Manitowoc ID-1802A Handleiding

Manitowoc Ijsmachine ID-1802A

Lees hieronder de 📖 handleiding in het Nederlandse voor Manitowoc ID-1802A (48 pagina's) in de categorie Ijsmachine. Deze handleiding was nuttig voor 10 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/48
Part Number: 000013325 Rev 02 6/17
Indigo Ice Machines
Installation, Operation and Maintenance Manual
This manual is updated as new information and models are released. Visit our website for the latest manual.
Safety Notices
Safety Notices
Read these precautions to prevent personal injury:
• Read this manual thoroughly before operating,
installing or performing maintenance on the
equipment. Failure to follow instructions in this manual
can cause property damage, injury or death.
• Routine adjustments and maintenance procedures
outlined in this manual are not covered by the
warranty.
• Proper installation, care and maintenance are essential
for maximum performance and trouble-free operation
of your equipment.
Visit our website www.manitowocice.com for manual
updates, translations, or contact information for service
agents in your area.
• This equipment contains high voltage electricity and
refrigerant charge. Installation and repairs are to be
performed by properly trained technicians aware of
the dangers of dealing with high voltage electricity and
refrigerant under pressure. The technician must also
be certified in proper refrigerant handling and servicing
procedures. All lockout and tag out procedures must be
followed when working on this equipment.
• This equipment is intended for indoor use only. Do not
install or operate this equipment in outdoor areas.
DEFINITIONS
DANGER
Indicates a hazardous situation that, if not avoided, will
result in death or serious injury. This applies to the most
extreme situations.
nWarning
Indicates a hazardous situation that, if not avoided, could
result in death or serious injury.
,Caution
Indicates a hazardous situation that, if not avoided, could
result in minor or moderate injury.
Notice
Indicates information considered important, but not
hazard-related (e.g. messages relating to property
damage).
NOTE: Indicates useful, extra information about the
procedure you are performing
nWarning
Follow these precautions to prevent personal injury
during installation of this equipment:
• Installation must comply with all applicable equipment
fire and health codes with the authority having
jurisdiction.
• To avoid instability the installation area must be
capable of supporting the combined weight of the
equipment and product. Additionally the equipment
must be level side to side and front to back.
• Ice machines require a deflector when installed on
an ice storage bin. Prior to using a non-OEM ice
storage system with this ice machine, contact the
bin manufacturer to assure their ice deflector is
compatible.
• Remove all removable panels before lifting and
installing and use appropriate safety equipment
during installation and servicing. Two or more people
are required to lift or move this appliance to prevent
tipping and/or injury.
• Do not damage the refrigeration circuit when installing,
maintaining or servicing the unit.
• Connect to a potable water supply only.
• This equipment contains refrigerant charge. Installation
of the line sets must be performed by a properly
trained and EPA certified refrigeration technician aware
of the dangers of dealing with refrigerant charged
equipment.
• Legs or casters must be installed and the legs/casters
must be screwed in completely. When casters are
installed the mass of this unit will allow it to move
uncontrolled on an inclined surface. These units must
be tethered/secured to comply with all applicable
codes. Swivel casters must be mounted on the front
and rigid casters must be mounted on the rear. Lock the
front casters after installation is complete.
• Some 50 Hz models may contain up to 150 grams
of R290 (propane) refrigerant. R290 (propane)
is flammable in concentrations of air between
approximately 2.1% and 9.5% by volume (LEL lower
explosion limit and UEL upper explosion limit). An
ignition source at a temperature higher than 470°C is
needed for a combustion to occur. Refer to nameplate
to identify the type of refrigerant in your equipment.
Only trained and qualified personnel aware of the
dangers are allowed to work on the equipment.

Product specificaties

Merk: Manitowoc
Categorie: Ijsmachine
Model: ID-1802A

Heb je hulp nodig?

Als je hulp nodig hebt met Manitowoc ID-1802A stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Ijsmachine Manitowoc

Manitowoc

Manitowoc CNF0201 Handleiding

3 Juli 2024
Manitowoc

Manitowoc RNF1020C Handleiding

3 Juli 2024
Manitowoc

Manitowoc JC-1395 Handleiding

3 Juli 2024
Manitowoc

Manitowoc K-00068 Handleiding

3 Juli 2024
Manitowoc

Manitowoc SPA-160 Handleiding

3 Juli 2024
Manitowoc

Manitowoc D-320 Handleiding

3 Juli 2024
Manitowoc

Manitowoc D-400 Handleiding

3 Juli 2024
Manitowoc

Manitowoc RF-0266A Handleiding

3 Juli 2024
Manitowoc

Manitowoc SFA-191 Handleiding

3 Juli 2024
Manitowoc

Manitowoc ID-1892N Handleiding

3 Juli 2024

Handleiding Ijsmachine

Nieuwste handleidingen voor Ijsmachine

U-Line

U-Line U-BI1215INT-20A Handleiding

18 December 2024
Unold

Unold Profi Plus 48980 Handleiding

9 December 2024
Unold

Unold Gusto 48945 Handleiding

9 December 2024
Haier

Haier JL-ICM1000A Handleiding

9 December 2024
Haier

Haier JL-ICM720A Handleiding

9 December 2024
Haier

Haier JL-ICM710A Handleiding

9 December 2024
Royal Catering

Royal Catering RCSL 3/10 Handleiding

6 December 2024
Royal Catering

Royal Catering RCSL 2/3 Handleiding

6 December 2024
Monogram

Monogram UNC15NPRII Handleiding

6 December 2024
Tefal

Tefal Gelato IG5007 Handleiding

6 December 2024