Monitor Audio Creator C2M-T2X Handleiding

Monitor Audio Speaker Creator C2M-T2X

Lees hieronder de 📖 handleiding in het Nederlandse voor Monitor Audio Creator C2M-T2X (11 pagina's) in de categorie Speaker. Deze handleiding was nuttig voor 30 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/11
Product Manual
Creator Series
Register your speakers using the QR code
or visit monitoraudio.com/registration
Register your Creator Series speakers
to ensure the best possible product and customer support
2
CAUTION: The Creator Series loudspeakers can only be ixed into plasterboard (dry-lined) or
suspended ceilings (in-ceiling models), with a thickness of up to 35mm (excluding the Super
Slim series, which can be ixed up to 15mm) and walls (in-wall models), with a thickness of up
to 30mm. Solid wall installation will require channelling out and framework constructed to
provide a structure for the Tri Grip dog legs to clamp to. For safety reasons, if you are unsure
of your ability to provide a secure and safe ixing, do not attempt to ix these speakers,
please obtain the services of a competent and qualiied trades person.
CAUTION: Ensure that there are no water pipes or electricity cables running within the wall
or ceiling structure before cutting the speaker apertures. Work from secure steps and avoid
trailing wires.
Do not over tighten the Tri-Grip Dog Leg clamps. Over tightening the clamping mechanism on
any in ceiling/ in wall speaker can result in damage to the speaker mounting hardware, ceiling/
wall or speaker frame, and/or delection in the speaker frame during installation.
If you notice any of the above during installation, you have over tightened the Tri Grip Dog Leg.
Back o the mounting screw until delection is reduced to allow the product to sit irmly against
the ceiling or wall.
IMPORTANT: Do not exceed 5Kgf/cm (4.34 lbf/inch.) or 0.5 NM when tightening
the Tri Grip dog leg screws.
When using a cordless screwdriver/ drill to install this product ensure the clutch is set to it’s
lowest setting to avoid over-tightening and damaging the mounting hardware.
Before you unpack your speakers, please make sure that there is plenty of available loor space.
Inside the carton, you will ind a cut-out template that you can use the mark and cut into your
ceilings or walls to the correct size, you’ll also ind your Quik-Link terminal and grille in the box.
Preparing your installation
Overtightening warning


Product specificaties

Merk: Monitor Audio
Categorie: Speaker
Model: Creator C2M-T2X

Heb je hulp nodig?

Als je hulp nodig hebt met Monitor Audio Creator C2M-T2X stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Speaker Monitor Audio

Handleiding Speaker

Nieuwste handleidingen voor Speaker