KitchenAid KWCU265HSS Handleiding

KitchenAid Niet gecategoriseerd KWCU265HSS

Lees hieronder de đź“– handleiding in het Nederlandse voor KitchenAid KWCU265HSS (24 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 45 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/24
Installation Instructions and
Use and Care Guide
30" (76.2 cm)
36" (91.4 cm)
48" (121.9 cm)
Wall-Mount Canopy Range Hood
IMPORTANT:
Read and save
these instructions.
IMPORTANT:
Installer: Leave Installation Instructions with
the homeowner.
Homeowner: Keep Installation Instructions for
future reference.
Save Installation Instructions for local electrical
inspector's use.
4329224/9763386
Quick Reference
Table of Contents:
Pages
Before you start
Product dimensions
Cabinet dimensions
Venting requirements
Electrical requirements
Installation steps
Use and Care Information
Wiring diagram
Accessories
Warranty
Requesting Assistance or
Service
2
3
3
3
5
5 - 7
8
9
9
10
11 - 12
Before you start...
Proper installation is your
responsibility:
• Have a qualified technician install
this range hood.
• Comply with installation clearances
specified on the model/serial rating
plate.
The model/serial rating plate is
located inside the range hood on the
rear wall.
Range hood location should be away
from strong draft areas, such as
windows, doors and strong heating
vents.
Cabinet opening dimensions that are
shown must be used. Given
dimensions provide minimum
clearance. Consult your cooktop/range
manufacturer installation instructions
before making any cutouts.
Grounded electrical outlet is required.
See “Electrical requirements.”
The canopy hood is factory set for
venting through the roof or wall. For
non-vented (recirculating) installations
see “Non-Vented (Recirculating) Kits”
on the back page.
All openings in ceiling and wall where
range hood will be installed must be
sealed.
Important: Observe all governing
codes and ordinances.
Parts supplied:
4 screws
top
bracket
middle
bracket
bottom
bracket
upper
chimney
canopy
damper
lower
chimney
Parts needed:
2 U.L.- or C.S.A.- listed, 1/2" (12.5 mm)
conduit connectors
power supply cable
1 wall or roof cap
metal vent system
6 screws to attach brackets to wall
Tools needed:
Phillips
screwdriver
flat-blade
screwdriver
caulking gun and
weatherproof
caulking
compound
duct tape
metal
snips
pliers
pencil
saber or
keyhole saw
drill
1-1/4" drill bit
level
measuring
tape or ruler
wire stripper
or utility knife
WARNING — TO REDUCE THE
RISK OF FIRE, ELECTRIC SHOCK,
OR INJURY TO PERSONS,
OBSERVE THE FOLLOWING:
Installation work and electrical
wiring must be done by qualified
person(s) in accordance with all
applicable Codes and Standards,
including Fire Rated
Construction. The combustion
airflow needed for safe
operation of fuel-burning
equipment may be affected by
this unit’s operation. Follow the
heating equipment
manufacturer’s guideline and
safety standards such as those
published by the National Fire
Protection Association (NFPA),
and the American Society of
Heating, Refrigeration and Air
Conditioning Engineers
(ASHRAE), and the local code
authorities.
When cutting or drilling into wall
or ceiling, do not damage
electrical wiring and other
hidden utilities.
Ducted fans must always be
vented to the outdoors.
WARNING — To reduce the risk
of fire, use only metal ductwork.
This unit must be grounded.
2
This is the safety alert symbol.
This symbol alerts you to
potential hazards that can kill
or hurt you and others. All safety
messages will follow the safety alert
symbol and either the word “DANGER”
or “WARNING”. These words mean:
You can be killed or seriously injured
if you don’t follow instructions.
DANGER
WARNING
Your safety and the safety of
others is very important.
We have provided many important
safety messages in this manual and
on your appliance. Always read and
obey all safety messages.
All safety messages will tell you what
the potential hazard is, tell you how to
reduce the chance of injury, and tell
you what can happen if the
instructions are not followed.
You can be killed or seriously injured
if you don’t immediately follow
instructions.
3
Cabinet dimensionsProduct dimensions
92-1/2"
(235 cm)
min.
111-1/2"
(283.2 cm)
max.
ceiling to
floor
Venting requirements
•The size of the vent should be uniform.
•Use no more than three 90° elbows.
•Make sure there is a minimum of 24" (61 cm) of straight
vent between the elbows if more than one elbow is used.
•Do Not install two elbows together.
•The length of vent system and number of elbows should
be kept to a minimum to provide efficient performance.
•The vent system must have a damper. If roof or wall cap
has a damper, Do Not use damper supplied with the
range hood.
•Use duct tape to seal all joints in the vent system.
•Use caulking to seal exterior wall or roof opening around
the cap.
Determine which venting method is best for your
application and follow “Preparation” under ”Installation
steps“ on Page 5.
For the most efficient and
quiet operation:
Vent system must terminate to the outside.
Do not terminate the vent system in an attic or other
enclosed area.
Do not use 4 inch (10.2 cm) laundry-type wall caps.
Use metal vent only. Rigid metal vent is recommended. Do
not use plastic or metal foil vent.
30" hood 29-15/16" (76 cm),
36" hood 35-3/8" (89.9 cm),
48" hood 47-1/4" (120 cm)
overall width
23" (58.4 cm) min. -
42" (106.7) max.
overall chimney
height
22" (58.9 cm)
lower
chimney
height
1" (2.5 cm) min. -
20" (50.8 cm) max.
upper chimney height
9-1/2" (24.1 cm)
canopy height
19-1/4"
(48.9 cm)
overall depth
5-7/8"
(14.9 cm)
10-7/8"
(27.6 cm)
19" (48.3 cm)*
13" (33 cm)
cabinet
depth
34-5/8"
(87.9 cm)
min.
18" (45.7 cm)
min. clearance
upper cabinet to
countertop
* If the canopy hood is installed higher than
24" (61 cm) above the cooking surface, the
middle bracket must be installed at the
bottom point of the upper chimney sleeve.
** If the canopy hood is mounted higher than
24" (61 cm) above cooking surface, depending
on ceiling height, upper chimney may need to
be cut.
36" (91.4 cm)
base cabinet
height
30" hood 30" (76 cm),
36" hood 35-7/16" (90 cm)
48" hood 47-5/16" (120.2 cm)
min. cabinet opening widths
24" (61 cm) min.
bottom of canopy to
cooking surface**

Product specificaties

Merk: KitchenAid
Categorie: Niet gecategoriseerd
Model: KWCU265HSS

Heb je hulp nodig?

Als je hulp nodig hebt met KitchenAid KWCU265HSS stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Niet gecategoriseerd KitchenAid

KitchenAid

KitchenAid KRFC300H Handleiding

11 November 2024
KitchenAid

KitchenAid KFE5T Handleiding

22 Augustus 2024
KitchenAid

KitchenAid KSM500PSOB Handleiding

2 Juli 2023
KitchenAid

KitchenAid RKP26M1XAQ Handleiding

25 Juni 2023
KitchenAid

KitchenAid KFP1466OB Handleiding

13 Juni 2023
KitchenAid

KitchenAid KSM3316XFW Handleiding

8 Juni 2023
KitchenAid

KitchenAid KFP750CR Handleiding

7 Juni 2023
KitchenAid

KitchenAid KF26M1QBX Handleiding

28 Mei 2023
KitchenAid

KitchenAid KFP0933 Handleiding

27 Mei 2023
KitchenAid

KitchenAid KCDI075VA Handleiding

24 Mei 2023

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd

Festo

Festo VPPI Handleiding

21 November 2024
Festo

Festo VAVE-P17-TP-5YL1-P Handleiding

21 November 2024
Festo

Festo SD-SUB-D-BU9 Handleiding

21 November 2024
Festo

Festo SAMH-F12-MK Handleiding

21 November 2024
Festo

Festo SFAB Handleiding

21 November 2024
Festo

Festo SFAH Handleiding

21 November 2024
Festo

Festo DRRD-12 Handleiding

21 November 2024
Festo

Festo SDE3 Handleiding

21 November 2024
Festo

Festo SFTE Handleiding

21 November 2024
Festo

Festo CRVZS-5 Handleiding

21 November 2024