Pioneer DEH-X8700BT Handleiding

Pioneer Autoradio DEH-X8700BT

Lees hieronder de 📖 handleiding in het Nederlandse voor Pioneer DEH-X8700BT (32 pagina's) in de categorie Autoradio. Deze handleiding was nuttig voor 50 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/32

English Français Italiano Español Deutsch Nederlands Русский

CD RDS RECEIVER

AUTORADIO CD RDS

SINTOLETTORE CD RDS

REPRODUCTOR DE CD CON RECEPTOR RDS

CD RDS-EMPFÄNGER

CD RDS-ONTVANGER

CD RDS ПРИЕМНИК

DEH-X8700DAB

DEH-X8700BT Installation Manual

Manuel d’installation

Manuale d’installazione

Manual de instalación

Installationsanleitung

Installatiehandleiding

Руководство по установке

2En

Important

•When installing this unit in a vehicle

without an ACC (accessory) position on

the ignition switch, failure to connect the

red cable to the terminal that detects

operation of the ignition key may result

in battery drain.

•Use of this unit in conditions other than

the following could result in fire or

malfunction.

–Vehicles with a 12-volt battery and

negative grounding.

–Speakers with 50 W (output value) and

4 Ω to 8 Ω (impedance value).

•To prevent a short-circuit, overheating or

malfunction, be sure to follow the

directions below.

–Disconnect the negative terminal of the

bat tery before installation.

–Secure the wiring with cable clamps or

adhesive tape. Wrap adhesive tape

around wiring that comes into contact

with metal parts to protect the wiring.

– Place all cables away from moving parts,

su ch as the shift lever and seat rails.

–Place all cables away from hot places,

such as near the heater outlet.

–Do not connect the yellow cable to the

battery by passing it through the hole

to the engine compartment.

–Cover any disconnected cable

connectors with insulating tape.

–Do not shorten any cables.

–Never cut the insulation of the power

cable of this unit in order to share the

power with other devices. The current

capacity of the cable is limited.

–Use a fuse of the rating prescribed.

–Never wire the negative speaker cable

directly to ground.

–Never band together negative cables of

multiple speakers.

•When this unit is on, control signals are

sent through the blue/white cable.

Connect this cable to the system remote

control of an external power amp or the

vehicle’s auto-antenna relay control

terminal (max. 300mA 12 V DC). If the

vehicle is equipped with a glass antenna,

connect it to the antenna booster power

supply terminal.

•Never connect the blue/white cable to

the power terminal of an external power

amp. Also, never connect it to the power

terminal of the auto antenna. Doing so

may result in battery drain or a

malfunction.

•The black cable is ground. Ground cables

for this unit and other equipment

(especially, high-current products such as

power amps) must be wired separately. If

they are not, an accidental detachment

may result in a fire or malfunction.

Connections/Installation

Connections

ACC position No ACC position

This unit

Antenna input

Microphone 4 m

Microphone input

DAB antenna input (Only for DEH-

X8700DAB)

Power cord input

AUX input jack (3.5 mm stereo jack)

Rear output

Front output

Subwoofer output

Wired remote input

Hard-wired remote control adapter can

be connected (sold separately).

Fuse (10 A)

USB port

USB cable 1.5 m

Power cord

To power cord input

Depending on the kind of vehicle, the

function of and may be different.

In this case, be sure to connect to

and to .

Yel low

Back-up (or accessory)

Yel low

Connect to the constant 12 V supply

terminal.

Red

Accessory (or back-up)

Red

Connect to terminal controlled by the

ignition switch (12 V DC).

Connect leads of the same color to each

other.

Black (chassis ground)

Blue/white

The pin position of the ISO connector

will differ depending on the type of

vehicle. Connect and when Pin 5

is an antenna control type. In another

type of vehicle, never connect and

3En

English

Blue/white

Connect to the system control terminal

of the power amp (max. 300 mA 12 V

DC).

Blue/white

Connect to the auto-antenna relay

control terminal (max. 300 mA 12 V DC).

Speaker leads

White: Front left

White/black: Front left

Gray: Front right

Gray/black: Front right

Green: Rear left or subwoofer

Green/black: Rear left or subwoofer

Violet: Rear right or subwoofer

Violet/black: Rear right or subwoofer

Orange/white

Connect to a car’s illumination signal.

ISO connector

In some vehicles, the ISO connector

may be divided into two. In this case, be

sure to connect to both connectors.

NOTES

•Change the initial menu of this unit. Refer

to [S/W control]. The subwoofer output of

this unit is monaural.

•W

hen using a subwoofer of 70 W (2 Ω), be

sure to connect the subwoofer to the

violet and violet/black leads of this unit.

Do not connect anything to the green

and green/black leads.

Power amp (sold separately)

Perform these connections when using the

optional amplifier.

System remote control

Connect to blue/white cable.

Power amp (sold separately)

Connect with RCA cables (sold

separately)

To rear output

Rear speaker

To front output

Front speaker

To subwoofer output

Subwoofer

Important

•Check all connections and systems before

final installation.

•Do not use unauthorized parts as this

may cause malfunctions.

•Consult your dealer if installation requires

drilling of holes or other modifications to

the vehicle.

•Do

not install this unit where:

– it may interfere with operation of the

vehicle.

– it may cause injury to a passenger as a

result of a sudden stop.

Installation

•The semiconductor laser will be damaged

if it overheats. Install this unit away from

hot places such as near the heater outlet.

•Optimum performance is

obtained when the unit is

installed at an angle of less

than 60°.

•When installing, to ensure proper heat

dispersal when using this unit, make sure

you leave ample space behind the rear

panel and wrap any loose cables so they

are not blocking the vents.

DIN front/rear mount

This unit can be properly installed using

either front-mount or rear-mount

installation.

Use commercially available parts when

installing.

DIN Front-mount

1Insert the mounting sleeve into the

dashboard.

For installation in shallow spaces, use

the supplied mounting sleeve. If there is

enough space, use the mounting sleeve

that came with the vehicle.

2Secure the mounting sleeve by using a

screwdriver to bend the metal tabs

(90°) into place.

Dashboard

Mounting sleeve

•Make sure that the unit is installed

securely in place. An unstable

installation may cause skipping or

other malfunctions.

DIN Rear-mount

1Determine the appropriate position

where the holes on the bracket and

the side of the unit match.

2Tighten two screws on each side.

Tapping screw (5 mm × 8 mm)

Mounting bracket

Dashboard or console

Removing the unit

1Remove the trim ring.

Trim ring

Notched tab

•Releasing the front panel allows easier

access to the trim ring.

•When reattaching the trim ring, point

the side with the notched tab down.

2Insert the supplied extraction keys

into both sides of the unit until they

click into place.

3Pull the unit out of the dashboard.

Leave ample

space 5 cm

5 cm

Product specificaties

Merk:	Pioneer
Categorie:	Autoradio
Model:	DEH-X8700BT
Kleur van het product:	Zwart
Ingebouwd display:	Ja
Bluetooth:	Ja
Beeldscherm, aantal kleuren:	210000 colours
Equalizer-instellingen:	Ja
Aantal banden equalizer:	5
MP3 afspelen:	Ja
AUX ingang:	Ja
Optische drive type:	CD,CD-R,CD-RW
Afneembaar scherm:	Ja
Ondersteunde frequentiebanden:	AM,FM
Aantal voorkeurszenders:	24
Inclusief RDS tuner:	Ja
USB direct afspelen:	Ja
CD-R afspelen:	Ja
CD-RW afspelen:	Ja
Afstandsbediening inbegrepen:	Ja
Te gebruiken met een iPod:	Ja
Type beeldscherm:	LCD
CD Text:	Ja
Afneembaar frontje:	Ja
Verstelbare kleur:	Ja