Valcom VIP-148L Handleiding

Valcom Speaker VIP-148L

Lees hieronder de 📖 handleiding in het Nederlandse voor Valcom VIP-148L (4 pagina's) in de categorie Speaker. Deze handleiding was nuttig voor 5 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/4

1 947628

ISSUE 5

VIP-130L IP Paging Horn

INTRODUCTION

The VIP-130L IP Paging Horn is a self contained

paging system which enables voice paging up to

1200 feet from an Ethernet connection. The

VIP-130L consists of a high efficiency 5 Watt Class-D

Horn and a VIP-LLE Network Extender allowing

stand alone capability when used with a SIP enabled

telephone system or can be accessed from a variety

of Valcom managed VoIP products.

SPECIFICATIONS

Access Methods

 PBX, FXO Port w/VIP-811

 POTS telephone set w/VIP-811

 PBX, FXS Port w/VIP-821

 Valcom M Cast Page Group

 SIP telephone system

Features

 RJ-45 network connection

 LED Status Indicator

 Network activity LEDs

 Power over Ethernet (PoE) 802.3af compatible

 High Efficiency Class-D 5 Watt Amplifier

Dimensions/Weight

(Horn)

 7.00” H x 10.00" W x 10.00" D

(18.75 cm H x 25.4 cm W x 26.4 cm D)

 Weight: 5.8 lbs. (2.63 kg)

Network Extender

(VIP-LLE)

 1.30” H x 6.10" W x 6.00" D

(3.51 cm H x 15.72 cm W x 13.51 cm D)

 Weight: 0.85 lbs. (0.39 kg)

Environment

Temperature: 0 to +40° C

Humidity: 0 to 85% non-precipitating

Nominal Specifications – HORN

Input Impedance: 600 Ohms

Input Level: -10dBm

Output Impedance: 600 Ohms

Output Level: -10dBm nominal

Nominal Speciﬁcations – VIP-LLE

Via 802.3af PoE Ethernet Switch:

Class 3

Packing List

Qty Item

1 VIP-LLE Network Extender

1 5 Watt High Efficiency Horn

1 VSP Document

2 Mounting Brackets

4 Rubber Pads

4 Wood Screws

1 “C” Clamp

INSTALLATION

FCC Information

This equipment has been tested and found to

comply with the limits for a Class A digital device,

pursuant to Part 15 of the FCC Rules. These

limits are designed to provide reasonable

protection against harmful interference when the

equipment is operated in a commercial

environment. This equipment generates, uses

and can radiate radio frequency energy and if not

installed and used in accordance with the

2 947628

CAUTION: To reduce the risk of electric shock,

Do not remove cover.

No user serviceable parts inside.

Refer servicing to qualified service personnel.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

This symbol indic ates that dangerous

voltage constituting a risk of electric

shock is present within this unit.

This symbol indicates that there are

important operating and maintenance

instructions in the literature accompanying

this unit.

instruction manual, may cause harmful

interference to radio communications. Operation

of this equipment in a residential area may cause

harmful interference in which case the user will

be required to correct the interference at his own

expense.

Precautionary Designations

Mounting (VIP-LLE)

The VIP-LLE Network Extender is designed for wall

or shelf mounting and must be within 300 feet of the

network switch.

Shelf: Provided with the VIP-LLE Network Extender

are four rubber pads. Peel the pads from the carrier

backing and place at the four corners of the bottom of

the unit.

Wall: Using the brackets and wood screws provided,

secure the VIP-LLE Network Extender

to the wall.

Mounting (HORN)

The horn should be mounted 15 to 20 feet above the

floor to allow for best sound distribution. The unit can

be mounted to a wall, a beam or an electrical box.

NOTE: For ease of installation, the base can be

attached to the speaker before or after the base is

mounted.

 Loosen position adjustment knob

 Insert the ball of the base into the socket of

the speaker

 Tighten the position adjustment knob

 Mount the base to a wall using the two

pre-drilled holes provided.

 A “C” clamp is provided with the horn to allow

mounting to a beam. Place the bolt through

the hole in the bottom of the base to secure

the “C” clamp to the beam. It is suggested

that the horn be mounted to the underside of

the “I” beam to provide maximum positioning

adjustments.

 The base has pre-drilled holes for a double-

gang square electrical box, but by drilling out

additional knockout holes, the base can be

mounted to a single-gang or octagon box.

The horn may be rotated or moved up and down to

obtain the desired position by loosening the position

adjustment knob at the bottom of the unit

approximately one turn. Make required adjustments

and re-tighten knob.

3 947628

Interconnections

The only method of powering the VIP-130L IP Paging

Horn is via a Power over Ethernet (PoE) switch or

power injector meeting the 802.3af specification.

Make all required signal connections before

connecting to Ethernet switch or power injector

meeting the 802.3af specification. Power is supplied

to the horn assembly via the VIP-LLE Network

Extender.

Network Connection

As shown in Figure 3, the VIP-LLE Network Extender

has one RJ-45 network connector on the front panel.

Use a standard Ethernet patch cable to connect the

NETWORK connector of the VIP-LLE Network

Extender to a 802.3af compliant PoE port (300 feet

maximum distance).

Signal Connections

As shown in Figure 3 and 4, audio output

connections are made on the rear panel of the VIP-

LLE Network Extender. Versions of the VIP-LLE

Network Extender with the color-coded, 8-pin screw

connector will connect standard CAT-5 twisted-pair

cable from the rear panel color coded connector of

the VIP-LLE Network Extender to the supplied VM-

186 RJ-45 connector (900 feet maximum distance).

Connect RJ-45 connector of horn to VM-186 RJ-45

socket. For versions of the VIP-LLE Network

Extender with the RJ-45 Audio Output connector, the

horn may be connected directly to the RJ-45 port. If

additional length is required, any standard T568A or

T568B extension may be used (900 feet maximum).

Status Indicator Lights

The VIP-LLE Network Extender has 3 status

indication lights:

STATUS: Flashes during normal operation, and solid

when unit in reset.

LINK: Indicates 100 Mbit Ethernet connection when

illuminated. No activity indicates 10 Mbit connection.

Act: Indicator flashes to indicate network activity

Operation

Provide paging from SIP connection or via a variety

of Valcom managed VoIP products. Integration to

customer telephone system can be via SIP

registration, FXO port (with VIP-811), or FXS port

(with VIP-821).

Setup

Information specific to your application will need to be

programmed into the VIP-130L using a computer.

The PC used for programming would be connected to

the same subnet as the VIP-130L. Setup will be

done using the IP Solutions Setup Tool. The IP

Solutions Setup Tool may be downloaded from the

Valcom website at www.valcom.com.

TECHNICAL ASSISTANCE

Assistance is available from the factory when

problems are encountered. Call (540) 563-2000 and

press 1 for Technical Support or visit our website at

http://www.valcom.com.

Valcom equipment is not field repairable. Valcom,

Inc. maintains service facilities in Roanoke, VA.

Should repairs be necessary, attach a tag to the unit

clearly stating your company name, address, phone

number, contact person and the nature of the

problem. Send the unit to:

Valcom, Inc.

Repair & Return Dept.

5614 Hollins Road

Roanoke VA. 24019

VALCOM LIMITED WARRANTY

Valcom, Inc. warrants its products only to the original purchaser, for its own use, to be free from defects in materials and workmanship under

conditions of normal use and service for a period of one year from the date of shipment. This Limited Warranty obligation shall be limited to the

replacement, repair or refund of any such defective device within the warranty period, provided that:

1. inspection by Valcom, Inc. indicates the validity of the claim;

2. the defect is not the result of damage, misuse or negligence after the original shipment;

3. the product has not been altered in any way or repaired by others and that factory sealed units are unopened (a service charge plus parts

and labor will be applied to units defaced or physically damaged);

4. freight charges for the return of products to Valcom are prepaid;

5. all units 'out of warranty' are subject to a service charge. The service charge will cover minor repairs (major repairs will be subject to

additional charges for parts and labor).

This Limited Warranty is in lieu of and excludes all other warranties, expressed or implied and in no event shall Valcom, Inc. be liable

for any anticipated profits, consequential damages, loss of time or other losses incurred by the buyer in connection with the purchase,

operation, maintenance, installation, removal or use of the product. The maximum liability of Valcom under this warranty is limited to

the purchase price of the specific Product covered by the warranty.

Disclaimer. Except for the Limited Warranty provided herein, the product is provided “as-is” without any warranty of any kind whatsoever

including, without limitation, any WARRANTY OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE OR NON-INFRINGEMENT.

This warranty specifically excludes damage incurred in shipment. In the event a product is received in damaged condition, the carrier should be

notified immediately. Claims for such damage should be filed with the carrier involved in accordance with the F.O.B. point.

Headquarters:

Valcom, Inc.

5614 Hollins Road Roanoke, VA 24019-5056

Phone:

(

540

)

563-2000 FAX:

(

540

)

362-9800

Product specificaties

Merk:	Valcom
Categorie:	Speaker
Model:	VIP-148L
Kleur van het product:	Wit
LED-indicatoren:	Nee
Bluetooth:	Nee
Connectiviteitstechnologie:	Bedraad
Ethernet LAN:	Ja
Type stroombron:	DC
Gemiddeld vermogen:	- W
DC voltage input:	24 V
Volumeregeling:	Digitaal
Equalizer-instellingen:	Nee
Aanbevolen gebruik:	Universeel
Audio-uitgangskanalen:	1.0 kanalen
Speaker plaatsing:	Ceiling-mountable, Wall-mountable
Aantal drivers:	1
Woofer:	Nee
Frequentiebereik:	- Hz
Gevoeligheid:	117 dB
USB:	Nee
Luidspreker soort:	1-weg
Speaker omsluiting:	Gesloten
Versterker:	Ingebouwd
Tweeter:	Nee
Wifi:	Nee
Speaker positie:	Satelliet
Afneembare beschermings-hoes:	Nee