Kenwood TKR-850 Handleiding
Kenwood
Radio communicatie
TKR-850
Lees hieronder de 📖 handleiding in het Nederlandse voor Kenwood TKR-850 (2 pagina's) in de categorie Radio communicatie. Deze handleiding was nuttig voor 43 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/2
INSTALLATION
To install the handles onto the front panel of the repeater,
align the handles with the holes on the front panel, then
secure the handles using the supplied screws.
Please consult your dealer for installing the repeater and
antenna.
MICROPHONE
Connect an optional KMC-30 (E type only), KMC-27A,
KMC-27B, or KMC-9C microphone to theKENWOOD
MIC jack on the front panel.
VHF FM REPEATER/ UHF FM REPEATER
TKR-750/ TKR-850
INSTRUCTION MANUAL
KENWOOD CORPORATION
© B62-1327-20 (K,E)
09 08 07 06 05 04 03 02
NOTICES TO THE USER
UNPACKING AND CHECKING EQUIPMENT
Note:
The following unpacking information is for use by your
KENWOOD
dealer, an authorized
KENWOOD
service facility, or the factory.
Carefully unpack the repeater. We recommend that you
identify the items listed in the following table before
discarding the packing material. If any items are missing
or have been damaged during shipment, file a claim with
the carrier immediately.
FCC WARNING
This equipment generates or uses radio frequency energy. Changes or
modifications to this equipment may cause harmful interference unless
the modifications are expressly approved in the instruction manual. The
user could lose the authority to operate this equipment if an unauthorized
change or modification is made.
â—†
GOVERNMENT LAW PROHIBITS THE OPERATION OF
UNLICENSED RADIO TRANSMITTERS WITHIN THE
TERRITORIES UNDER GOVERNMENT CONTROL.
â—†
ILLEGAL OPERATION IS PUNISHABLE BY FINE OR
IMPRISONMENT OR BOTH.
â—†
REFER SERVICE TO QUALIFIED TECHNICIANS ONLY.
metI rebmuNtraP ytitnauQ
erutxiferawdraH 4X-2048-12J 1
ssalgtnorF 4X-5362-01B 1
retliF 4X-9521-11B 1
noihsuC 4X-1081-31G 4
noihsuC 4X-2081-31G 4
tooF 5X-5740-20J 2
tooF 4X-2940-20J 2
temmorG 5X-2030-95J 2
eldnaH 5X-8140-10K 1
swercS 54-6003-53N 5
drocCD 5X-7243-03E 1
elbacrotcennoC 5X-8223-13E 1
esuF 5X-7351-50F 1
)ylnoepytK(dracytnarraW — 1
launamnoitcurtsnI XX-7231-26B 1
THANK YOU!
We are grateful you purchased this KENWOOD repeater.
We believe this easy-to-program repeater will be highly
effective in your communications system, and will keep
personnel operating at peak efficiency.
KENWOOD incorporates the latest in advanced technol-
ogy into all of our products. As a result, we feel strongly
that you will be pleased with the quality and features of
this product.
FEATURES
• You can easily program channel data using the KPG-66D
software on a PC.
• You can recall 1 of 16 preset channels using either a PF key
or the external control line.
• The firmware can be written to the Flash memory through
an external source.
• QT/DQT signalling can be programmed on each channel. It
simultaneously decodes up to 16 different QT/DQT tones.
• The interface port can be used with external equipment,
such as a repeater controller.
• The repeater has multi-mode capability.
Wide: 30 kHz/ Narrow: 15 kHz (TKR-750; K type only)
Wide: 25 kHz/ Narrow: 12.5 kHz (TKR-750/ TKR-850)
• You can adjust the following functions from a PC:
• Squelch
• RX audio signal output (RA)
• RX detector signal output (RD)
• RX frequency
• RF output power
• Maximum deviation
• TX audio input (TA)
• Signalling deviation (TD)
• DQT balance
• QT deviation
• DQT deviation
• Test tone deviation
• CW ID deviation
• Repeat gain
• TX frequency
PRECAUTIONS
• Do not expose the unit to rain or moisture; to prevent fire or
electric shock.
• Do not open the unit under any circumstances; to avoid risk
of electric shock.
• Do not expose the unit to long periods of direct sunlight, nor
place it close to heating appliances.
• Do not place the unit in excessively dusty and/or humid
areas, nor on unstable surfaces.
• If you detect an abnormal odor or smoke coming from the
unit, disconnect the power from the unit immediately.
Contact your KENWOOD service center or dealer.
REPEATER OPERATION
Note:
Please consult your dealer for programming the repeater.
When power is applied to the unit, the Power indicator
lights:
• Green when using the main DC jack.
• Red when using the Backup terminal.
Rotate the control to adjust the volume.VOLUME
The BUSY indicator lights green while receiving a signal
and the indicator lights red while transmitting.TX
qqqqq Speaker
ww
www CH/STATUS Display
Two, 7-segment digits display the channel number
or status.
ee
eee VOLUME control
Rotate to adjust the volume.
rrrrr DC SOURCE switch
ttttt Power indicator
Lights green when power is applied from the DC
13.6V jack (DC 13.2V jack on E type versions).
Lights red when power is applied from the BACK
UP battery terminal.
yyyyy MIC jack
Connect a microphone to this 8-pin modular jack.
uu
uu
uProgrammable Function keys
Press these keys to activate their programmable
functions.
iiiii BUSY indicator
Lights green while a signal is being received.
oo
oo
oTX indicator
Lights red while transmitting.
â– Rear Panel
qq
qq
qTX OUT jack
Connect a TX antenna or a duplexer to this recep-
tacle.
wwwww CONTROL I/O jack
Connect an external programming device or re-
peater controller to this DB-25 interface.
eeeee FUSE
Insert 15 A blade fuses into these fuse holders.
rr
rr
rRX IN jack
Connect a RX antenna or a duplexer to this BNC
receptacle.
ttttt DC 13.6V (K type) / DC 13.2V (E type) jack
Connect a 13.6 V (K type) or 13.2 V (E type) DC
power supply to this jack.
yyyyy BACKUP battery terminal
uuuuu TEST/SPKR jack
Test input/output jack. Connect an external
speaker to this jack.
TRANSCEIVER OPERATION
â– Receive
Adjust the volume to your desired level. You may need
to readjust the volume when you receive a message
from your dispatcher or another member in your fleet.
• The BUSY indicator lights green while a signal is
being received.
â– Transmit
1Listen to the channel before transmitting, to make
sure it is not being used.
2Press the microphone PTT switch, then speak in
your normal speaking voice.
• FCC regulations require that you identify the
station you are calling as well as your own
station (your assigned call sign).
• The TX indicator lights red while transmitting.
3When you finish speaking, release the PTT switch.
CONTROLS AND FUNCTIONS
â– Front Panel
qq
qqq ww
www rr
rrr tt
ttt
yy
yy
yuu
uu
uii
ii
ioo
oo
o
ee
eee
qqqqq wwwww rrrrr
tttttyyyyyuuuuu
eeeee
* The K type model is
shown in this diagram.
Product specificaties
| Merk: | Kenwood |
| Categorie: | Radio communicatie |
| Model: | TKR-850 |
Heb je hulp nodig?
Als je hulp nodig hebt met Kenwood TKR-850 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Radio communicatie Kenwood
16 April 2022
23 April 2022
2 Mei 2022
2 Mei 2022
30 April 2022
23 April 2022
15 Augustus 2022
7 Mei 2022
16 Augustus 2022
3 Mei 2022
Handleiding Radio communicatie
- Radio communicatie Motorola
- Radio communicatie Albrecht
- Radio communicatie Baofeng
- Radio communicatie Furuno
- Radio communicatie GTV
- Radio communicatie Icom
- Radio communicatie Intek
- Radio communicatie Multi Care Systems
- Radio communicatie President
- Radio communicatie Rexon
- Radio communicatie Simrad
- Radio communicatie Spektrum
- Radio communicatie Stabo
- Radio communicatie Swissphone
- Radio communicatie Team
- Radio communicatie Vertex Standard
- Radio communicatie Wintec
- Radio communicatie Wouxun
Nieuwste handleidingen voor Radio communicatie
3 September 2023
3 September 2023
2 September 2023
26 Augustus 2023
26 Augustus 2023
31 Januari 2023
31 Januari 2023
14 Juli 2023
31 Januari 2023
13 Mei 2023