Whirlpool AWA 5088/1 Handleiding

Whirlpool Wasmachine AWA 5088/1

Lees hieronder de đź“– handleiding in het Nederlandse voor Whirlpool AWA 5088/1 (17 pagina's) in de categorie Wasmachine. Deze handleiding was nuttig voor 89 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/17
CONTENTS
BEFORE USING THE WASHING MACHINE
FIRST WASH CYCLE
PRECAUTIONS AND GENERAL RECOMMENDATIONS
DESCRIPTION OF THE WASHING MACHINE
PREPARATION OF THE WASHING
DETERGENTS AND ADDITIVES
PROGRAMME SELECTION
CLEANING THE FOREIGN BODY TRAP
DRAINING RESIDUAL WATER
CARE AND MAINTENANCE
TROUBLESHOOTING GUIDE
AFTER-SALES SERVICE
TRANSPORT AND HANDLING
INSTALLATION
19
BEFORE USING THE WASHING MACHINE
1.Remove the packaging and check
a. Cut and remove the shrink-wrap.
b.Remove the top protection and the protective
corners.
c. Remove the bottom protection by tilting and
turning the washing machine on one rear bottom
corner.
d. Open the lid by pressing it slightly down while
raising the handle. Remove the polystyrene cushion.
e. Remove the blue protective film from the panel
(depending on model).
•After unpacking, make sure that the washing
machine is undamaged. If in doubt, do not use
the washing machine. Contact After-Sales
Service or your local retailer.
•Keep the packaging materials (plastic bags,
polystyrene parts, etc.) out of reach of children;
they are potentially dangerous.
2.Remove the transport bracket
•The washing machine is fitted with transport
screws and a transport bracket to prevent
damage during transport. Before using the
washing machine you must remove the
transport bracket (see “Installation/Remove
the transport bracket”).
3.Install the washing machine
•Place the washing machine on a flat and stable
floor surface.
• Adjust the feet to ensure that the machine is
stable and level (see “Installation/Adjust the
feet”).
4.Water supply
•Connect the water supply inlet hose in
accordance with the regulations of your local
water company (see “Installation/Connect the
water inlet hose”).
• Water supply: Cold water only
• Tap: 3/4” threaded hose connection
• Pressure: 100-1000 kPa (1-10 bar).
For Great Britain & Ireland only:
•Water inlet: hot and cold fill.
The warm water inlet temperature must not exceed
60° C.
5.Drain hose
•Connect the drain hose to the siphon or hook it
over the edge of a sink with the “U” bend (see
“Installation/Connect the water drain hose”).
•If the washing machine is connected to a built-
in drainage system, ensure the latter is equipped
with a vent to avoid simultaneous loading and
draining of water (siphoning effect).
6.Electrical connection
•Electrical connections must be carried out by a
qualified technician in compliance with the
manufacturer’s instructions and the current
standard safety regulations.
•The technical data (voltage, power and fuses)
are given on the rating plate on the rear of the
washing machine.
•The washing machine must be connected
exclusively by means of a socket with an earth
connection in accordance with current
regulations. The washing machine must be
earthed by law. The manufacturer declines all
liability for damage to persons or property
deriving directly or indirectly from failure to
observe the directions.
•Do not use extension leads or multi sockets.
•Before any maintenance on the washing
machine disconnect it from the mains supply.
•Access to the mains plug or to disconnection
from the mains supply via a double-pole switch
must be ensured at all times following the
installation.
•Do not operate the washing machine if it has
been damaged during transport. Inform the
After-Sales Service.
•Mains cable replacement is only to be carried out
by After-Sales Service.
•The washing machine must be connected to an
effective earthing installation, in compliance with
the regulations in force. In particular, washing
machines installed in premises containing a shower
or a bath must be protected by a differential residual
current device of at least 30 mA. Earthing the
washing machine is obligatory under the law. The
manufacturer declines all liability for damage to
persons or property deriving either directly or
indirectly from failure to observe the directions
above.
•The washing machine may only be used in the
household for the prescribed uses.
Dimensions:
Width: 400 mm
Height: 900 mm
Depth: 600 mm
20
FIRST WASH CYCLE
PRECAUTIONS AND GENERAL RECOMMENDATIONS
1.Packing
•The packaging materials are 100% recyclable and
bear the recycling symbol . Adhere to local
regulations when disposing of packaging material.
2.Energy saving tips
•Achieve the best use of energy, water, detergent
and time by using the recommended maximum
load size.
•Do not exceed the detergent dosages indicated
in the manufacturer’s instructions.
•The Eco Ball - a special system in the outlet - will
prevent detergent loss from the drum to avoid
detergent loss into the environment.
•Use “Prewash” for heavily soiled laundry only!
Save detergent, time, water and energy
consumption by not selecting “Prewash” for
slight to normally soiled laundry.
•Pretreat stains with stain remover or soak dried
in stains in water before washing to reduce the
necessity of a hot wash program.
•Save energy by using a 60°C instead of a 90°C
wash programme or a 40°C instead of a 60°C
wash programme.
•Save energy and time by selecting a high spin
speed to reduce the water content in laundry
before using a tumble dryer (for machines with
adjustable spin speed).
3.Disposing of packaging and old washing
machines
•The washing machine is built from reusable
materials. The washing machine must be
disposed of in compliance with current local
waste disposal regulations.
•Before scrapping, cut of the power cable so that the
washing machine cannot be connected to the mains.
•Remove detergent from compartment if you
intend scrapping your washing machine.
4.Child safety
•Children must not be allowed to play with or in
the washing machine.
5.General recommendations
•Do not leave the washing machine connected
when not in use. Turn off the tap.
•Before cleaning or carrying out maintenance
switch off the washing machine and disconnect
it from the mains supply.
•To clean the outside of the washing machine,
use a neutral detergent and a damp cloth.
•Do not use abrasive detergents.
•Do not attempt to force the lid open.
•If necessary, the power cable may be replaced
with an identical one obtained from our After-
Sales Service. The power cable must only be
replaced by a qualified technician.
6.EC Declaration of Conformity
•This washing machine has been designed,
constructed and distributed in compliance with
the safety requirements of EC Directives:
73/23/EEC Low Voltage Directive
89/336/EEC EMC Directive
93/68/EEC CE Marking Directive
We recommend that the first wash cycle be carried out empty. This will remove any residual water used
in the factory checks.
1.Turn on the tap.
2.Close the drum flaps.
3. Pour a small amount of detergent (about 30 ml) into the detergent dispenser .
4.Select a short programme (see programme chart).
5.Press the “On/Off” button.


Product specificaties

Merk: Whirlpool
Categorie: Wasmachine
Model: AWA 5088/1

Heb je hulp nodig?

Als je hulp nodig hebt met Whirlpool AWA 5088/1 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Wasmachine Whirlpool

Handleiding Wasmachine

Nieuwste handleidingen voor Wasmachine

LG

LG WT17BPBK Handleiding

22 November 2024
Bosch

Bosch WAX32M10 Handleiding

22 November 2024
LG

LG F2WV308NEW3 Handleiding

22 November 2024
Bosch

Bosch WAU28S70 Handleiding

22 November 2024
Bosch

Bosch WGA142X2TR Handleiding

22 November 2024
LG

LG WF-79X3 Handleiding

22 November 2024
Edesa

Edesa EWF-7400 X Handleiding

22 November 2024
Smeg

Smeg WN04SEA Handleiding

21 November 2024
Smeg

Smeg WHT814ASIT Handleiding

21 November 2024