Stiebel Eltron HSBB 180 Plus Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Stiebel Eltron HSBB 180 Plus (24 pagina's) in de categorie Ketel & boiler. Deze handleiding was nuttig voor 63 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/24
OPERATION AND INSTALLATION
Integral cylinder
» HSBB 180 Plus (GB)
» HSBB 180 S Plus (GB)
2 | HSBB 180 Plus (GB)|HSBB 180 S Plus (GB) www.stiebel-eltron.com
CONTENTS | SPECIAL INFORMATION
SPECIAL INFORMATION
- The appliance may be used by children over
8years of age and persons with reduced phys-
ical, sensory or mental capabilities or a lack of
experience and expertise, provided that they are
supervised or they have been instructed on how
to use the appliance safely and have understood
the potential risks. Children must never play with
the appliance. Cleaning and user maintenance
must not be carried out by children without
supervision.
- The connection to the power supply must be in
the form of a permanent connection. Ensure the
appliance can be separated from the power sup-
ply by an isolator that disconnects all poles with
at least 3mm contact separation.
- Observe all applicable national and regional reg-
ulations and instructions.
- Observe minimum distances (see chapterInstal-
lation/ Preparations/ Installation site).
- Only a qualified contractor should carry out in-
stallation, commissioning, maintenance and re-
pair of the appliance.
DHW cylinder
- Drain the appliance as described in chapter
“Installation/ Maintenance/ Draining the DHW
cylinder”.
- Observe the maximum permissible pressure (see
chapter “Installation/ Specification/ Data table”).
- The DHW cylinder is under supply pressure. If no
diaphragm expansion vessel is installed, expan-
sion water will drip from the safety valve during
heat-up.
- Regularly activate the safety valve to prevent
it from becoming blocked, e.g. by limescale
deposits.
- The safety valve drain aperture must remain open
to atmosphere.
SPECIAL INFORMATION
OPERATION
1. General information �����������������������������������������3
1.1 Relevant documents_____________________________________________ 3
1.2 Safety instructions _______________________________________________ 3
1.3 Other symbols in this documentation _______________________ 3
1.4 Information on the appliance _________________________________ 3
1.5 Units of measurement __________________________________________ 3
2. Safety ����������������������������������������������������������4
2.1 Intended use ______________________________________________________ 4
2.2 General safety instructions ____________________________________ 4
2.3 Test symbols ______________________________________________________ 4
3. �������������������������������������4Appliance compatibility
4. Appliance description ���������������������������������������4
5. Settings �������������������������������������������������������5
6. Cleaning, care and maintenance ���������������������������5
7. Troubleshooting ����������������������������������������������5
INSTALLATION
8. Safety ����������������������������������������������������������6
8.1 General safety instructions ____________________________________ 6
8.2 Instructions, standards and regulations ____________________ 6
9. Appliance description ���������������������������������������6
9.1 Standard delivery ________________________________________________ 6
9.2 Accessories ________________________________________________________ 6
10. Preparation ���������������������������������������������������6
10.1 Installation site ___________________________________________________ 6
10.2 Transport and handling ________________________________________ 7
11. Installation ����������������������������������������������������7
11.1 Positioning the appliance ______________________________________ 7
11.2 Removing/tting the front casing ____________________________ 8
11.3 Heating water connection and safety valve ________________ 8
11.4 DHW connection and safety assembly _______________________ 9
11.5 Filling the system _______________________________________________ 10
11.6 Venting the appliance __________________________________________ 11
12. Electrical connection ��������������������������������������� 11
12.1 Electric emergency/booster heater and control voltage 12
12.2 Sensor installation ______________________________________________ 14
12.3 Remote control __________________________________________________ 14
13. Commissioning ��������������������������������������������� 14
13.1 Checks before commissioning the heat pump manager 14
13.2 Commissioning the heat pump manager __________________ 14
13.3 Appliance handover ____________________________________________ 15
14. Shutting down the system �������������������������������� 15
15. Maintenance ������������������������������������������������ 15
16. Specification ������������������������������������������������ 16
16.1 Dimensions and connections _________________________________ 16
16.2 Hydraulic diagram ______________________________________________ 17
16.3 Wiring diagram _________________________________________________ 18
16.4 Energy consumption data _____________________________________22
16.5 Data table ________________________________________________________22
GUARANTEE
ENVIRONMENT AND RECYCLING
OPERATION
General information
www.stiebel-eltron.com HSBB 180 Plus (GB)|HSBB 180 S Plus (GB)| 3
OPERATION
1. General information
The chapters “Special information” and Operation” are intended
for appliance users and qualified contractors.
The chapter “Installation” is intended for qualified contractors.
Note
Read these instructions carefully before using the appli-
ance and retain them for future reference.
Pass on these instructions to a new user if required.
1.1 Relevant documents
Operating and installation instructions for the WPM heat
pump manager
Operating and installation instructions for the connected
heat pump
Operating and installation instructions for all other sys-
tem components
1.2 Safety instructions
1.2.1 Structure of safety instructions
!
KEYWORD Type of risk
Here, possible consequences are listed that may result
from failure to observe the safety instructions.
Steps to prevent the risk are listed.
1.2.2 Symbols, type of risk
Symbol Type of risk
Injury
Electrocution
Burns
(burns, scalding)
1.2.3 Keywords
KEYWORD Meaning
DANGER Failure to observe this information will result in serious
injury or death.
WARNING Failure to observe this information may result in serious
injury or death.
CAUTION Failure to observe this information may result in non-seri-
ous or minor injury.
1.3 Other symbols in this documentation
Note
General information is identified by the adjacent symbol.
Read these texts carefully.
Symbol Meaning
Material losses
(appliance damage, consequential losses and environmen-
tal pollution)
Appliance disposal
This symbol indicates that you have to do something. The ac-
tion you need to take is described step by step.
These symbols show you the software menu level (in
this example level3).
1.4 Information on the appliance
Connections
Symbol Meaning
Inlet/ intake
Drain/ outlet
Domestic hot water
DHW circulation
Heat pump
Heating
1.5 Units of measurement
Note
All measurements are given in mm unless stated oth-
erwise.
!
!


Product specificaties

Merk: Stiebel Eltron
Categorie: Ketel & boiler
Model: HSBB 180 Plus

Heb je hulp nodig?

Als je hulp nodig hebt met Stiebel Eltron HSBB 180 Plus stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Ketel & boiler Stiebel Eltron

Handleiding Ketel & boiler

Nieuwste handleidingen voor Ketel & boiler