Pioneer XV-EV31 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Pioneer XV-EV31 (100 pagina's) in de categorie Home cinema set. Deze handleiding was nuttig voor 50 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/100
Stereo DVD Cassette Deck Receiver
XV-EV61
XV-EV31
Speaker System
S-EV61V
S-EV31V
Operating Instructions
CONGRATULATIONS ON YOUR PURCHASE OF THIS FINE PIONEER PRODUCT.
Pioneer is on the leading edge of DVD research for consumer products and this unit incorporates the
latest technological developments.
We are sure you will be fully satisfied with the DVD player.
Thank you for your support.
Recording equipment and copyright: Recording
equipment should be used only for lawful copying
and you are advised to check carefully what is lawful
copying in the country in which you are making a
copy. Copying of copyright material such as films or
music is unlawful unless permitted by a legal
exception or consented to by the rightowners.
H067_En
On the bonnet of the unit:
IMPORTANT
The lightning flash with arrowhead
symbol, within an equilateral
triangle, is intended to alert the user
to the presence of uninsulated
“dangerous voltage” within the
product's enclosure that may be of
sufficient magnitude to constitute a
risk of electric shock to persons.
CAUTION:
TO PREVENT THE RISK OF
ELECTRIC SHOCK, DO NOT
REMOVE COVER (OR BACK). NO
USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
The exclamation point within an
equilateral triangle is intended to
alert the user to the presence of
important operating and main-
tenance (servicing) instructions in
the literature accompanying the
appliance.
H002_En
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
WARNING: THE APPARATUS IS NOT
WATERPROOFS, TO PREVENT FIRE OR SHOCK
HAZARD, DO NOT EXPOSE THIS APPARUTUS TO
RAIN OR MOISTURE AND DO NOT PUT ANY
WATER SOURCE NEAR THIS APPARATUS, SUCH
AS VASE, FLOWER POT, COSMETICS CONTAINER
AND MEDICINE BOTTLE ETC.
H001A_En
WARNING: BEFORE PLUGGING IN THE UNIT
FOR THE FIRST TIME, READ THE FOLLOWING
SECTION CAREFULLY. THE VOLTAGE OF THE
AVAILABLE POWER SUPPLY DIFFERS
ACCORDING TO COUNTRY OR REGION. BE SURE
THAT THE POWER SUPPLY VOLTAGE OF THE
AREA WHERE THIS UNIT WILL BE USED MEETS
THE REQUIRED VOLTAGE (E.G., 230V OR 120V)
WRITTEN ON THE REAR PANEL.
H041A_En
WARNING: NO NAKED FLAME SOURCES,
SUCH AS LIGHTED CANDLE, SHOULD BE
PLACED ON THE APPARATUS. IF NAKED FLAME
SOURCES ACCIDENTALLY FALL DOWN, FIRE
SPREAD OVER THE APPARATUS THEN MAY
CAUSE FIRE.
H044_En
CAUTION
This product contains a laser diode of higher class
than 1. To ensure continued safety, do not remove
any covers or attempt to gain access to the inside
of the product.
Refer all servicing to qualified personnel.
The following caution label appears on your unit.
Location: rear of the unit
H018A_En
Operating Environment H045_En
Operating environment temperature and
humidity:
+5ºC – +35ºC (+41ºF – +95ºF); less than 85%RH
(cooling vents not blocked)
Do not install in the following locations
÷Location exposed to direct sunlight or strong
÷artificial light
÷Location exposed to high humidity, or poorly
ventilated location
VENTILATION:
When installing this unit, make sure to leave
space around the unit for ventilation to improve
heat radiation (at least 30 cm at top, 15 cm at
rear, and 15 cm at each side).
WARNING
:
Slot and openings in the cabinet are provided
for ventilation and to ensure reliable operation
of the product and to protect it from
overheating, to prevent fire hazard, the openings
should never be blocked and covered with
items, such as newspapers, table-cloths,
curtains, etc. Also do not put the apparatus on
the thick carpet, bed, sofa, or fabric having a
thick pile.
H040 En
Energy-saving design
This system is designed to use 0.5W of
electricity when power is switched to standby.
VOLTAGE SELECTOR SWITCH
The line voltage selector switch is located on the
rear panel. Check that it is set properly before
plugging the power cord into the outlet. If the
voltage is not properly set, or if you move to an area
where the voltage requirements differ, adjust the
selector switch as follows:
1. Make sure the power cord is disconnected.
2. Insert a small-sized screwdriver into the
groove on the voltage selector, and adjust the
VOLTAGE SELECTOR
.
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is encouraged
to try to correct the interference by one or more of
the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment
and receiver.
– Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV
technician for help. H010_En
Information to User
Alteration or modifications carried out without
appropriate authorization may invalidate the
user's right to operate the equipment. H011_En
CAUTION:
This product satisfies FCC regulations when
shielded cables and connectors are used to
connect the unit to other equipment. To prevent
electromagnetic interference with electric
appliances such as radios and televisions, use
shielded cables and connectors for connections.
H012_En
CAUTION:
Use of controls or adjustments or
performance of procedures other than those
specified herein may result in hazardous
radiation exposure.
The use of optical instruments with this
product will increase eye hazard.
H013_En
CAUTION: THE STANDBY/ON BUTTON IS
SECONDARY CONNECTED AND THEREFORE
DOES NOT SEPARATE THE UNIT FROM MAINS
POWER IN STANDBY POSITION. therefore install
the unit suitable places easy to disconnect the
MAINS plug in case of the accident. The MAINS
plug of unit should be unplugged from the wall
socket when left unused for a long period of
time.
H017B_En
CAUTION 220-230 V
Power source voltage is factory adjusted at
220-230 volts. If your area is different, change
the voltage selector’s setting. H039En


Product specificaties

Merk: Pioneer
Categorie: Home cinema set
Model: XV-EV31

Heb je hulp nodig?

Als je hulp nodig hebt met Pioneer XV-EV31 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Home cinema set Pioneer

Handleiding Home cinema set

Nieuwste handleidingen voor Home cinema set

Mitsai

Mitsai DV3630 Handleiding

17 November 2024
Denon

Denon AVR-A10H Handleiding

12 November 2024
LG

LG MAI0702 Handleiding

7 Oktober 2024
LG

LG LH-TK3605Q Handleiding

7 Oktober 2024
LG

LG XH-TK5022Q Handleiding

27 Augustus 2024
LG

LG MAI0522 Handleiding

27 Augustus 2024
LG

LG MAI0552 Handleiding

27 Augustus 2024
LG

LG DKS-6105KZ Handleiding

27 Augustus 2024
LG

LG LH-T2665 Handleiding

27 Augustus 2024