VXi BlueParrott Xpressway Handleiding

VXi Hoofdtelefoon BlueParrott Xpressway

Lees hieronder de 📖 handleiding in het Nederlandse voor VXi BlueParrott Xpressway (2 pagina's) in de categorie Hoofdtelefoon. Deze handleiding was nuttig voor 3 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/2

* A Multipoint Connection allows connection of two devices to the headset at the same time. For example, this could be two cell phones, or a phone and a VoIP dongle.

FCC NOTICE TO USERS; This part complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept

any interference received, including interference that may cause undesired operation. Users are not permitted to make changes or modify the device in any way. Changes or modications not approved

by VXi Corporation will void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to part 15 of the FCC

rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference to radio communications. However there is no guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment on and off, the user is encouraged to try to correct the interference by

one or more of the following measures: - Reorient or relocate the receiving antennae - Increase the separation between the equipment and the receive - Connect the equipment into an outlet on a circuit

different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help.

CANADA / IC NOTICE TO USER: Operation is subject to the following two conditions: 1) This device may not cause harmful interference, and (2) This device must accept any interference received, including

interference that may cause undesired operation of the device. This device complies with RSS-210 of Industry Canada. This Class B digital apparatus complies with Canadian ICES-003 (Cet appareil

numérique de la classe B est conforme à la norme NMB-003 du Canada).

VXI WARRANTY:

1. VXi warrants that your Xpressway headset system will be free from defects in material and workmanship for one year from the date of purchase. If, during the rst year from the date of

purchase, your Xpressway headset system fails to work due to a defect in material or workmanship, VXi will repair or replace the product, at its election, free of charge. Without proof of purchase,

the warranty period begins on the date of manufacture. Consumable components (for example, cushions, battery and fuse) are not included in this one-year warranty.

2. The foregoing limited warranty does not cover equipment failure attributable to accident, improper operation, misuse, abuse, or any cause other than defects in the materials or workmanship

of VXi’s products.

3. VXi’s obligations under this warranty are limited to repair or replacement (at our option) of any defective part returned to VXi at the customer’s expense. Returned products require a Return

Authorization that may be obtained by calling 1-800-742-8588. Products returned to VXi for repair under this warranty will be return shipped to the customer at VXi’s expense.

4. THIS LIMITED WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. Some

jurisdictions do not permit the exclusion of implied warranties and the foregoing exclusions may not apply to you.

5. In no event shall VXi be responsible for any other damages whatsoever, including direct, indirect, special, incidental, consequential, or other damages for breach of this or any other warranty,

express or implied.

VXi Corporation, 27 Locust Street, Dover, NH 03820 USA 1-800-742-8588 / 603-742-2888 / www.vxicorp.com / www.blueparrott.com1

PN20255 6C ©20 09 VXi Corporation Printed in China

HOW TO REPLACE THE AUTO CHARGER FUSE

If the green indicator light on the auto adapter (located next to the USB port) does not light up when plugged into the

power source, check the charger’s inline fuse. Replace with 2A 250V Fast-Blow glass fuse (3AG) if necessary. Fuses are

available at most automotive stores. To replace, unscrew the tip of the auto adapter (see photo, right) and remove the

fuse. Put new fuse in and screw the tip back on.

MODES OF OPERATION BUTTON PRESS LIGHT INDICATORS AUDIO INDICATORS

TURN ON MFB - 3 second press 2 notes rising, followed by short Blue ashes

tone when Bluetooth

connected

TURN OFF MFB - 4 second press 2 notes falling, followed by short Red ashes

tone when Bluetooth disconnected

PAIRING MFB - 6 second press 2 notes rising, followed by 4 notes Blue quickly ashing

rising

ON - NO BLUETOOTH CONNECTION NA Blue double blink NA

ON - BLUETOOTH CONNECTED NA NABlue ashing slowly

MAKE A CALL Dial from keypad or use Voice Dial NA NA

END A CALL MFB: 1 tap NA 2 notes falling

ANSWER A CALL MFB: 1 tap during ring tone NA 2 notes rising

VOICE DIAL - ACTIVATE / DEACTIVATE MFB: 1 tap NA 1 beep

REJECT A CALL MFB: 1 second press during ring

tone

NA 2 notes falling

LAST NUMBER REDIAL 1 second press of Volume Down

button

NA 1 beep

CALL WAITING - ANSWER / SWITCH BETWEEN CALLS MFB: 2 quick taps NA Beep heard when call is incoming

CALL WAITING - END CALLS MFB: 1 tap to end active call. Tap

once again to answer call on hold.

Tap once more to disconnect

second caller

NA Call on hold will ring the headset

after the active call

is disconnected

TRANSFER AUDIO WHILE ON A CALL 1 second press of Volume Down

button

NA 1 Long tone

SEND CALL ON HOLD TO VOICE MAIL MFB: 1 second press NA Long tone

VOLUME UP / VOLUME DOWN Tap Volume Up or Volume Down

button

NA 1 beep each time tapped

MUTE / UNMUTE 1 second press of Volume Up

button

NA 1 beep. Short beep every 10

seconds while muted

TURN LEDS (LIGHTS) OFF / ON Tap Volume Up and Volume Down

buttons at the same time

Lights go out NA

MULTIPOINT CONNECTION * - ENABLE Tap MFB, Volume Up and Volume

Down buttons all at the same time

NA 4 notes rising

REESTABLISH LOST BLUETOOTH CONNECTION WITH

PHONE (PHONE IS ALREADY PAIRED AND TURNED ON)

MFB: 1 tap NABlue ashing slowly

LOW BATTERY WARNING NA Long tone / 30 sec.Red ashes

CHARGING IN PROCESS NA NARed (not ashing)

CHARGING COMPLETE NA NAGreen (not ashing)

OPERATIONS GUIDE

TIPS

= Keep microphone positioned near the corner of your mouth. Correct positioning ensures that the noise-canceling

technology works properly.

= If you have not used the headset for an extended period, charge the headset for 3½ hours before using.

Unscrew

Tip

Indicator

Light

CHARGE THE HEADSET

Refer to photos above

= Connect small end of the USB cord into the

headset’s USB charging port.

= Choose Charging Method: Plug other

end of cord into the Auto or AC charger

and then plug the charger into the power

source. Or, to charge the headset on your

computer, plug the USB cord directly into

your computer’s USB port.

= An initial overnight charge is recommended.

Afterwards, charge 3½ hours for a full charge.

Charging Indicator Lights:

Red Light - Charging in process

Green Light - Fully charged

Insert matching size disk into cushion.

Attach headband, then cushion.

OVER-

THE-HEAD

WEARING

STYLE

Optional: Attach

receiver cover for

added stability

OVER-

THE-EAR

WEARING

STYLE

Attach ear hook

Attach behind-the-neck headband as shown.

Then attach cushion as described in the over-

the-head style.

BEHIND-

THE-NECK

WEARING

STYLE

PAIR HEADSET WITH PHONE

= Turn off headset.

= Place headset and phone within 3 ft. of

each other. Keep other Bluetooth devices

at least 50 feet away or turn them off.

= Press the MFB on the headset for about

6 seconds until the blue light ashes

continuously.

= Put phone into Bluetooth Discovery Mode

(“Add New Devices”).

= Enter pass code of 0000 when prompted.

= When the blue light changes from a quick

ash to a slower ash, pairing is complete.

COMPONENTS

1. Behind-the-Neck Headband

2. Over-the-Head Headband

3. Ear Cushion Mounting Disks (2 sizes)

4. Leatherette Ear Cushions (2 sizes)

5. Foam Ear Cushions (2 sizes)

6. Xpressway Headset™

7. Ear Hook

8. Receiver Cover

9. USB Cord

10. Auto Charger

11. Wall Charger

1. 2.

10.

11.

SAFETY INSTRUCTIONS

= Avoid hearing damage. Set volume at lowest comfortable

level. If you experience ringing in your ears or people sound

mufed, stop using the headset. Avoid turning up volume

to block noisy surroundings (it’s possible to adapt to volume

that is too high).

= Check with local and state laws regarding cell phone

handset usage while operating a motor vehicle.

= Do not immerse any part of this product in water.

= Plastic bags and small parts may cause choking if ingested

Keep them away from small children and pets.

= Use only the power cords included with this product.

= Avoid temperatures exceeding 140°F.

TALK TIME AND RANGE

Range: Up to 66 feet. Certain conditions

and obstructions, such as wireless

devices, placing the phone on a metal

surface (such as the hood of a car),

walls, etc. can reduce range.

Talk Time Duration: 16+ hrs on a full charge

Standby Time Duration: Up to 150 hours

on a full charge

Multifunction Button

(MFB)

Volume Up Button

Volume Down Button

USB Charging Port

If the headband is too tight, pull

ends outward to widen the band.

Xpressway™

USER GUIDE

Convertible!

3 wearing

styles

Compatible with most Bluetooth phones & Bluetooth

enabled computers (Windows® or Macintosh®)

Product specificaties

Merk:	VXi
Categorie:	Hoofdtelefoon
Model:	BlueParrott Xpressway
Kleur van het product:	Zwart
Oplader:	Ja
Bluetooth:	Ja
Bluetooth-versie:	2.1+EDR
Connectiviteitstechnologie:	Draadloos
Frequentieband:	2.4 GHz
Meegeleverde kabels:	USB
Ondersteund aantal accu's/batterijen:	1
Draagwijze:	Ear-hook, Head-band, Neck-band
Headset type:	Monauraal
Impedantie:	32 Ohm
Positie speakers koptelefoon:	Intraauraal
Frequentiebereik koptelefoon:	300 - 4000 Hz
Aansluitbereik:	20 m
Gevoeligheid koptelefoon:	113 dB
Standby tijd:	150 uur
Diameter van de luidspreker:	13 mm
Gesprekstijd:	16 uur
Frequentie microfoon:	20 - 15000 Hz
Type product:	Headset
Batterijtechnologie:	Lithium-Polymeer (LiPo)