IHome iB50 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor IHome iB50 (3 pagina's) in de categorie Hoofdtelefoon. Deze handleiding was nuttig voor 50 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/3
Limited Lifetime Warranty
iHome Products, a division of SDI Technologies Inc. (hereafter referred to as SDI Technologies), warrants this product
to be free from defects in workmanship and materials, under normal use and conditions, for the lifetime of the product
from the date of original purchase.
Should this product fail to function in a satisfactory manner, it is best to first return it to the store where it was originally
purchased. Should this fail to resolve the matter and service still be required by reason of any defect or malfunction
during the warranty period, SDI Technologies will repair or, at its discretion, replace this product without charge (except
for a $10.00 charge for handling, packing, return UPS/postage, and insurance). This decision is subject to verification
of the defect or malfunction upon delivery of this product to the Factory Service Center listed below. The product must
include proof of purchase, including date of purchase. The fee for service without proof of purchase is $20.00.
Before returning this product for service, please first replace the batteries (if applicable) with fresh ones, as exhausted
or defective batteries are the most common cause of problems encountered.
If service is still required:
1. Remove the batteries (if applicable) and pack the unit in a well padded, heavy corrugated box.
2. Enclose a photocopy of your sales receipt, credit card statement, or other proof of the date of purchase, if within
the warranty period.
3. Enclose a check or money order payable to the order of SDI Technologies, for the sum of $10.00 ($20.00 without
proof of purchase).
4. Send the unit prepaid and insured, to the Factory Service Center listed below.
Consumer Repair Department
SDI Technologies Inc.
1330 Goodyear Drive
El Paso, TX 79936-6420
Disclaimer of Warranty
NOTE: This warranty is valid only if the product is used for the purpose for which it was designed. It does not cover
(i) products which have been damaged by negligence or willful actions, misuse or accident, or which have been
modified or repaired by unauthorized persons; (ii) cracked or broken cabinets, or units damaged by excessive heat;
(iii) damage to digital media players, CD’s or tape cassettes (if applicable); (iv) the cost of shipping this product to the
Factory Service Center and its return to the owner.
This warranty is valid only in the United States of America and does not extend to owners of the product other than
to the original purchaser. In no event will SDI Technologies or any of its affiliates, contractors, resellers, their officers,
directors, shareholders, members or agents be liable to you or any third party for any consequential or incidental
damages, any lost profits, actual, exemplary or punitive damages. (Some states do not allow limitations on implied
warranties or exclusion of consequential damages, so these restrictions may not apply to you.) This warranty gives
you specific legal rights, and you may also have other rights which vary from state to state.
Your acknowledgement and agreement to fully and completely abide by the above mentioned disclaimer of warranty
is contractually binding to you upon your transfer of currency (money order, cashier's check, or credit card) for purchase
of your SDI Technologies product.
iB50-030612-A
Printed in China
Š 2012 SDI Technologies, Inc. All rights reserved
Questions? Visit www.ihomeaudio.com or call 1-800-288-2792 Toll Free.
Model: iB50
The Home iB50 headphones include Active Noise Cancellation circuitry designed to reduce or eliminate
certain background noises, such as airplane engine noise, to give you a quieter, more enjoyable listening
experience. When the ANC circuit is switched ‘On’, a microphone inside each earpiece ‘listens’ for
extraneous noise that is not part of your music, and the ANC circuit then generates an opposite sound
wave designed to eliminate or greatly reduce the extraneous noise. The ANC circuit is powered by two
“AAA” batteries, included.
Using your iHome iB50 Headphones
Installing The Batteries
Although the headphones can be used
without batteries, the Active Noise Cancel-
lation circuit will not operate unless the
batteries are properly installed.
Note: The ANC On/Off switch was set to
the ‘Off’ position at our factory.
Over Ear Active Noise
Cancelling Headphones
with Volume Control
Left Headphone
Mute Button
Cable Jack On/Off Button
LED ANC ‘On’
Indicator
R
Connect The Detachable Cable
Connect the detachable headphone cable to the jack on the
bottom of the L earpiece. The cable should be connected with
the in-line volume control closest to the L earpiece as shown.
Make sure that the plug is fully inserted into the jack. If the plug is
not fully inserted the sound may be intermittent, or you may only
hear sound from one of the earpieces.
Note: The volume control on the cable was set at ‘Maximum’ at
our factory.
Connect the other end of the detachable cable to the headphone jack of your external music source such
as an iPod, iPhone, iPad, MP3 player, personal CD player, etc. Again, make sure that the plug on the
detachable cable is fully inserted into the headphone jack of your external music source.
Listening to Music
• Before putting on your headphones, we recommend that you rotate the volume control on the
headphone cable counter-clockwise until it is approximately half way between the Minimum and
Maximum levels.
• Begin playback of your external music source and adjust the volume level of your external device
to approximately 50% of maximum volume.
• Place the iB50 headphones on your head according to the L and R markings on the earpieces.
When worn properly the detachable cable will be on your left side. Slide the L and R earpieces
up or down to achieve the most comfortable fit.
• Adjust the volume controls on the headphone cable and your external device to a comfortable
listening level. Note: If one control is set too high and the other is set too low, the sound may be
distorted.
• To reduce or eliminate extraneous noise, such as the engine roar in an airplane cabin, slide the
ANC On/Off switch the ‘On’ position. The ANC LED indicator turns red when the ANC circuit is
‘On’.
• When you are finished listening slide the ANC switch to the ‘Off’ position to extend the life of the
batteries. The ANC LED indicator goes ‘Off’. Also remember to shut off the power of your external
music source.
Using The Mute Button (Only When ANC is 'On')
Depress the Mute button on the L earpiece to temporarily shut off the sound so that you can hear
someone speaking to you without removing the headphones. Release the Mute button to resume
normal operation.
Using the 2-Prong Airline Adapter
Some older aircraft have audio/visual systems that use dual
headphone jacks in the armrests of their seats. To use your iB50
headphones with this type of A/V system, insert the plug of the
headphone cable into the jack of the included 2-prong adapter as
shown and insert the 2-prong adapter into the dual jacks in the
armrest of your seat.
Travel Pouch
To keep your headphones clean, store them in the included travel pouch when not in use. The L and
R earpieces fold flat for convenient storage.
Replacing the Batteries
The two “AAA” batteries should provide over 60 hours of continuous operation with the ANC circuit
‘On’. If you notice that the ANC circuit is no longer providing any noticeable noise reduction, or that
the ANC LED indicator does not turn ‘On’, it’s time to replace the batteries.
We recommend that you use a well-known brand of alkaline batteries for longest life and best
performance.
Follow the ‘Installing The Batteries’ instructions above to replace the batteries.
The battery compartment is located inside the R earpiece. To open the battery compartment cover, press
with your thumb at the top of the cover as shown to release the locking tab and slide the cover downward
to remove it.
Insert the two “AAA” batteries into the battery compartment as
shown. Be sure to install the batteries in the correct polarity (+/-)
according to the markings in the battery compartment. If the
batteries are inserted incorrectly the ANC circuit will not operate.
After installing the batteries, replace the battery compartment
cover and make sure it is completely flat against the earpiece with
no gap at the bottom.
Batteries information
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbone-zinc) or
rechargeable (nickel-cadmium) batteries.


Product specificaties

Merk: IHome
Categorie: Hoofdtelefoon
Model: iB50
Kleur van het product: Zwart
Breedte: 180 mm
Diepte: 75.2 mm
Hoogte: 193 mm
Connectiviteitstechnologie: Bedraad
Opbergetui: Ja
Draagwijze: Hoofdband
Positie speakers koptelefoon: Supraaural
Afneembare kabel: Ja
Akoestisch systeem: Gesloten
Type product: Hoofdtelefoons
Ruisonderdrukking microfoon: Ja

Heb je hulp nodig?

Als je hulp nodig hebt met IHome iB50 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Hoofdtelefoon IHome

IHome

IHome NB439 Handleiding

17 Januari 2024
IHome

IHome iB25 Handleiding

17 Januari 2024
IHome

IHome iB14 Handleiding

17 Januari 2024
IHome

IHome DN-M40 Handleiding

17 Januari 2024
IHome

IHome IB29 Handleiding

17 Januari 2024
IHome

IHome iB35 Handleiding

17 Januari 2024
IHome

IHome IB1R Handleiding

17 Januari 2024
IHome

IHome iB40 Handleiding

17 Januari 2024
IHome

IHome iB1 Handleiding

17 Januari 2024
IHome

IHome IB15 Handleiding

16 Januari 2024

Handleiding Hoofdtelefoon

Nieuwste handleidingen voor Hoofdtelefoon