium 7 - 11 11 - 20

3 Average 12 - 17 21 - 30

4 18 - 34 31 - 60Hard

5 Very hard 35 - 50 61 - 90

PROGRAMS TABLE

PROGRAMS DESCRIPTION

Program

Drying

NaturalDry

Available

options *)

Detergent

container Duration

of wash

program

(h:min)**)

Water con-

sumption

(litres/cycle)

Energy con-

sumption

(kWh/cycle)

Tub B

1. Eco 50° 3:10 9,5 0,93

2. 6th Sense®50-

60° 1:25 - 3:00 7,0 - 14,0 0,90 - 1,40

3. Intensive 65° - - 2:50 16,0 1,60

4. Daily 50° - 1:35 13,0 1,15

5. Silent 50° - - 3:30 15,0 1,15

6. Rapid 30’ 50° - - -0:30 9,0 0,55

7. Crystals 45° - -1:40 11,5 1,20

8. Pre-Wash - - - - - 0:12 4,5 0,01

Instructions on wash cycle selection.

ECO

Normally soiled crockery. Standard program, the most ecient in

terms of its combined energy and water consumption.

6th SENSE®

For normally soiled dishes with dried food residues. Senses the level of

soiling on the dishes and adjusts the program accordingly. When the

sensor is detecting the soil level an animation appears in the display

and the cycle duration is updated.

INTENSIVE

Program recommended for heavily soiled crockery, especially suitable

for pans and saucepans (not to be used for delicate items).

DAILY

Normally soiled crockery. Everyday cycle, that ensures optimal

cleaning performance in shorter time.

SILENT

Suitable for night-time operation of the appliance. Ensures optimal

cleaning and drying performance with the lowest noise emission.

RAPID 30’

Program to be used for lightly-soiled dishes with no dried food

residues.

CRYSTALS

Program for delicate items, which are more sensitive to high tempera-

tures, for example glasses and cups.

PRE-WASH

Use to refresh crockery planned to be washed later. No detergent to be

used with this program.

Notes:

Please note that cycles like Rapid or 1h Wash&Dry are most eective for

lightly soiled dishes.

To reduce consumption even further, only run the dishwasher

when it is full.

ECO program data is measured under laboratory conditions according to European Standard EN 50242. Note for Test Laboratories: For information on

comparative EN testing conditions, please send an email to the following address: dw_test_support@whirlpool.com

Pre-treatment of the dishes is not needed before any of the programs.

*) Not all options can be used simultaneously.

**) The duration of the program shown on the display or in the booklet is an estimate calculated on standard conditions. The actual time may vary

depending on many factors such as temperature and pressure of the incoming water, room temperature, amount of detergent, quantity and type of load,

load balancing, additional selected options and sensor calibration. The sensor calibration can increase program duration up to 20 min.

Standby consumption: Left-on mode consumption: 6 W - O mode consumption: 0.5 W

Product specificaties

Merk:	Whirlpool
Categorie:	Vaatwassers
Model:	WEIC 3C26 F
Apparaatplaatsing:	Volledig ingebouwd
Soort bediening:	Buttons, Sensor
Ingebouwd display:	Ja
Gewicht:	35500 g
Breedte:	595 mm
Diepte:	570 mm
Hoogte:	820 mm
Netbelasting:	5 W
Aantal couverts:	14 couverts
Droogsysteem:	Statisch
Deurkleur:	Niet van toepassing
Snoerlengte:	1.3 m
Uitgestelde start timer:	Ja
Startvertraging:	12 uur
Duur cyclus:	220 min
Geluidsniveau:	46 dB
Energie-efficiëntieklasse:	E
Gewicht verpakking:	37500 g
Breedte verpakking:	650 mm
Diepte verpakking:	675 mm
Hoogte verpakking:	910 mm
Waterconsumptie per cyclus:	9 l
Stroom:	10 A
Geluidsemissieklasse:	C
Aantal wasprogramma's:	8
Energieverbruik per 100 cycli:	95 kWu
Verstelbare voeten:	Ja
Kleur bedieningspaneel:	Roestvrijstaal
Bestek compartiment type:	Mand
Zout indicator:	Ja
Glansmiddel indicator:	Ja
Multitab optie:	Ja
Bescherming tegen overstromen:	Ja
Aantal temperatuurinstellingen:	3
Afwasprogramma's:	Glass/delicate, Intensive, Night, Pre-wash, Quick
Energieverbruik per cyclus:	- kWu
Lengte afvoerslang:	1.5 m
Lengte watertoevoerslang:	1.55 m
Temperatuur (max):	60 °C
Manden verstelbare plaatsing:	Lower, Upper
Stroomverbruik (indien uit):	0.5 W
AC-ingangsspanning:	220 - 240 V
AC-ingangsfrequentie:	50 Hz
Energie-efficiëntieschaal:	A tot G