Turbosound Prague TPA122-WB Handleiding

Turbosound Speaker Prague TPA122-WB

Lees hieronder de 📖 handleiding in het Nederlandse voor Turbosound Prague TPA122-WB (4 pagina's) in de categorie Speaker. Deze handleiding was nuttig voor 23 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/4
TPA122-WB / TPA152-WB
Steel Wall Bracket for TPA/TPZ Loudspeakers
Quickstart Guide
2TPA122-WB / TPA152-WB
LEGAL DISCLAIMER
MUSIC Group accepts no liability for
any loss which may be suffered by any
person who relies either wholly or in
part upon any description, photograph,
or statement contained herein. Technical
specifi cations, appearances and other
information are subject to change
without notice. All trademarks are the
property of their respective owners.
MIDAS, KLARK TEKNIK, TURBOSOUND,
BEHRINGER, BUGERA and DDA are
trademarks or registered trademarks of
MUSIC Group IP Ltd. © MUSIC Group IP
Ltd. 2014 All rights reserved.
LIMITED WARRANTY
For the applicable warranty terms and
conditions and additional information
regarding MUSIC Group’s Limited
Warranty, please see complete details
online at music-group.com/warranty.
4TPA122-WB / TPA152-WB
Wall Brackets
1. Remove the M10 blanking bolts from the speaker.
The bracket will be mounted to these points.
2. Install the wall plate in the venue using the appropriate
xings (not supplied).
3. Lift the speaker to the bracket and attach with the
supplied M10 bolts and friction washers.
4. Set the desired speaker angle and insert the 2
locking screws.
5. For added precaution and where required by local
standards, install an M10 threaded eyebolt in the back of the speaker, then connect a properly-rated safety
cable from the eyebolt to the mounting structure.
Suspending with Eyebolts
TPA and TPZ cabinets can be suspended using optional eyebolts coupled
to the internal rigging points provided on the top, bottom and sides and
back. The simplest method is to use the two rigging points on the top and
a single pull-back rigging point in the centre of the rear panel.
Remove the appropriate countersunk screws and replace them with
shoulder eyebolts, which must have a thread length of at least 18 mm.
Use the rear rigging point to angle the cabinet for optimum room
coverage. Cabinets may be hung upside down if required.
IMPORTANT NOTE: The mounting of a permanently installed sound system
may be dangerous unless undertaken by quali ed personnel with the
required experience and certifi cation to perform the necessary tasks.
Walls, fl oors or ceilings must be capable of safely and securely supporting the actual load. The mounting
accessory used must be safely and securely fi xed both to the loudspeaker and to the wall, fl oor or ceiling.
When mounting rigging components on walls, fl oors or ceilings, ensure that all xings and fasteners
used are of an appropriate size and load rating. Wall and ceiling claddings, and the construction and
composition of walls and ceilings, all need to be taken into account when determining whether a
particular fi xing arrangement can be safely employed for a particular load. Cavity plugs or other specialist
xings, if required, must be of an appropriate type, and must be fi tted and used in accordance with the
maker’s instructions.


Product specificaties

Merk: Turbosound
Categorie: Speaker
Model: Prague TPA122-WB

Heb je hulp nodig?

Als je hulp nodig hebt met Turbosound Prague TPA122-WB stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Speaker Turbosound

Handleiding Speaker

Nieuwste handleidingen voor Speaker