Shark SV800 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Shark SV800 (13 pagina's) in de categorie Stofzuiger. Deze handleiding was nuttig voor 14 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/13
EURO-PRO Operating LLC
Boston, MA, 02465
Tel.: 1 (800) 798-7398
www.sharkvac.com
COPYRIGHT© EURO-PRO OPERATING LLC 2009
OWNER’S MANUAL
MANUAL DEL USUARIO
MANUEL D’UTILISATION
MODELS | MODELOS | MODÈLES
SV800 – SV800C
10.8 Volts / 10,8 Voltios / 10,8 Volts
SAVE THESE INSTRUCTIONS
For Household Use Only
1Rev. 03/09B
IMPORTANT SAFEGUARDS
READ ALL INSTRUCTIONS BEFORE USING YOUR VACUUM.
When using an electrical appliance, basic safety precautions should always be
observed, including the following:
WARNING:To reduce the risk of fire, electrical shock, or injury:
1. Do not charge this unit outdoors.
2. Do not use outdoors or on wet surfaces.
3. Do not allow to be used as a toy.
Close attention is necessary when used
by or near children.
4. Use only as described in this manual.
5 Use only manufacturer’s recommended
attachments.
6. Do not use charger if power cord has
been damaged.Do not use cordless
hand vacuum or charger if it has been
dropped, damaged, left outdoors, or
dropped in water. Return it to EURO-
PRO Operating LLC for examination,
repair or adjustment.
7. Do not abuse the charger cord. Never
carry the charger or base by the cord or
yank to disconnect from an outlet;
instead grasp the plug and pull to
disconnect.
8. Keep charger cord away from heated
surfaces.
9. This product includes rechargeable
nickel cadmium batteries. Batteries
must be recycled or disposed of
properly. Do not incinerate batteries
or expose to high temperatures, as
they may explode.
10. Do not handle plug or appliance with
wet hands.
11. Do not put any object into openings.
Do not use with any opening blocked;
keep free of dust, lint, hair and anything
that may reduce air flow.
12. Keep hair, loose clothing, fingers, and all
parts of body away from openings and
moving parts.
13. Do not pick up anything that is burning
or smoking, such as cigarettes,
matches, or hot ashes.
14. Do not attempt to change accessories
while unit is running.
15. Use extra care when cleaning on stairs.
16. Do not use to pick up flammable or
combustible liquids such as gasoline or
use in areas where they may be present.
17. Look on your hand vacuum and follow
all label and marking instructions.
18. Do not use charger with an extension
cord. Plug charger directly into an
electrical outlet. Use charger only in a
standard (120V., 60Hz) electrical outlet.
19. Do not use the hand vacuum cleaner
without dust cup filter in place.
20. Store the cordless vacuum indoors. Put
the cordless vacuum away after use to
prevent accidents.
21. Leaks from battery cells can occur under
extreme conditions. If the liquid, which
is 20-35% solution of potassium hydroxide,
gets on the skin – wash immediately with
soap and water or neutralize with a mild
acid such as lemon juice or vinegar. If the
liquid gets into the eyes, flush them
immediately with clean water for a
minimum of 10 minutes and seek medical
attention.
22. Use only on dry, indoor surfaces.
23. Do not use for any purpose other than
described in this user’s guide.
24. Do not attempt to use the charger with any
other product nor attempt to charge this
product with another charger. Use only
the charger model YL-35-120200D
supplied with this appliance.
25. The battery must be removed from the
appliance before it is discarded.
26. The battery is to be recycled or disposed
of safely.
27. The appliance must be disconnected from
the supply when removing the battery.
28. Turn off all controls before unplugging.
29. Remove the battery from the vacuum
before servicing the appliance.
30. Always turn the vacuum off before
connecting or disconnecting the motorized
floor brush.
GETTING TO KNOW YOUR CORDLESS STICK VAC
2
*Illustrations may differ from actual product
1. Ergonomic Handle
2. Telescopic Tube
3. On/Off Switch
4. Filter
5. Dust Cup
6. Dust Cup Release
7. Motorized Floor Brush
8. Telescopic Tube
Locking Latch
9. Telescopic Tube Release
10. Battery Release
11. Rechargeable Battery
12. Crevice Tool
13. Floor Brush / Crevice Tool
Release
14. Battery Charger Base
15. Charging Adapter
(Model YL-35-120200D)
16. Charging Light
NOTE: Your cordless stick vacuum is shipped with the battery
uncharged. Charging of the unit for 24 hours prior to first
use is required.
OPERATING INSTRUCTIONS
4. Once the telescopic tube is inserted,
you can adjust the height of the handle
by moving the locking latch past 90
degrees to the open position. Holding
the handle, extend the tube to the
height that is right for you and then
close the latch to the locked position.
(Fig. 3)
Fig. 3Fig. 2
3
Charging the Battery
NOTE: The battery is packaged
separately from the charging base but it
is not charged. Before using the
vacuum, charge the battery for 24 hours.
NOTE: The charging base can be
mounted on a table top or a wall near an
electrical outlet.
1. When mounting on a wall, make sure
that the intended wall area for the
charging base to be drilled is free
from any hidden electrical wires,
water pipes and gas lines.
2. Select an appropriate place close to a
wall power outlet (120V., 60 Hz).
3. Do not place near direct sunlight,
near a heat source or outdoors.
4. Select an appropriate drill type for the
material to be drilled.
5. Carefully measure and mark the
location of all bracket holes and then
drill holes and screw the charging
base onto the wall. (Screws not
included.)
6. The charge adapter plug is keyed and
will fit into the charging base only one
way. Align the channel on the
adaptor plug with the tab on the
bottom of the charging base. (Fig. 1)
7. Plug the charging adapter into the
closest electrical wall outlet.
8. Place the charging base onto the wall.
Be careful not to pinch the charging
adaptor wire between the wall and the
charging base.
9. Insert the battery into the charging
base to charge. The charging light on
the charging base will light up.
NOTE: The battery must be charged for
24 hours prior to first use. Ensure that the
On/Off switch is in the “Off” position
before inserting the battery.
5. Hold the battery and insert the bottom
part first into the opening found at the
back of the unit. Then rotate in place
making sure that it clicks into place.
(Fig. 4)
Fig. 4
6. Turn the unit “On” to begin
vacuuming.
7. Place your foot lightly on the top of
the motorized brush and rotate the
handle back toward you to release the
unit from the locked upright position.
Fig. 1
Charger base
Charging
adapter
Battery
Charging light
Assembling the Stick Vac
1. Remove all the parts of the stick vac
from the box.
2. Hold the motorized brush and push it
in the base of the stick vac completely.
(Fig. 2)
3. Hold the telescopic tube and push it in
to the top of the handle of the stick
vac. (Fig. 3)
OPERATING INSTRUCTIONS
On/Off Switch
The On/Off switch has three different
positions. (Fig. 5)
1. Push on the "I" side to turn the
vacuum to “LOW” speed.
2. Push on the “II" side to turn the
vacuum to “HIGH” speed.
3. Push on the “O” (middle) to turn the
vacuum to the “Off” position.
Fig. 5
= ON (Low speed)
= OFF
= ON (High speed)
Converting Stick Vac to Hand Vac
1. Press the telescopic release button to
remove the telescopic tube. (Fig. 6)
2. Press the floor brush release button
and remove the motorized floor
brush. (Fig. 6)
Telescopic
tube release
Release
button
Lift
Pull Fig. 6
3. Insert the crevice tool into the bottom
of the vacuum making sure that it
snaps into place. (Fig. 7) To remove
the crevice tool, press the motorized
brush/crevice tool release button.
Fig. 7 4
Emptying the Dust Cup
IMPORTANT: Always turn the vacuum
off before removing the dust cup.
1. To remove the dust cup, press the
dust cup release that is on the
bottom of the dust cup. (Fig. 8)
Fig. 8
Dust cup
release
2. Hold the dust cup
cover and twist it
to the left to remove
it from the dust
cup. (Fig. 9)
3. Hold it over a
garbage can and
empty the dust.
(Fig. 10)
IMPORTANT:Empty
the dust cup after every
use. Never use the
vacuum without the
dust cup and filter
in place.
4. To reattach the dust
cup cover, align the
indicators that are
the cover and the
dust cup and turn to
the right to lock in
place. Make sure
that the “▌”
symbol on the top
cover is aligned with
the “â–Č”symbol
on the dust cup
to lock into
place. (Fig. 11)
Fig. 9
Fig. 10
Fig. 11


Product specificaties

Merk: Shark
Categorie: Stofzuiger
Model: SV800

Heb je hulp nodig?

Als je hulp nodig hebt met Shark SV800 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Stofzuiger Shark

Handleiding Stofzuiger

Nieuwste handleidingen voor Stofzuiger