Pioneer S-SL100CR Handleiding
Pioneer
Home cinema set
S-SL100CR
Lees hieronder de 📖 handleiding in het Nederlandse voor Pioneer S-SL100CR (80 pagina's) in de categorie Home cinema set. Deze handleiding was nuttig voor 52 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/80
2
En
Thank you for buying this Pioneer product.
Please read through these operating instructions so you will know how to operate your model properly. After you have finished reading the
instructions, put them away in a safe place for future reference.
Before you start
S-SL100-LR/S-SL100CR
• This speaker system has an impedance of 8 Ω, and should be
connected only to an amplifier designed with a load
impedance of 8 Ω (the amplifier’s speaker output connector
should clearly be labeled “8 Ω”).
In order to prevent damage to the speaker system resulting
from input overload, please observe the following precautions:
•Do not supply power to the speaker system in excess of the
maximum permissible input.
•When using a graphic equalizer to emphasize loud sounds in
the high-frequency range, do not use excessive amplifier
volume.
•Do not try to force a low-powered amplifier to produce loud
volumes of sound (the amplifier’s harmonic distortion will be
increased, and you may damage the speaker).
Caution: installation
• Do not place the speaker on an unstable surface, as doing so
may cause the speaker to fall and cause damage or bodily
injury.
• Switch off and unplug your AV equipment and consult the
instructions when connecting up components. Make sure you
use the correct connecting cables.
• Install the center speaker below the TV. When installing the
center speaker on top of the TV, be sure to secure it with tape
or some other suitable means. Otherwise, the speaker may fall
from the TV due to external shocks such as earthquakes,
endangering those nearby or damaging the speaker.
Caution: in use
• Do not use the speaker to output distorted sound for long
periods of time. This can result in damages to the speaker and
poses a potential fire hazard.
• Do not place heavy or large objects on top of the speaker.
Doing so could provoke the speaker to fall, causing damages
or bodily injury.
• The speaker system grill cannot be removed. Do not try to
forcibly remove it since doing so may damage the grille.
• This product incorporates autoregression technology to
protect the speakers. If the speakers stop emitting noise when
receiving too large a signal, turn the volume down on the amp
and wait a few seconds. The protection feature disables itself
automatically.
S-SLW500
• This product is a passive subwoofer, and must be combined
with the VSX-S300 or other audio device provided with a built-
in subwoofer amplifier.
• This speaker system has an impedance of 4 Ω, and should be
connected only to an amplifier designed with a load
impedance of 4 Ω (the amplifier’s speaker output connector
should clearly be labeled “4 Ω”).
In order to prevent damage to the speaker system resulting
from input overload, please observe the following precautions:
•Do not supply power to the speaker system in excess of the
maximum permissible input.
•When using a graphic equalizer to emphasize loud sounds in
the high-frequency range, do not use excessive amplifier
volume.
•Do not try to force a low-powered amplifier to produce loud
volumes of sound (the amplifier’s harmonic distortion will be
increased, and you may damage the speaker).
Caution: installation
• Do not place the speaker on an unstable surface, as doing so
may cause the speaker to fall and cause damage or bodily
injury.
• Switch off and unplug your AV equipment and consult the
instructions when connecting up components. Make sure you
use the correct connecting cables.
• Do not attach these speakers to the wall or ceiling, as they may
cause injury in the event of a fall.
Caution: in use
• Do not use the speaker to output distorted sound for long
periods of time. This can result in damages to the speaker and
poses a potential fire hazard.
• Do not place heavy or large objects on top of the speaker.
Doing so could provoke the speaker to fall, causing damages
or bodily injury.
• Do not sit or stand on the speaker, or let children play on the
speaker. Doing so could provoke the speaker to fall, causing
damages or bodily injury.
• The speaker system grill cannot be removed. Do not try to
forcibly remove it since doing so may damage the grille.
Cleaning the speaker cabinet
With normal use, wiping with a dry cloth should be sufficient to
keep the cabinet clean. If necessary, clean with a cloth dipped in
a neutral cleanser diluted five or six times with water, and wrung
out well. Do not use furniture wax or cleansers.
Never use thinners, benzine, insecticide sprays or other chemicals
on or near this unit since these will corrode the surfaces.
Pioneer is not responsible for any accidents or damage that
result from improper installation, misuse or modification of
the product, or natural disasters.
S-SL100-LR_S-SL100CR_En.fm 2 ページ 2011年4月12日 火曜日 午前11時31分
3
En
English
What’s in the box
S-SL100-LR
• Speaker cord (4 m) x 2
• Non-skid pads x 8
• Warranty card x 1 (European model only)
• Operating instructions (this document)
S-SL100CR
• Speaker cord (4 m) x 1
• Speaker cord (10 m) x 2
• Non-skid pads x 12
• Warranty card x 1 (European model only)
• Operating instructions (this document)
S-SLW500
• Speaker cord (3 m) x 1
• Non-skid pads x 4
•Seal x 4
• Warranty card x 1 (European model only)
Installation
S-SL100-LR/S-SL100CR
Install non-skid pads
Use the accessory non-skid pads as necessary, depending on your
installation location.
Lay the unit on its side on soft cloth or other material that will not
scar the unit.
S-SLW500
Installing the subwoofer
The subwoofer can be mounted in either vertical or horizontal
orientation. The factory default is horizontal orientation.
For vertical orientation installation
1 The feet are attached with Phillips screws; use a Phillips
screwdriver to remove them.
2 Apply the accessory seals to the place the feet were
located to hide the screw holes.
3 Apply the non-skid pads to the four corners of the surface
where the subwoofer is to be mounted. Note that the non-
skid pads may not be fully effective on all surfaces, so do not
install in slippery locations.
・Do not attempt to perform these procedures while tilting the
unit at an angle. Lay the unit on its side on soft cloth or other
material that will not scar the unit.
Mounting location
Non-skid pads
Non-skid pads
Step 1
Step 2
Step 3
Seals
Feet
Non-skid pads
50˚ to 60˚
S-SL100-LR_S-SL100CR_En.fm 3 ページ 2011年4月12日 火曜日 午前11時31分
Product specificaties
Merk: | Pioneer |
Categorie: | Home cinema set |
Model: | S-SL100CR |
Heb je hulp nodig?
Als je hulp nodig hebt met Pioneer S-SL100CR stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Home cinema set Pioneer
19 Mei 2023
7 Mei 2023
7 Mei 2023
2 Mei 2023
30 April 2023
20 April 2023
16 April 2023
13 April 2023
29 Maart 2023
26 Maart 2023
Handleiding Home cinema set
- Home cinema set Philips
- Home cinema set Sony
- Home cinema set Samsung
- Home cinema set Panasonic
- Home cinema set LG
- Home cinema set AEG
- Home cinema set Daewoo
- Home cinema set Grundig
- Home cinema set JVC
- Home cinema set JBL
- Home cinema set Kenwood
- Home cinema set Medion
- Home cinema set Onkyo
- Home cinema set Yamaha
- Home cinema set Adler
- Home cinema set Aiwa
- Home cinema set Akai
- Home cinema set Blaupunkt
- Home cinema set Bose
- Home cinema set Boston Acoustics
- Home cinema set Dali
- Home cinema set Definitive Technology
- Home cinema set Dell
- Home cinema set Denon
- Home cinema set Eltax
- Home cinema set Fenton
- Home cinema set Focal
- Home cinema set Funai
- Home cinema set GPX
- Home cinema set Harman Kardon
- Home cinema set Hyundai
- Home cinema set ILive
- Home cinema set Iluv
- Home cinema set KEF
- Home cinema set Klipsch
- Home cinema set Konig
- Home cinema set Lenco
- Home cinema set Magnat
- Home cinema set Magnavox
- Home cinema set Marantz
- Home cinema set Meridian
- Home cinema set NAD
- Home cinema set Polk
- Home cinema set Pure Acoustics
- Home cinema set Pyle
- Home cinema set RCA
- Home cinema set Rotel
- Home cinema set Sanyo
- Home cinema set Schneider
- Home cinema set Sharp
- Home cinema set Sherwood
- Home cinema set Sylvania
- Home cinema set Technics
- Home cinema set Teufel
- Home cinema set Thomson
- Home cinema set Wharfedale
- Home cinema set Wolfgang
- Home cinema set Jamo
- Home cinema set Anthem
- Home cinema set Bowers And Wilkins
- Home cinema set Creative
- Home cinema set Edifier
- Home cinema set Nevir
- Home cinema set Majestic
- Home cinema set Canton
- Home cinema set Integra
- Home cinema set Coby
- Home cinema set Audiocore
- Home cinema set Dynaudio
- Home cinema set SVS
- Home cinema set Mitsai
- Home cinema set Fluance
- Home cinema set Amphion
- Home cinema set BBK
- Home cinema set SLS
Nieuwste handleidingen voor Home cinema set
1 December 2024
25 November 2024
23 November 2024
22 November 2024
22 November 2024
22 November 2024
22 November 2024
22 November 2024
22 November 2024
22 November 2024