VAX V-008 Performance Handleiding

VAX Stofzuiger V-008 Performance

Lees hieronder de 📖 handleiding in het Nederlandse voor VAX V-008 Performance (9 pagina's) in de categorie Stofzuiger. Deze handleiding was nuttig voor 9 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/9
More user manuals on ManualsBase.com
Vax Careline:
0870 6061248
Instruction Manual
Please read carefully before using
this cleaner. Always fully extend
the mains cable before use.
www.vax.co.uk
BAGLESS UPRIGHT VACUUM CLEANER
Vax Model Number: V-008
BAGLESS UPRIGHT VACUUM CLEANER
Vax Model Number: V-008SP
Vax V-008S 6th.qxd 4/6/05 11:29 AM Page 1
More user manuals on ManualsBase.com
1 Hand grip
2 Handle
3 TurboToolâ„¢
4 Crevice tool (inside extension tube)
5 Extension tube
6 Dirt container lid
7 Dirt container
8 HEPA filter
9 Brushbar height adjuster
10 Headlight
11 Furniture protect strip
12 Clear dirt path window
13 Lower hose
14 Hose tube
15 Dirt container release button
16 Self-propelled on/off switch (V-008SP only)
17 Hose caddy
18 Hose
19 Dusting brush
20 Cord wrap with quick release
21 Carrying handle
22 Power cord
23 Lower cord wrap
24 Wheels
25 Handle release pedal
26 On/off pedal
27 Hose clip
28 One (1) screw
1. Diagram
Parts Overview
2
2. Safety Information
FOR HOUSEHOLD USE ONLY.
When using the vacuum cleaner, basic safety
precautions should always be observed, including the
following:
1. Only use the vacuum cleaner indoors on dry
surfaces.
2. Turn off the vacuum cleaner controls before
connecting to or disconnecting from the mains
supply.
3. Always unplug the vacuum cleaner before
connecting or disconnecting the vacuum hose.
4. Close attention is necessary when used by or near
children. Do not allow children to use as a toy.
5. Use only as described in this manual. Use only the
manufacturer’s recommended attachments.
6. Do not use the vacuum cleaner with a damaged
cord or plug. Do not use the vacuum cleaner if it
has been dropped, damaged, left outdoors or
dropped into water. Return the vacuum cleaner to
a Vax Authorised Service Agent or suitably
qualified person for examination, repair or
adjustment.
7. Do not pull or carry by the cord. Do not use the
cord as a handle, close a door on the cord or pull
the cord around sharp edges or corners. Do not
run the vacuum cleaner over the cord. Keep the
cord away from heated surfaces.
8. Do not handle the plug or vacuum cleaner with wet
hands. Do not use outdoors or on wet surfaces.
9. Do not put any objects into openings. Do not use
with any openings blocked and do not restrict air
flow. Keep all openings free of dust, lint, hair or
anything that may reduce airflow.
10. Keep hair, loose clothing, fingers and all parts of
the body away from openings and moving parts.
11. Do not pick up hot coals, cigarette butts, matches
or any hot, smoking or burning objects.
12. Do not pick up flammable or combustible materials
(lighter fluid, petrol, kerosene, etc) or use in the
presence of explosive liquids or vapours.
13. Do not vacuum up harmful or toxic material
(chlorine bleach, ammonia, drain cleaner, etc).
Safety Information
Fig.1/1
3
14. Do not vacuum up hard or sharp objects such as
glass, nails, screws, coins, etc.
15. Do not use without the filters in place.
16. Use extra care when vacuuming on stairs.
17. Keep vacuuming area well lit.
18. Store the vacuum cleaner indoors in a cool,
dry area.
19. Turn off the switch before unplugging.
20. Use only CE-approved 13 amp extension cords.
Non-approved extension cords may overheat.
Care should be taken to arrange the cord so that
the cord cannot be pulled or tripped over.
WARNING: Always switch off and unplug the vacuum
cleaner from the electrical outlet before assembling,
opening or emptying the dirt container, or before
connecting/disconnecting the attachments.
CAUTION: The vacuum cleaner is a very powerful unit.
Before plugging the cord into the outlet make sure the
switch is in the ‘off’ position. Hold the vacuum cleaner
firmly when starting and in use.
IMPORTANT: If the inlet or hose is blocked, switch off
the vacuum cleaner and remove the blockage(s) before
re-starting the vacuum cleaner.
IMPORTANT: Cleaning filters improves vacuum
performance. Make sure all filters are replaced back
into the vacuum cleaner before using.
This vacuum cleaner is intended for household use
only and not for commercial or industrial use.
PLEASE KEEP THESE INSTRUCTIONS FOR
FURTHER USE.
Motor Thermostat
IMPORTANT: The motor is equipped with a thermal
cut-out. If for any reason, the vacuum cleaner should
over-heat, the thermostat will automatically turn the
unit off. Should this occur, unplug the vacuum cleaner
from the wall outlet and turn off the switch. Remove the
dirt container and empty. Clean the filters. Allow the
cleaner to cool for approximately one (1) hour.
To re-start, plug into a wall outlet and switch back on.
FRONT BACK
1
4
6
7
8
9
5
11
12
13
3
14
2
10
15
18
19
21
22
25
26
27
20
17
16
24
24
23
28
Vax V-008S 6th.qxd 4/6/05 11:29 AM Page 2
More user manuals on ManualsBase.com
4. Clip TurboToolâ„¢ on to the front of the TurboToolâ„¢
caddy (Fig.3/4).
5. Wrap the lower hose around the back of the hose
caddy (Fig.3/5A). Push hose tube down into the
right side of cleaner (Fig.3/5B).
6. Slide the dusting brush on to the post on the
upper tool caddy with bristles facing out (Fig.3/6A).
Slide the extension tube/crevice tool into the round
slot on the front right side of tool caddy (Fig.3/6B).
3. How to Assemble
IMPORTANT: Always remove the power plug from
the electrical outlet before assembling or before
removing accessories.
Tool required: Phillips screwdriver.
1. Guide the power cord into the opening. Slide the
upper handle into the TurboToolâ„¢ caddy (Fig.3/1).
2. Insert the handle fastener into the back of the
TurboToolâ„¢ caddy (Fig.3/2).
3. Insert one (1) screw into the front and tighten
until secure (Fig.3/3).
How to Operate
4
How to Assemble
5
Fig.3/2
a
FRONT
BACK
b
Fig.3/3
4. How to Operate
Cord Release
Turn the quick release for easy cord removal (Fig.4/1).
Clip cord into cord guide to keep out of the way
while vacuuming.
Adjustment for Different Floor Types
Turn the brushbar height adjuster according to the
surface being cleaned (Fig.4/2).
NOTE: For easiest adjustment, place cleaner in full
upright position.
AB
CAUTION: The brushbar continues to rotate
while the hose is removed or in use, and at all
times while the vacuum cleaner is on. Keep hair,
loose clothing, fingers and all parts of the body
away from the brush area while the vacuum
cleaner is on. The cleaner must be in the
upright position to lift the rotating brushbar off
the carpet when cleaning above the floor.
Vax recommend that the carpet height adjuster
is turned to its highest position when using the
tools. NOTE: Model V-008SP only is NOT suitable for
hard floor cleaning.
On/off Pedal
Plug the cord into the electrical outlet. Turn the
vacuum cleaner on by depressing the foot switch
located on the back left side of the vacuum cleaner
(Fig.4/3). The vacuum cleaner can be turned off by
pressing the on/off switch again.
Handle Release Pedal
To release the handle, push the handle release pedal
located on the lower left side of the cleaner (Fig.4/4).
Carpet Cleaning
Move the handle and adjust it to the desired position
for (A) storing the upright or (B) operating the cleaner.
De-press the handle release pedal again (C) to clean
under furniture (Fig.4/5).
Fig.3/1
Fig.3/5
Fig.3/6
Fig.3/4
Fig.4/1 Fig.4/3
Fig.4/5
Fig.4/4
Fig.4/2
ab
c
ABAB
C
Vax V-008S 6th.qxd 4/6/05 11:29 AM Page 4


Product specificaties

Merk: VAX
Categorie: Stofzuiger
Model: V-008 Performance

Heb je hulp nodig?

Als je hulp nodig hebt met VAX V-008 Performance stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Stofzuiger VAX

Handleiding Stofzuiger

Nieuwste handleidingen voor Stofzuiger