JBL Control CRV Handleiding

JBL Speaker Control CRV

Lees hieronder de 📖 handleiding in het Nederlandse voor JBL Control CRV (16 pagina's) in de categorie Speaker. Deze handleiding was nuttig voor 31 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/16
JBL Control® CRV
Owner’s Manual
JBL CONTROL® CRV LOUDSPEAKERS
JBL Control CRV speakers are perhaps the most exible and
versatile loudspeakers ever developed. There are numerous
mounting options. The JBL Control CRV speaker can be wall-
mounted or corner-mounted, or two, three or four speakers
can be joined together to create loudspeaker solutions
for a wide variety of coverage, appearance and mounting
requirements.
This owner’s guide will cover the installation and wiring
procedures for each mounting option. Simply decide how
you will mount and use the speakers, and then follow the
instructions for your speci c application.
Please note that while the JBL Control CRV speaker is
a general purpose indoor/outdoor loudspeaker, it is not
waterproof. The speaker should not be submerged or
directly exposed to excessive amounts of water, ice, snow or
sustained moisture.
TABLE OF CONTENTS
UNPACKING THE SPEAKERS .......................2
WALL SURFACE MOUNTING ........................3
WALL CORNER MOUNTING ..........................4
WALL CEILING MOUNTING ...........................6
HALF-ROUND WALL MOUNTING ..................7
3/4 ROUND EXTERNAL CORNER
WALL MOUNTING .....................................8
FOUR SPEAKER ARRAY USING
OPTIONAL POLE-MOUNT
BRACKET (PMB) .....................................10
SETTING TAP SELECTOR ...........................13
PAINTING & MAINTENANCE ......................14
SPECIFICATIONS ......................................... 15
DIMENSIONS ................................................16
UNPACKING THE SPEAKERS
If you suspect damage from transit, report it immediately to
your carrier. Keep the shipping carton and packing materials
for future use.
JBL Control CRV Speaker
(2) #10-32 x 2"
Screws
(2) #10-32 x 1/2"
Screws
Corner/Wall-Mount
Bracket Cap
Corner/Wall-Mount
Bracket
(2) Bracket Covers
2
WALL SURFACE MOUNTING
When deciding upon a location for the JBL Control CRV
speaker, take care NOT to install the mounting bracket closer
than 3” (7.6 cm) (horizontal) and 8-1/2” (21.5 cm) (vertical) to
the ceiling. Any closer than the minimum measurements will
not allow the clearance needed to position and slide the JBL
Control CRV speaker into the mounting bracket.
1. Run the wiring to the location desired for mounting the JBL
Control CRV speaker.
2. Using a level, secure the mounting bracket to the wall. Be
sure to use an appropriate anchor.
3. Connect the stripped bare wires to the input terminals of the
JBL Control CRV speaker.
4. Set the tap selector switch to the desired 70V/100V tap, or to
the THRU position for 4 ohm low-impedance operation.
5. The mounting bracket is designed to trap the ange of the
JBL Control CRV speaker by securing the mounting-bracket
cap with two screws through the bottom of the mounting
bracket. Rest the JBL Control CRV speaker’s rear ange in the
mounting bracket, as shown. This will support the weight of the
speaker. Slide the mounting-bracket cap over the assembly.
Secure the mounting-bracket cap by inserting two #10-32 x 2”
screws (provided) in the bottom of the mounting bracket and
tightening.
6. To orient the JBL logo into the correct position, pull the JBL
logo slightly outward from the speaker grille and rotate. The
JBL logo is held in place by a spring. Peel the adhesive cover
off the mounting-bracket cover and attach to the top and bottom
of the mounting assembly.
INSTALLATION
Corner/Wall-Mount-
Bracket Assembly
NOTE: There are two
cable access holes
provided in the Wall-
Mount Assembly.
Appropriate
anchors
3" Minimum distance
from ceiling
to top of bracket
(horizontal mount) 8-1/2" Minimum distance
from ceiling
to top of bracket
(vertical mount)
Mounting-Bracket Cap
Mounting Bracket
#10-32 x 2" Screws (2)
(side view)
(side view)
Mounting Bracket
shown as looking through
the speaker.
Mounting-Bracket Cap
Mounting Bracket
#10-32 x 2" Screws (2)
CAUTION: Installation must be
done by quali ed persons using
safe rigging standards
.
The installer is responsible for proper selection
and use of mounting hardware, to properly and
safely wall-mount the speakers
.
Mounting-Bracket
Cover
Mounting-Bracket
Cover
3


Product specificaties

Merk: JBL
Categorie: Speaker
Model: Control CRV

Heb je hulp nodig?

Als je hulp nodig hebt met JBL Control CRV stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Speaker JBL

Handleiding Speaker

Nieuwste handleidingen voor Speaker