SpinMaster Havoc Stinger - Air Hogs Handleiding

SpinMaster Speelgoed Havoc Stinger - Air Hogs

Lees hieronder de 📖 handleiding in het Nederlandse voor SpinMaster Havoc Stinger - Air Hogs (8 pagina's) in de categorie Speelgoed. Deze handleiding was nuttig voor 36 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/8
INSTRUCTION GUIDE
®
CONTENTS LIST AND PARTS IDENTIFICATION
BECOMING FAMILIAR WITH YOUR CONTROLLER/CHARGER
Havoc Stinger®
CONTROLLER/CHARGER
Power indicator
Direction stick
(LEFT/RIGHT)
Trimmer
Charging indicator
Minimum Throttle position
Cover and
charging wire
Power switch
Throttle stick
(UP/DOWN)
Band selector
Battery cover
Controller/Charger
Spare
Tail Rotors Instruction Guide
HAVOC STINGER®Stabilizer
Connecting shaft
Main rotor blade
Flybar
Rotor
Removal Tool
CHOKING HAZARD
WARNING:
Not for Children under 3 years.
Small parts.
DANGER!
NEVER INSERT ANY SHARP OBJECTS,
PINS OR SCREWS INTO THE
HELICOPTER AS THIS MAY PUNCTURE
THE INTERNAL BATTERY!
Do not touch the running propeller!
Do not play above someone’s head!
Adult supervision is required!
CAUTION:
CAUTION:
Tail rotor to be
replaced by adult only.
NOTE: If hair or debris gets caught
in rotor and prevents rotor from
turning, remove as above and clean.
1
Landing Gear
Tail rotor
Adjustable centre
of gravity for variable
hover speeds.
Slide back for slow steady
hovering, slide forward for fast
forward flight.
Aluminum Labels
®
OFF
ON
OFF
ON
OFF
ON
Power switch
Charging socket
Problems flying?
Do not return your Air Hogs®
to the store. Email us at
customercare@spinmaster.com
or call us toll-free at
1.800.622.8339
WWW.AIRHOGS.COM
8
-
10
YRS
HOW TO INSTALL YOUR BATTERIES
HOW TO CHARGE YOUR HAVOC STINGER® HELICOPTER
HOW TO FLY YOUR HAVOC STINGER® HELICOPTER
1. SET THE BAND ON YOUR CONTROLLER:
2. TRIMMING YOUR HELICOPTER:
To do this, you must check which frequency letter your helicopter is set at.
Turn over the helicopter and you will find a letter (A,B,C) on the bottom.
Set the band selector on your controller to the same letter (A,B,C) by moving the horizontal switch found below the ON/OFF power switch.
1. The Havoc Stinger
®
will have around 5-6 minutes of flight time after a 20-30 minute charge.
2. Before you recharge the battery, wait 10-15 minutes to let the battery cool down.
Things to remember:
Gently push the throttle up to raise your helicopter .5 m (1.5 ft) to 1 m (3 ft) high off the ground.
If your helicopter turns CLOCKWISE, continue to push the LEFT side of the trim button REPEATEDLY until the turning stops
and the helicopter flies straight.
If your helicopter turns COUNTERCLOCKWISE, continue to push the RIGHT side of the trim button REPEATEDLY until the turning
stops and the helicopter flies straight.
Pull out the cover and take out
the charging wire.
Turn the helicopter OFF
using the OFF/ON switch on
the underside.
Insert the charge plug into
the socket on the side of the
helicopter.
When ON/OFF switch is set to ON,
the green LED will
light up when
charging. Once
completed it will
turn OFF. Pull
the plug out
from the
side of the
helicopter.
STEP ONE STEP TWO STEP THREE STEP FOUR
Keep turning clockwise
or
Spiral clockwise
Keep turning counterclockwise
or
STEP
ONE
STEP
TWO
STEP
THREE
Spiral counterclockwise
2
BATTERY INSTALLATION – CONTROLLER/CHARGER
1. Open the battery door with a screwdriver (pic.1). 2. If used batteries are present, remove these batteries from the unit by pulling up on one end of each
battery. 3. Install new batteries as shown in the polarity diagram (+/-) inside the battery compartment (pic.2). 4. Replace battery door securely (pic.3).
5. Check your local laws and regulations for correct recycling and/or battery disposal.
pic.1 pic.3pic.2
3. FLYING INDOORS
NOTE: Your Havoc
Stinger
®
loses its trim
EVERY time you turn it
off. So remember these
helpful tips to stabilize
it every time!
Location – Fly in a wide-open room [ideally over 3 m (10 ft) (W) x 5 m (16.5 ft) (L) x 2.5 m (8 ft) (H)], away from breakable items. Avoid flying near vents and/or
fans, as these may overpower the Havoc Stinger
®
and make it difficult to control. NOTE: Always get permission to fly your Havoc Stinger
®
indoors.
CAUTION: Never fly near your face. Keep rotor away from your fingers, hair, eyes and other body parts. Always lift off from a flat surface.
Never hold the flying heli in your hand when lifting off. DO NOT launch heli near people or animals. Stay away from obstacles and electrical hazards.
OFF
ON
OFF
ON
OFF
ON
3
4. FLIGHT CONTROL (After Trimming)
Hover up and down:
When the helicopter flies steadily, you can slowly push the throttle stick up
to make the helicopter fly higher, or release the stick a bit to make the
helicopter fly lower. Only small amounts of stick position change are required
for smooth flying (Pic.4 & Pic.5).
Turn counterclockwise and clockwise:
Hold the helicopter at a height. Push the rudder stick toward left to turn
counterclockwise (pic.6), and push the rudder stick toward right to turn
clockwise (pic.7).
pic.4
Hover up
pic.6 pic.7
pic.5
Hover down
Accelerates & Decelerates:
If you turn the helicopter slowly counterclockwise, the helicopter will
decelerate. And when you turn it clockwise, it will accelerate.
Fly forward and stop:
The helicopter will slowly fly forward when a gentle clockwise turn is
made. To make it stop, it is sufficient to give a short counterclockwise
turn command. By alternating this flight technique, the helicopter can
be directed anywhere and come back to it’s starting position.
HOW TO ADJUST YOUR HELICOPTER’S FLIGHT PERFORMANCE
NOTE: Hovering is half the
battle. If you can maintain your
helicopter in a stable position
in the air you are on your way
to becoming a PRO.
- Put the helicopter on a smooth surface. Uneven floor surface will affect its lifting off.
- Slowly increase the throttle.
- DO NOT look at the controller/charger but focus on the helicopter.
- As soon as the helicopter leaves the ground, reduce throttle slightly. (in the worst case, the helicopter will
drop back to the floor, but that is better than crashing against the ceiling)
- VERY gently add throttle if the helicopter goes down.
- VERY gently reduce throttle if helicopter goes up.
- For turning, give short, small inputs to the direction stick. (Most beginners will easily over control the helicopter)
HOW TO FIX YOUR TWIN ROTORS
If the linkage between your twin rotors comes undone and is dangling below the bottom rotor,
it is very EASY to fix! (A)
Carefully re-attach the linkage back onto the top connector and gently push it into place. (B)
While your there, you might want to check around the area for any fibers or debris that might
affect your flight performance. Carefully remove it with tweezers and you are ready to start
flying again!
A
WRONG
B
RIGHT
FORWARD WEIGHTING
Stick the Center of
Gravity Adjuster labels
here to obtain different
performance.
Optional Center of Gravity
Adjuster labels
If you would like to adjust the directional control
of your Havoc Stinger
®
, you have the option of
putting on the optional Center of Gravity
Adjuster labels. Stick the labels on the bottom of
the helicopter’s nose as shown. This will forward
weight the helicopter and allow for a
different flight performance.
You can also adjust the speed by
moving the rear fin forward or backward.
Moving it forward increases the
forward flying speed. Moving it
backward decreases the forward flying speed.
TROUBLESHOOTING
Main rotor won’t move.
Tail rotor is broken or not moving.
Suddenly stops and drops while flying.
The helicopter is not reacting to the
controller.
PROBLEM
ON/OFF switch is set to OFF.
Weak battery.
Something may be caught in the rotor.
Rotor may have chipped during flight.
Try steering left/right to activate tail rotor.
Weak power.
Helicopter may be out of range from controller.
A,B,C channel selection on controller is not
correct.
Helicopter may not be turned ON.
CAUSE
Set switch to ON.
Re-charge the helicopter using the charging port OR
check batteries in the controller.
Remove hair or dirt caught in the rotor.
Replace tail rotor with the spare set in the package.
Re-charge helicopter or check battery power in controller.
Move closer to the helicopter with the controller.
Double check the letter on the bottom of the helicopter
and adjust the channel selector on the controller.
Turn helicopter ON.
SOLUTION
Rear Fin


Product specificaties

Merk: SpinMaster
Categorie: Speelgoed
Model: Havoc Stinger - Air Hogs

Heb je hulp nodig?

Als je hulp nodig hebt met SpinMaster Havoc Stinger - Air Hogs stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Speelgoed SpinMaster

Handleiding Speelgoed

Nieuwste handleidingen voor Speelgoed