Panasonic TY-SP42P8W-K Handleiding

Panasonic Televisie TY-SP42P8W-K

Lees hieronder de 📖 handleiding in het Nederlandse voor Panasonic TY-SP42P8W-K (28 pagina's) in de categorie Televisie. Deze handleiding was nuttig voor 21 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/28

TQZH663

Monteringsanvisningar

Högtalare för plasma-monitor

Innan arbetet påbörjas ska du noga läsa dessa anvisningar och

bruksanvisningen som medföljer plasmaskärmen för att försäkra att arbetet

utförs på rätt sätt.

(Bevara dessa anvisningar. Du kan behöva anlita dem på nytt för underhåll

eller flyttning av hållaren.)

Monteringsvejledning

Højttalere til plasmaskærm

Før arbejdet påbegyndes, skal De omhyggeligt læse disse instruktioner og

betjeningsvejledningen til plasmaskærmen for at sikre at opsætningsarbejdet

udføres korrekt.

(Gen disse instruktioner. De kan få brug for dem ved vedligeholdelse, eller

hvis ophænget skal flyttes.)

Instrucciones de instalación

Altavoces para Pantalla de Plasma

Antes de empezar el trabajo, lea atentamente estas instrucciones y el manual

de la pantalla de plasma para asegurar una instalación correcta.

(Guarde estas instrucciones. Podrá necesitarlas cuando haga trabajos de

mantenimiento o mueva el soporte.)

Instructions d’installation

Enceintes pour écran Plasma

Avant de commencer le travail, lisez attentivement ces instructions ainsi que le

mode d’emploi de l’écran large à plasma de manière à réaliser un montage

convenable.

(Conservez soigneusement les présentes instructions. Vous pouvez en avoir

besoin pour effectuer un entretien ou si vous désirez déplacer l’applique.)

Instruzioni per I’installazione

Altoparlanti per lo Schermo al Plasma

Prima di iniziare il montaggio leggere attentamente queste istruzioni ed il

manuale dello schermo al plasma allargato per poter procedere al montaggio

in modo corretto.

(Conservare poi queste istruzioni che si renderanno necessarie per la

manutenzione e l’eventuale spostamento della staffa.)

Installatiehandleiding

Luidsprekers voor Plasmadisplay Monitor

Lees deze installatiehandleiding en de bedieningshandleiding voor het

plasmascherm zorgvuldig door voordat u begint, zodat de

montagewerkzaamheden op de juiste wijze worden uitgevoerd.

(Bewaar deze handleiding. U hebt de handleiding weer nodig wanneer u de

bevestigingssteun verwijdert of verplaatst.)

Installationsanleitung

Lautsprecher für Plasmadisplay

Vor der Ausführung lesen Sie bitte diese Anleitung und die

Bedienungsanleitung für das Plasmadisplay sorgfältig durch, damit die

Anbringung richtig ausgeführt wird.

(Bitte bewahren Sie diese Anleitung auf. Sie kann bei der Wartung oder der

erneuten Anbringung der Halterung benötigt werden.)

Installation Instructions

Speakers for Plasma Display

Before commencing work, carefully read these Instructions and the Manual for

the plasma display to ensure that fitting is performed correctly.

(Please keep these instructions. You may need them when maintaining or

moving.)

EnglishDeutschNederlandsItalianoFrançaisEspañolSvenskaDansk

TY-SP37P8W-K

TY-SP37P8W-S

TY-SP42P8W-K

TY-SP42P8W-S

TY-SP50P8W-K

TY-SP50P8W-S

MODEL No.

English

CAUTION

After installing the speakers, do not hold or move the display by lifting the speakers.

• The mounting brackets may get damaged, and personal injury may result.

Do not suspend the speakers.

• Personal injury may result if the speakers fall off. Take particular care to ensure the safety of children.

These speaker are for use with the Plasma Display.

• If connecting them to some other amplifier, make sure that the maximum input is within the rated level(8W). If the

input level is exceeded , fire may result.

Make sure that all screws are tightened securely during installation.

• Ensure that the installation is carried out correctly to prevent the speakers from becoming detached, and possibly

causing possible personal injury.

Safety Precautions

Mounting bracket

(right) .......................2

Mounting bracket

(left) .........................2

Bracket mounting

screw .....................12

Sponge ....................2 Speaker cable

(20 cm) ...................2

Accessories

• Attach the sponges to the surfaces which are in

contact with the Display.

• Clean the surfaces before attaching the sponges.

• Attach the sponge along the rib on the speaker.

1. Attach the sponges to the

speakers.

2. Attach the mounting

brackets to the speakers.

Installation Installing to the Plasma Display

For right For left

Mounting

brackets

(right)

Mounting

brackets

(left)

Bracket mounting

screws

Bracket mounting

screws

Speaker (Ieft)

Speaker (right)

Trim

Sponges

rib

Side of the

speaker

• Secure the top and bottom mounting bracket by

tightening the bracket mounting screw.

• As shown in the enlarged views, adjust the

speakers so that there is some clearance between

them and the display by sliding the right speaker

to the right, and the left speaker to the left, and

then secure the bracket mounting screws.

• Securely tighten the bracket mounting screws.

English

1. If connecting to an external amplifier that exceeds the

rated input for the speakers, keep the amplifier volume

suitably low to protect the speakers from damage. If any

problems occur with speaker operation, disconnect the

mains lead of the amplifier and consult a qualified service

technician.

2. Do not place the speakers in the following places:

• Areas that are exposed to direct sunlight

• Near heaters or other heat sources

• Areas subject to high humidity

3. This set is equipped with magnetic resistant speakers.

However be careful not to place it near a CRT as it may

cause color patches.

4. To clean the speakers, wipe them with a soft cloth. If

they are extremely dirty, wipe them with a cloth that has

been soaked in a small amount of household detergent,

and then wipe them dry with a separate cloth.

• Do not use solvents such as alcohol or thinner.

• If using chemically-treated cloths, follow the

instructions supplied with the cloth packaging.

Notes on use

• Secure the top and bottom mounting brackets by

tightening the bracket mounting screws.

• Secure the left speaker in the same way.

• To change the amount of clearance between the

speakers and the display, loosen the bracket

mounting screws, make adjustments as desired,

and then tighten the screws.

• Tighten the bracket mounting screws securely so

that the speakers are not loose and do not rattle.

4. Secure the speakers in

place.

• Insert the hooks and pin on the top and bottom

mounting brackets simultaneously into the slots at

the rear of the plasma display, and then lower the

speaker into place.

• Attach the left speaker in the same way.

3. Attach the speakers to the

Plasma Display.

• After preparing the ends of the speaker cables, connect them as shown.

•

The red cable is for the (+) side and the black cable is for the (-) side. Do not connect the cables to the wrong sides.

• When connecting the speaker cable, make sure that the core of the cord does not short.

5. Connect the speaker cables.

Hook

Slot

Bracket mounting

screw

Rear of

Plasma Display

Rear of Plasma Display

1. Press down on the lever.

2. Insert the

cable.

3. Release the lever.

1. Push down the lever.

3. Return the lever to its

normal position.

2. Insert

the cable.

Preparing the ends of the

speaker cables

Remove while

twisting

Product specificaties

Merk:	Panasonic
Categorie:	Televisie
Model:	TY-SP42P8W-K
Kleur van het product:	Zwart
Gewicht:	2000 g
Breedte:	107 mm
Diepte:	88 mm
Hoogte:	610 mm
Soort:	TV/Monitor luidsprekers
Connectiviteitstechnologie:	Bedraad
Gemiddeld vermogen:	8 W
Equalizer-instellingen:	Nee
Aanbevolen gebruik:	Universeel
Impedantie:	6 Ohm
Audio-uitgangskanalen:	2.0 kanalen
Woofer:	Ja
Compatibiliteit:	Professional Series Plasma Displays (42" / 8-10 series)
Luidspreker soort:	1-weg
Afmetingen (B x D x H):	107 x 88 x 610 mm
Diameter woofer:	3.1 "
Diameter hogetonenluidspreker:	2.4 "
Aantal satellieten:	2
Gemiddeld vermogen satelietluidsprekers:	16 W
Tweeter:	Ja
Bedrijfstemperatuur (T-T):	0 - 40 °C
Relatieve vochtigheid in bedrijf (V-V):	20 - 80 procent