Whirlpool AWM 302/4 Handleiding

Whirlpool Wasmachine AWM 302/4

Lees hieronder de 📖 handleiding in het Nederlandse voor Whirlpool AWM 302/4 (17 pagina's) in de categorie Wasmachine. Deze handleiding was nuttig voor 35 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/17
51
INSTALLATION INSTRUCTIONS
MOBILITY WHEELS
(for UK only)
Depending on model, your washing machine is
provided with mobility wheels.
You will find these wheels in the accessory kit supplied
with the machine, or you can order them from our
After-Sales Service.
MOUNTING INSTRUCTIONS
1. Tilt the machine forward.
2. Loosen the two rear feet.
3. Insert the wheels as close as possible to the
screw (1).
4. Tighten the screw completely (2).
5. Put the machine in an upright position.
6. Adjust the front feet making sure that the machine
is completely level with the floor.
Note: Levelling is extremely important to avoid any
risk of instability and vibrations.
MOVING THE MACHINE
1. Open the door of the machine.
2. Lift the machine by 1 or 2 cm (3).
3. Push or pull the machine according to your need.
1
2
3
50
1) ELECTRICAL CONNECTIONS
“Warning - this appliance must be earthed”
This appliance is normally supplied with a mains
lead having a plug fitted in the factory which has
been checked for correct earth continuity.
If the fitted plug is not suitable for your socket
outlet, or if the machine’s mains lead is not fitted
with a plug, you should fit a suitable new, good
quality plug by following the instructions in (2)
below.
Any unsuitable plug should be cut off and
disposed of in order to avoid a possible shock
hazard should it be inserted into a socket.
2) CONNECTION TO A REWIRABLE PLUG - to be
carried out only by a qualified electrician
The wires in the mains lead are coloured in
accordance with the following code:
BLUE - NEUTRAL (“ ”N )
BROWN - “ ”LIVE (“ ”L )
GREEN AND YELLOW - ” “ EARTH ( E )
To fit a new plug, proceed as follows:
2.1 Polarized Plugs (e.g. 3 pin, 13 amp plug
conforming to BS 1363A)
a. The GREEN AND YELLOW wire must be
connected to the terminal in the plug which is
marked with the letter “E” or by the Earth
symbol or coloured yellow or green and
yellow.
b. The BLUE wire must be connected to the
terminal which is marked with the letter “N” or
coloured black.
c. The BROWN wire must be connected to the
terminal which is marked with the letter “L” or
coloured red.
2.2 Non-polarized plugs (e.g. 2 pin with side
earth contact)
The wire which is coloured GREEN AND
YELLOW must be connected to the earth
contact. The other two wires should be
connected to the two pins, irrespective of colour.
3) FUSE REPLACEMENT
If the mains lead of this appliance is fitted with a
BS 1363A 13 amp fused plug, replace the fuse
only with an A.S.T.A. approved type conforming
to BS 1362 and proceed as follows:
1. Remove the fuse cover (A) and the fuse (B).
2. Fit the replacement 13 A fuse into the fuse
cover.
3. Refit both into the plug.
For all other types of plug, the supply socket
should be protected by a 16 A fuse or circuit
breaker at the distribution board.
INSTALLATION INSTRUCTIONS
49
DRAIN HOSE
Drain hose connection to water outlet.
1. Unhook the drain hose from the left clip;
see arrow A in Fig. 1.
Important:
Do NOT loosen the drain hose connection;
see arrow B in Fig. 1, otherwise there is the risk of
leakage (danger of scalding with hot water).
2. Fit the drain hose either to the siphon or hook it
over the edge of a sink or bath tub with the “ ”U
bend (Fig. 1). Small hand basins are not suitable.
3. Minimum drain height: 70 cm.
Maximum U-bend drain height: 125 cm.
4. If you need to add an extension, use a flexible
hose of the same type and secure the union with
screw-on hose clips. Maximum overall drain hose
length 2.5 m.
Important:
Make sure that there are no kinks in the drain hose run
and take precautions against it falling while the
appliance is running (Fig. 2).
CONNECTION TO THE MAINS
Observe local utility company regulations.
The connection must be made with a correctly
installed, earthed and insulated socket.
The system must be earthed.
The manufacturer declines all responsibility for
injury to persons or pets and damage to property
caused by disregarding the above instructions.
The data concerning voltage, consumption and
necessary fuse are supplied on the inside of the
appliance door.
The mains connection cable may only be replaced
by a qualified electrician.
The appliance conforms to European safety
regulations, EC directive 93/68/EWG and
EN 60555.
Do not use extension leads or multiplugs.
INSTALLATION INSTRUCTIONS
Min 70 cm
Max 125 cm
Fig. 1
Fig. 2


Product specificaties

Merk: Whirlpool
Categorie: Wasmachine
Model: AWM 302/4

Heb je hulp nodig?

Als je hulp nodig hebt met Whirlpool AWM 302/4 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Wasmachine Whirlpool

Handleiding Wasmachine

Nieuwste handleidingen voor Wasmachine