Sharp SKMD30E3DS Handleiding

Sharp Magnetron SKMD30E3DS

Lees hieronder de 📖 handleiding in het Nederlandse voor Sharp SKMD30E3DS (12 pagina's) in de categorie Magnetron. Deze handleiding was nuttig voor 15 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/12
E 1
30" EXTENSION KIT: SKMD30E9ES INSTALLATION INSTRUCTIONS
IMPORTANT NOTES TO THE INSTALLER
Read all of the Installation Manual that is included with the Microwave Drawer before installing the extension kit.
Observe all governing codes, ordinances, and safety instructions.
Be sure to leave these instructions with the consumer.
Parts included:
Left Side Trim (qty. 1) Right Side Trim (qty. 1) Mounting Brackets (qty. 2)
Bracket Screws (qty. 8)
Trim Screws (qty. 4)
Install the extension kit after properly installing the microwave drawer in the cabinet. See steps below.
Note that the side trims are marked "L" and "R" on the back side.
T I N S KB 28 9M R R 0
MICROWAVE DRAWER STANDARD MOUNT, MEASUREMENTS AND INSTALLATION INSTRUCTIONS
D
G
A
B
C
H
I
F
E
JA. 215/8" (549.28 mm)
B. 411 /16" (119.06 mm)
C. 13/4" (44.45 mm)
D. 217/8" (555.63 mm)
E. 235/8" (600.07 mm)
F. 16" (406.4 mm)
G. 1419/ " (370.68 mm)32
H. 117/ " (38.89 mm) door thickness32
I. 15" (381 mm) auto drawer opening
J. 4" (101.60 mm)
Figure 1
E 2
1. Prepare cabinet opening as shown in Figure 2.
2. Place the drawer adjacent to the wall or cabinet opening. Plug the
power supply cord into the electrical outlet.
3. Carefully guide the drawer into the prepared opening. Avoid
contact with the sides of the cutout opening and pinching the cord
between the oven and the wall.
4. Slidethedrawerallthewaybackuntilthesiderailsareushwith
the face of the cabinet.
5. Open the drawer. Using the 4 holes on the drawer as a template,
pre-drill the cabinet using a
1/16" (1.6 mm) bit. Secure the drawer
with the 4 screws supplied. See Figure 3.
Side
Rail
Figure 3
6. Close drawer to complete oven installation. See Figure 4.
Figure 4
B
C
D
E
F
GH
I
I
O
J
K
L
Q
M
N
P
A
O
Figure 2
A. 6" (152.40 mm)
B. Suggested electrical outlet location*
C. Anti-Tip block
D. 5" (127 mm)
E. 31
/2" (88.90 mm)
F. 4" (101.60 mm)
G. 221/8" (561.98 mm) opening
H. 1413
/16" (376.24 mm) to bottom of Anti-Tip block
I. Allow 7/8" (22.22 mm) overlap
J. 231/2" (596.90 mm) minimum depth
K. Allow 7/16" (11.11 mm) overlap
L. 36" (914.40 mm) countertop height
M. Allow 7/16" (11.11 mm) minimum space
N. Floor must support 100 lb (45.4 kg)
O. Allow 41/8" (104.4 mm) minimum space
P. 159/16" (395.3 mm) opening
Q. 30" (762.0 mm) minimum width
Figures 1 and 2 contain many Microwave Drawer measurements for
reference when planning the drawer’s location.
This Microwave Drawer can be installed below any electric or gas
wall oven.
* Can also be installed using an electrical outlet in an adjacent
cabinet within the area where the provided electrical cord can
reach. Power cord access hole in cabinet should be a minimum
11/ " diameter hole and deburred of all sharp edges.2
IMPO RTANT Always allow sufcient power cord length to the
electrical outlet to prevent tension.
Always check electrical codes for requirements.
E 3
7. Remove the 2 trim screws from each mounting bracket to begin
installation.
Note: The mounting brackets come assembled to the side
trims.
8. Open the drawer to properly align brackets to microwave side
rails. See Figure 5.
Bracket
Side rails
Align sides and bottom of the 30"
mounting brackets to the sides and bottom
of the microwave drawer side rails
Figure 5
9. Using the 4 holes on each bracket as a template, pre-drill the
cabinet using a 1/16" (1.6 mm) bit. Secure the mounting brackets
to cabinet with the 8 bracket screws provided. See Figure 6.
Figure 6
10. Place side trims on top of the mounting brackets, aligning the
screw holes.
Note: Each side trim is marked "L" and "R" on the back
side to indicate Left and Right.
11. Mount the Left and Right 30" trim extensions using the 4 trim
screws provided. See Figure 7.
Figure 7


Product specificaties

Merk: Sharp
Categorie: Magnetron
Model: SKMD30E3DS

Heb je hulp nodig?

Als je hulp nodig hebt met Sharp SKMD30E3DS stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Magnetron Sharp

Handleiding Magnetron

Nieuwste handleidingen voor Magnetron