Petsafe PIG00-11115 Handleiding

Petsafe Dieren PIG00-11115

Lees hieronder de 📖 handleiding in het Nederlandse voor Petsafe PIG00-11115 (19 pagina's) in de categorie Dieren. Deze handleiding was nuttig voor 37 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/19

Please read this entire guide before beginning

P I G 0 0 -11115

YardMax® Rechargeable In-Ground Fence™

Product Manual

A B

petsafe.com1-800-732-2677 32

You and your pet were made for each other. Our aim is to help you have the best companionship and the most memorable moments

together. Your new YardMax® Rechargeable In-Ground Fence™ system is designed to give your pet maximum freedom while keeping him

safe. We know that safe pets make happy owners. Before getting started, please have your utilities marked, and take a moment to read

through the important safety information. If you have any questions, please don’t hesitate to contact us.

Hereinafter Radio Systems Corporation, Radio Systems PetSafe Europe Ltd., Radio Systems Australia Pty Ltd. and any other affiliate or brand of

Radio Systems Corporation may be referred to collectively as “We” or “Us.”

Important Safety Information

Explanation of attention words and symbols used in this guide:

This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this

symbol to avoid possible injury or death.

WARNING indicates a hazardous situation which, if not avoided, could result in death or serious injury.

CAUTION, used with the safety alert symbol, indicates a hazardous situation which, if not avoided, could result in minor

or moderate injury.

CAUTION, used without the safety alert symbol, indicates a hazardous situation which, if not avoided, could result in

harm to your pet.

NOTICE is used to address practices not related to personal injury.

• Not for use with aggressive pets. Do not use this product if your pet is prone to aggressive behavior. Aggressive pets

can cause severe injury or death to their owners and others. If you are not sure that this product is right for your pet,

please talk to your veterinarian or a certified trainer.

• Underground cables can carry high voltage. Have all underground cables marked before you dig to bury your wire.

In most areas this is a free service. Avoid these cables when you dig.

• Follow all safety instructions for your power tools. Be sure to always wear your safety goggles.

• Do not install, connect or remove your system during a lightning storm. If the storm is close enough for you to hear

thunder, it is close enough to create hazardous surges.

• Risk of electric shock. Use the fence transmitter and surge protector indoors in dry location only.

• Turn off the power to the outlet before you install or remove your surge protector.

• Risk of electrical shock or fire. Use the surge protector only with a duplex outlet with a center screw. Attach the unit

using the long screw supplied.

• This device contains Lithium-Ion (Li-Ion) batteries; never incinerate, puncture, deform, short-circuit, or charge with an

inappropriate charger. Fire, explosion, property damage, or bodily harm may occur if this warning is not followed.

• This system is NOT a solid barrier. It is designed to act as a deterrent to remind pets to remain within the established

boundary by use of static correction. It is important that you reinforce training with your pet on a regular basis. Since

the tolerance level to static correction varies from pet to pet, Radio Systems Corporation CANNOT guarantee that the

system will, in all cases, keep a pet within the established boundary. Not all pets can be trained to avoid crossing the

boundary! Therefore, if you have reason to believe that your pet may pose a danger to others or harm himself if he is

not kept from crossing the boundary, you should NOT rely solely upon this system to confine your pet. Radio Systems

Corporation shall NOT be liable for any property damage, economic loss or any consequential damages sustained

as a result of any animal crossing the boundary.

• Risk of injury. Wire on top of the ground may be a trip hazard; use care in how you place your wires.

• This product is not a toy. Keep it away from the reach of children.

• Do not install the surge protector if there is not at least 30 ft. (10 m) or more of wire between the electrical outlet and

electrical service panel.

Proper fit of the receiver collar is important. A receiver collar worn for too long or made too tight on your pet’s neck may

cause skin damage, ranging from redness to pressure ulcers. This condition is commonly known as bed sores.

• Avoid leaving the receiver collar on your pet for more than 12 hours per day.

• When possible reposition the collar on your pet’s neck every 1 to 2 hours.

• Check the fit to prevent excessive pressure; follow the instructions in this manual.

• When using a separate collar for a leash, do not put pressure on the receiver collar.

• Wash your pet’s neck area and the contact points of the receiver collar weekly with a damp cloth.

• Examine the contact area daily for signs of a rash or a sore.

• If a rash or sore is found, discontinue use of the receiver collar until the skin has healed.

• If the condition persists beyond 48 hours, see your veterinarian.

• For additional information on bed sores and pressure necrosis, please visit our website.

• Proper training of your pet is essential to successfully using the system. During the first 2 weeks of training, do not use

the system without direct supervision of your pet.

These steps will help keep your pet secure and comfortable. Millions of pets are comfortable while they wear stainless

steel contact points. Some pets are sensitive to contact pressure. You may find after some time that your pet is very tolerant

of the receiver collar. If so, you may relax some of these precautions. It is important to continue daily checks of the contact

area. If redness or sores are found, discontinue use until the skin has fully healed.

• You may need to trim the hair in the area of the contact points. Never shave your pet’s neck; this may lead to a rash

or infection.

• The receiver collar should not be on your pet when the system is tested. If it is, your pet may receive an

unintended correction.

• The boundary width of the system must be tested whenever an adjustment is made to the pet area to prevent

unintended corrections to your pet.

• Do not change the transmitter setting from Traditional mode (B) to YardMax® mode (A) without verifying that the

receiver collar will still contain your pet.

• If you use a collar and leash for training, be sure the extra collar does not put pressure on the contact points.

• If possible, DO NOT use an AC circuit protected with a Ground Fault Circuit Interrupter (GFCI) or Residual Current

Device (RCD). In rare cases, nearby lightning strikes may cause the GFCI or RCD to trip. Without power your pet may

be vulnerable to escape. You will have to reset the GFCI or RCD to restore power to the system.

• If the receiver collar fails the ReadyTest® startup, the receiver collar is automatically turned off. Your pet will not

be contained.

• To prevent an unintended correction, after the boundary flags have been placed, be sure to set the static correction

on the receiver collar back to level 1, which is tone only.

• Plug the surge protector into a grounded (3-prong) outlet that is within 5 ft. of the fence transmitter. ALWAYS use a

grounded (3-prong) outlet to ensure maximum protection.

• Do not remove the ground prong from the surge protector plug. Do not use a 3-prong plug to 2-prong outlet

converter. Doing so will make the surge protector ineffective against surges or spikes.

• Use care when mowing or trimming your grass not to cut the loop wire.

• Verify that the boundary loop and transmitter wires connect to the proper surge protector terminals. Reversed

connections will result in an increased risk of surge related damage.

• For added protection, when unused for long periods of time or prior to thunderstorms, unplug from the wall outlet and

disconnect the loop boundary wires. This will prevent damage to the transmitter due to surges.

• Charge your receiver collar when the receiver indicator light blinks red. Do not charge your receiver collar every night.

Charging too often can reduce battery life.

• Avoid damage to the jacket of the loop wire during the install; damage may cause areas of weak signal and lead to

early failure of the loop (wire breaks).

petsafe.com1-800-732-2677 54

Components

Other Items You May Need

• Additional wire and flags (Part # PIG00-13769)

• Additional wire connectors and gel-filled splice capsules

• Drill

• Tape measure

• Small Phillips screwdriver

• Staple gun

• Scissors

• Lighter

• Pliers

• Spade shovel or lawn edger

• Wire stripping pliers

• Waterproofing compound (e.g. silicone caulk)

• Non-metallic collar and leash

• PVC pipe or water hose

• Circular saw with masonry blade

Setup and training help: petsafe.com

A B

Red

Black

Loop Right

Loop Left

TX Left

TX Right

402-027

Red

Black

Loop Right

Loop Left

TX Left

TX Right

After verifying Receiver Collar

operation at the boundary, use the

labels to identify the Boundary Wire

connections to the Transmitter and

the Boundary Wire connections

to the Surge Protector.This will be

convenient to have should any of the

wires become disconnected.

Use on

Transmitter

Connections

Use on

Surge

Protector

Connections

Power

Adaptor

Mounting

Anchors

Mounting

Screws

Test Light

Tool

Boundary Flags—50

Boundary Wire – 500 ft.

Wire

Connectors

Gel-ﬁlled

Splice Capsules

Receiver Collar with

Short Contact Points

Fence Transmitter

Contact

Point Wrench

Long

Contact Points

Transmitter and

Surge Protector

Labels

Surge Protector

(USA & Canada only)

Receiver

Charger

(6 ft.)

Table of Contents

Components ........................................................................................................................................................................................................................ 5

Other Items You May Need ...........................................................................................................................................................................................5

Overview .............................................................................................................................................................................................................................6

How the System Works ....................................................................................................................................................................................................6

YardMax® and Traditional Modes ................................................................................................................................................................................6

Operating Guide ........................................................................................................................................................................................................ 8

Step 1: Have Your Utilities Marked .........................................................................................................................................................................8

Step 2: Charge the Receiver Collar ........................................................................................................................................................................8

Step 3: Install the Surge Protector and Transmitter ...............................................................................................................................................8

Step 4: Design Your Boundary Zone ................................................................................................................................................................... 10

Step 5: Position, Twist and Splice the Boundary Wire ......................................................................................................................................13

Step 6: Connect the Wires ..................................................................................................................................................................................... 14

Step 7: Prepare the Receiver Collar ..................................................................................................................................................................... 14

Step 8: Test the Fence Direction ............................................................................................................................................................................ 16

Step 9: Test the Receiver Collar ............................................................................................................................................................................ 17

Step 10: Bury the Boundary Wire ........................................................................................................................................................................ 19

Step 11: Place the Boundary Flags ....................................................................................................................................................................... 20

Step 12: Fit the Receiver Collar ..............................................................................................................................................................................21

Training Guide ..........................................................................................................................................................................................................22

Day 1—Tone-only Training for Boundary Awareness ...................................................................................................................................... 23

Days 2 Through 4—Boundary Awareness with Static Correction ................................................................................................................ 23

Days 5 Through 8—Distraction Phase .................................................................................................................................................................. 24

Days 9 Through 14—Unleashed Supervision .................................................................................................................................................... 25

Days 15 Through 30—Pet Monitoring ................................................................................................................................................................. 25

Taking Your Pet Out of the Pet Area ............................................................................................................................................................................ 25

Advanced Features ......................................................................................................................................................................................................... 26

System Test........................................................................................................................................................................................................................27

Wire Break Location Test .............................................................................................................................................................................................. 28

Receiver Collar Status Indicators ............................................................................................................................................................................... 29

Troubleshooting .......................................................................................................................................................................................................30

Terms of Use and Limitation of Liability ..................................................................................................................................................................... 32

Compliance ...................................................................................................................................................................................................................... 32

Customer Care International ........................................................................................................................................................................................ 32

Battery Disposal .............................................................................................................................................................................................................. 32

Warranty ...................................................................................................................................................................................................................... 33

Layout Grids ..................................................................................................................................................................................................................... 34