Juki AK85C Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Juki AK85C (12 pagina's) in de categorie Naaimachine. Deze handleiding was nuttig voor 90 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/12
AK85C
INSTRUCTION MANUAL
– 1 –
INSTALLATION
Congratulations on your purchase of a JUKI's window-plate-mounting type Auto lifter.
The main features of this device are as follows: 1) Simple installation, 2) Usable in combination with the knee lifter.
Please read these instructions to assure long-term satisfactory usage.
1. Press the OFF button of the power switch to turn OFF
the power after conrming that the sewing machine
has stopped.
2. Check to make sure that the power switch is in the OFF
state. Then, unplug the power cord.Perform the work
of step 3. after conrming that the power has been cut
and it has passed for 5 minutes or more.
3. Remove the side plate.
Replace the hinge screw of the knee lifter horizontal
bar and the hinge screw of the knee lifter link with
horizontal bar pin and hinge screw supplied with❶ ❷
the unit. Install knee lifter link spring as illustrated
in the gure.
No clearance is provided
between frame and sponge
No clearance is
provided in the
notch
Tension release wire
Knee lifter horizontal bar
4. Make sure that a sponge is placed as illustrated in
the gure. If not, pass the tension release wire in
the upper notch and pass the knee lifter horizontal
bar in the lower notch so that no clearance is pro-
vided in the notches. In addition, make sure that
there is no clearance between the frame and the
sponge.
* Improperly-installed sponge can be a cause of oil
leakage from the bobbin winder.
– 2 –
6. Install side plate (asm.) on the sewing machine.
At this time, install side plate (asm.) so that the slot
in solenoid link ts over knee lifter horizontal bar
pin .
5. Remove washer and nut from side plate
(asm.) of the device.
7. Install solenoid (asm.) with washer and nut .
8. Lower the presser foot until it comes in close
contact with the throat plate. Turn solenoid shaft
counterclockwise with a screwdriver with theA
solenoid pressed in the direction of the arrow, then
tighten the connecting stud clamping screw with
hexagonal wrench key .B
(Caution) The adequate tightening torque is 3.4 to
5.9 N·m. Be aware, if the connecting stud
clamping screw is excessively tightened,
the solenoid arm can break.
AB


Product specificaties

Merk: Juki
Categorie: Naaimachine
Model: AK85C

Heb je hulp nodig?

Als je hulp nodig hebt met Juki AK85C stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Naaimachine Juki

Handleiding Naaimachine

Nieuwste handleidingen voor Naaimachine