Whirlpool AWZ 3411 Handleiding

Whirlpool Wasdroger AWZ 3411

Lees hieronder de ๐Ÿ“– handleiding in het Nederlandse voor Whirlpool AWZ 3411 (20 pagina's) in de categorie Wasdroger. Deze handleiding was nuttig voor 34 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/20
3
CONTENTS
QUICK REFERENCE GUIDE
PROGRAMME CHART
PREPARING THE LAUNDRY
SELECTING A PROGRAMME AND OPTIONS
STARTING AND COMPLETING A PROGRAMME
CHANGING A PROGRAMME
INTERRUPTING A PROGRAMME
DAILY MAINTENANCE AND CLEANING
INSTRUCTIONS FOR USE
BOOKLET
BEFORE USING THE DRYER / CONNECTIONS PAGE 4
ELECTRICAL CONNECTION PAGE 5
PRECAUTIONS AND GENERAL
RECOMMENDATIONS PAGE 6
DESCRIPTION OF THE DRYER PAGE 7
VENT CONNECTION PAGE 8
DOOR REVERSIBILITY PAGE 9
TROUBLESHOOTING GUIDE / AFTER-SALES SERVICE PAGE 10
4
BEFORE USING THE DRYER / CONNECTIONS
1. Removing the packaging and check
๎‚•After unpacking, make sure that the dryer is
undamaged. If in doubt, do not use the dryer.
Contact After-Sales Service or your local retailer.
๎‚•Keep the packaging materials (plastic bags,
polystyrene parts, etc.) out of reach of children, as
they are potentially dangerous.
2. Electrical Connections
๎‚•Electrical connections must be carried out by a
qualified technician in compliance with the
manufacturerโ€™s instructions and current standard
safety regulations.
๎‚•Electrical connection must comply with local
Electricity Board regulations.
๎‚•Voltage information, power consumption and the
required fuse protection is shown on the rating
plate mounted at the rear of the dryer.
๎‚•The manufacturer cannot accept any liability for
personal injury or damage to property resulting
from failure to adhere to these instructions.
๎‚•The dryer must be earthed as prescribed by law.
๎‚•Do not use extension leads or multiple adaptors.
๎‚•Before any maintenance on the dryer disconnect it
from the mains supply.
๎‚•Do not operate the dryer if it has been damaged
during transport. Contact one of our After-Sales
Service technicians.
๎‚•Mains cable replacement is only to be carried out by
After-Sales Service.
๎‚•After installation access to the mains plug has to be
guaranteed, or the all-pole disconnection has to be
possible with a switch.
3. Installation
โ€ข Do not install your dryer where it can be subject
to extreme conditions, such as: poor ventilation,
temperatures around freezing (or above 35ยฐC).
โ€ข Remove the protective foil from the control panel.
โ€ข Take care not to install the dryer on a deep-pile
carpet.
Stability:
When installing the dryer always carefully level the
dryer adjusting the two feet and check the correct
levelling with a spirit level.
To built in the dryer
โ€ข For security reasons do not remove the
worktop.
โ€ข Connect the dryer to an external ventilation
system in order to prevent steam from damaging
your furniture during the years.
Stacking kit
Your dryer can be stacked on top of your front
loading washing machine. The type of stacking kit is
stated in the Instruction for use of your washing
machine or pls. contact your dealer or our After
Sales Service.
Minimum housing dimensions:
Width: 600 mm
Height: 850 mm
Depth: 560 mm
5
ELECTRICAL CONNECTION
1) For Great Britain only
Warning - this appliance must be earthed
Fuse replacement
If the mains lead of this appliance is fitted with a BS 1363A 13amp
fused plug, to change a fuse in this type of plug use an A.S.T.A.
approved fuse to BS 1362 type and proceed as follows:
1.Remove the fuse cover (A) and fuse (B).
2.Fit replacement 13A fuse into fuse cover.
3.Refit both into plug.
Important:
The fuse cover must be refitted when changing a fuse and if the fuse
cover is lost the plug must not be used until a correct replacement is
fitted.
Correct replacement are identified by the colour insert or the colour
embossed in words on the base of the plug.
Replacement fuse covers are available from your local electrical
store.
2) For the Republic of Ireland only
The information given in respect of Great Britain will frequently
apply, but a third type of plug and socket is also used, the
2-pin, side earth type.
3) Socket outlet / plug (valid for both countries)
If the fitted plug is not suitable for your socket outlet, please contact
Whirlpool Service for further instruction. Please do not attempt to
change plug yourself. This procedure needs to be carried out by a
qualified Whirlpool technician in compliance with the manufactures
instructions and current standard safety regulations.


Product specificaties

Merk: Whirlpool
Categorie: Wasdroger
Model: AWZ 3411

Heb je hulp nodig?

Als je hulp nodig hebt met Whirlpool AWZ 3411 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Wasdroger Whirlpool

Handleiding Wasdroger

Nieuwste handleidingen voor Wasdroger