Mill GMB300 Handleiding

Mill Heater GMB300

Lees hieronder de 📖 handleiding in het Nederlandse voor Mill GMB300 (15 pagina's) in de categorie Heater. Deze handleiding was nuttig voor 37 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/15
ASSEMBLY AND INSTRUCTION MANUAL (EN)
Please read the instrucons carefully before use. Take good care of this manual for later use.
This assembly and instrucon manual applies to the following panel heaters:
IB300, IB600DN, IB900DN, IB1200DN, IB800L DN, IB1000L DN
IB600DN G, IB1200DN G, IB800L DN G
MB300, MB600DN, MB900DN, MB1200DN, MB800L DN, MB1000L DN
PH600DN, PH1000DN, PH600L DN, PH800L DN
PH600DN S, PH1000DN S, PH600L DN S, PH800L DN S
PH600DN G, PH1000DN G, PH600L DN G, PH800L DN G
Series: Steel & Glass
Contents
Important safety informaon .................................................................................................... 3
Descripon of the heater ........................................................................................................... 6
Assembly .................................................................................................................................... 7
Electronic thermostat — Instrucons….……………...................................………………………………………………8
Day/night thermostat – Instrucons ....................................................................................... 10
Maintenance ............................................................................................................................ 15
Warranty .................................................................................................................................. 15
Waste disposal ......................................................................................................................... 15
EN 2 millheat.com
Important safety informaon
You must obey common safety guidelines when using electrical products, especially in the presence of children.
WARNING! To avoid electric shock or damage due to the heat, always make sure the plug is pulled out before the heater is moved or
cleaned.
Read the instrucons carefully.
The product is intended for home use only.
Make sure the heater is connected to the house's regular mains (230 V), as it indicated on the heater.
New heaters will produce a specic odor when used the rst me. This will stop aer a short me and is completely
harmless.
Check for any pieces of packing foam or cardboard that may have fallen into the heang elements of the heater. These
pieces must be removed in order to avoid unpleasant odors.
Prevent the heater from overheang – do not cover.
Always turn o the heater and unplug it when not used for a long me.
Pay special aenon if the heater is used in rooms where children, the handicapped or elderly reside.
The heater should not be set up directly beneath an electrical socket outlet.
The cord must not be laid under any kind of carpet. Make sure the cord is laid in such a way that nobody can trip on it.
The heater must not be used if either the cord or plug is damaged. The heater must not be used if it has been dropped on
the oor or is damaged in any other way causing it to malfuncon.
The cord must be repaired by the manufacturer or by an expert if it has been damaged, to avoid dangerous situaons.
Avoid using extension cords, which may overheat and could possibly start a î„®re.
Never cover the air vents on the heater. Avoid potenal re hazards by making sure the air intakes are not blocked or
covered. The heater should be used in rooms with normal î…‡at î…‡oors.
The heater should not be installed in close proximity to î…‡ammable materials of any kind because there can always be a risk
of î„®re.
The heater must never be used in rooms where gasoline, paint or other î…‡ammable liquids are stored, such as in a garage.
The heater is approved for use in zone 2 in bathrooms.
Never touch an electric heater with wet hands. The heater should be installed so a person showering or taking a bath
cannot come into direct contact with it.
The heater becomes hot when it is on. Therefore, be careful and avoid burning or scorching your skin.
The heater must be switched oî„«, the plug removed and the heater must cool down before it is moved.
Avoid overloading the mains (the circuit) where the heater is connected. The heater may overload the electrical circuit if
other electrical devices are plugged into the same socket outlet.
EN 3 millheat.com

Product specificaties

Merk: Mill
Categorie: Heater
Model: GMB300

Heb je hulp nodig?

Als je hulp nodig hebt met Mill GMB300 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Heater Mill

Mill

Mill PH1000DN Handleiding

17 Mei 2023
Mill

Mill PH800L DN Handleiding

8 Mei 2023
Mill

Mill GL600WIFI3 Handleiding

30 April 2023
Mill

Mill PH1000DN G Handleiding

24 April 2023
Mill

Mill HT12 Handleiding

21 April 2023
Mill

Mill CO2200MECMAX Handleiding

18 April 2023
Mill

Mill AB-H1000DN Handleiding

5 April 2023
Mill

Mill IB1000L DN Handleiding

1 April 2023
Mill

Mill MB800L DN Handleiding

28 Maart 2023
Mill

Mill HT5512 Handleiding

8 Maart 2023

Handleiding Heater

Nieuwste handleidingen voor Heater

Omega Altise

Omega Altise OABRFLPSD Handleiding

20 November 2024
Reer

Reer Viera TX-49FSW504 Handleiding

19 November 2024
Sonnenkonig

Sonnenkonig OFR5A Mini Handleiding

19 November 2024
Yamazen

Yamazen DC-X071 Handleiding

19 November 2024
Yamazen

Yamazen YDH-M10 Handleiding

19 November 2024
Cecotec

Cecotec ReadyWarm 1800 Thermal Connected Handleiding

19 November 2024
Cecotec

Cecotec ReadyWarm 1500 Max Ceramic Handleiding

18 November 2024
Cecotec

Cecotec ReadyWarm 2500 Thermal Connected Handleiding

18 November 2024
Yamazen

Yamazen DBC-L0952 Handleiding

18 November 2024
Yamazen

Yamazen HF-D12 Handleiding

18 November 2024