Toa H-1 EX Handleiding

Toa Speaker H-1 EX

Lees hieronder de 📖 handleiding in het Nederlandse voor Toa H-1 EX (12 pagina's) in de categorie Speaker. Deze handleiding was nuttig voor 63 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/12
OPERATING INSTRUCTIONS
H-1
SPEAKER SYSTEM
Please follow the instructions in this manual to obtain the optimum results from this unit.
We also recommend that you keep this manual handy for future reference.
TABLE OF CONTENTS
1. SAFETY PRECAUTIONS
2. GENERAL DESCRIPTION
3. FEATURES
4. HANDLING PRECAUTIONS
5. NOMENCLATURE
6. INSTALLATION
6.1. Direct Wall/Ceiling Mounting Without Using an Electrical Box
6.2. Mounting the Speaker to an Electrical Box Using The Adapter Frame
6.3. Mounting the Speaker Directly to an Electrical Box
6.4. Removing the Trim Piece
7. REPAINTING THE GRILLE AND TRIM PIECE
8. PROTECTION CIRCUITRY INFORMATION
9. EQUALIZATION
10. SPECIFICATIONS
Accessories
TOA Corporation
2
3
3
3
4
5
8
9
9
10
11
12
12
12
1. SAFETY PRECAUTIONS
• Be sure to read the instructions in this section carefully before use.
• Make sure to observe the instructions in this manual as the conventions of safety symbols and messages
regarded as very important precautions are included.
• We also recommend you keep this instruction manual handy for future reference.
Safety Symbol and Message Conventions
Safety symbols and messages described below are used in this manual to prevent bodily injury and property
damage which could result from mishandling. Before operating your product, read this manual first so you are
thoroughly aware of the potential safety hazards as well as understand the safety symbols and messages.
Indicates a potentially hazardous situation which, if mishandled,
could result in death or serious personal injury.
Indicates a potentially hazardous situation which, if mishandled,
could result in moderate or minor personal injury, and/or property
damage.
WARNING
CAUTION
WARNING
CAUTION
When the Unit is in Use
• Do not operate the speaker for an extended period
of time with the sound distorting. This is an
indication of a malfunction, which in turn can cause
heat to generate and result in a fire.
When Installing the Unit
• Install the unit only in a location that can
structurally support the weight of the unit and the
mounting bracket. Doing otherwise may result in
the speaker falling down and causing personal
injury and/or property damage.
When the Unit is in Use
• Should the following irregularity be found during
use, immediately stop operating the unit and
contact your nearest TOA dealer. Make no further
attempt to operate the unit in this condition as this
may cause fire or electric shock.
• If you detect smoke or a strange smell coming
from the unit.
• If water or any metallic object gets into the unit.
• If it is malfunctioning (no tone sounds.)
2
2. GENERAL DESCRIPTION
TOA's H-1 is a cylinder-shaped, small flush-mount 2-way speaker featuring high sound quality.
3. FEATURES
• The H-1 Speaker System features, flush-mount speaker design with a rotatable cylinder-type enclosure. The
speaker's smooth curved surface allows it to blend in with the interiors of most modern buildings.
• The speaker's small ( 8 x 5 cm) woofer features a magnetic circuit (employing a neodymium magnet) that
ensures powerful sound reproduction.
• The one-inch balanced dome tweeter features ferro-fluid to ensure superb transient response characteristics
for clear, high frequency sound output and high power-handling capabilities.
• The speaker's built-in crossover network circuitry features sharp cut-off characteristics that realize uniform
energy radiation while suppressing unwanted input signals to the woofer or tweeter.
• The H-1 Speaker System is designed with an emphasis on installation ease and safety, as well as easier
conduit wiring when an electrical box is installed.
• The cylinder-shaped speaker's mounting angle can be easily adjusted for up to ± 45 degrees rotation.
• A built-in matching transformer permits the speaker to be used for both high- and low-impedance
applications. For low-impedance applications, either the 4 or 16 terminal can be selected. Impedance
can be easily changed from outside the unit.
• Detachable screw terminals facilitate connection. Dual positive and negative terminals also facilitate bridge
connections.
• Both the speaker enclosure and Trim Piece are made of fire-resistant ABS (UL Standard 94: V-0 Grade).
• All external parts have been specially selected for ease of refinishing and repainting.
4. HANDLING PRECAUTIONS
The speaker is not magnetically shielded. Install it as far away as possible from television sets or computer's
CRTs to avoid degradation in picture quality.
3


Product specificaties

Merk: Toa
Categorie: Speaker
Model: H-1 EX

Heb je hulp nodig?

Als je hulp nodig hebt met Toa H-1 EX stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Speaker Toa

Toa

Toa PC-391T Handleiding

26 September 2024
Toa

Toa PC-391 Handleiding

23 September 2024
Toa

Toa PC-1860EN Handleiding

23 September 2024
Toa

Toa PC-2360EN Handleiding

23 September 2024
Toa

Toa F-1300W Handleiding

23 September 2024
Toa

Toa F-2000W Handleiding

23 September 2024
Toa

Toa PC-3WR Handleiding

18 September 2024
Toa

Toa TZ-205 Handleiding

18 September 2024
Toa

Toa PC-2668 Handleiding

18 September 2024
Toa

Toa PC-3WR-L Handleiding

18 September 2024

Handleiding Speaker

Nieuwste handleidingen voor Speaker