Hunter Victorian 81021 Handleiding

Hunter Ventilator Victorian 81021

Lees hieronder de 📖 handleiding in het Nederlandse voor Hunter Victorian 81021 (42 pagina's) in de categorie Ventilator. Deze handleiding was nuttig voor 26 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/42
Bath Ventilator with Light
Owner’s Manual
Victorian
43041-01
20131201
Model
81021
English Español
Página 22
43041-01 12/01/2013
2
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS,
OBSERVE THE FOLLOWING:
PREVEN TIVE MAINTENANCETA
A clean fan provides better service. Disconnect the power supply and clean the
fan as listed below.
TO CLEAN GRILLE: Use a mild detergent, such as dishwashing liquid, and a
soft cloth. DO NOT use abrasive cloths, steel wool pads or scouring powders.
TO CLEAN FAN ASSEMBLY: Unplug motor cord from receptacle. To remove
motor plate, find the single tab on the motor plate (located next to the recepta-
cle). Push up rear motor plate tab while pushing out on the side of the housing
or insert a screwdriver into the slot in the housing (next to tab) and twist screw-
driver. Gently vacuum fan, motor and interior of housing.
METAL AND ELECTRICAL PARTS SHOULD NEVER BE IMMERSED IN
WATER.
MAINTENANCE
The motor is permanently lubricated and never needs oiling. If the motor bear-
ings are making excessive or unusual
noises, replace the motor with the exact service motor. You should replace the
impeller at the same time.
1. Use this unit only in a manner intended by the manufacturer. If
you have questions, contact the manufacturer.
2. Before servicing or cleaning the unit, switch power off at ser-
vice panel and lock the service disconnecting means to prevent
power from being switched on accidentally. when the service
disconnecting means cannot be locked, securely fasten a promi-
nent warning device, such as a tag, to the service panel.
3. Installation work and electrical wiring must be done by qualified
person(s) in accordance with all applicable codes and standards,
including fire-rated construction.
4. Sufficient air is needed for proper combustion and exhausting
of gasses through the flue (chimney) of fuel burning equipment
to prevent backdrafting. Follow the heating equipment manufac-
turer’s guideline and safety standards, such as those published
by the National Fire Prevention Association (NFPA), and the
American Society for Heating, Refrigeration and Air-Conditioning
Engineers (ASHRAE), and the local code authorities.
5. When cutting or drilling into wall(s) or ceiling, do not
damage electrical wiring or other hidden utilities.
6. Ducted fans must always be vented to the outdoors.
7. If this unit is to be installed over a tub or shower, it must be marked as
appropriate for the application and be connected to a GFCI (Ground
Fault Circuit Interrupter) - protected branch circuit.
8. Never place a switch where it can be reached from a tub or shower.
9. Install fan at least 5 feet (1.52 m) above the floor.
10. This unit must be grounded.
11. Unit must not be installed in a ceiling thermally insulated to a value
greater than R40.
DISCONNECT ELECTRIC
POWER SUPPLY
AND LOCK OUT
SERVICE PANEL BEFORE
SERVICING UNIT
1. For general ventilating use only. Do not use to exhaust haz-
ardous or explosive materials and vapors.
2. To avoid motor bearing damage and noisy/unbalanced impel-
lers, keep drywall spray, construction dust, etc. off power
unit.
3. DO NOT install this product in a wall. This product is
designed for installation in ceilings up to a 12/12 pitch (45
degrees). Ductwork must point upward.
4. Please read specification label on product for further infor-
mation and requirements.
Do Not Install Above
Or Inside This Area
Cooking
Equipment
Floor
45° 45°
W A I N GR N
!
W A I N GR N
!
COOKING AREA
C A U NT I O
!
43041-01 12/01/2013
3
D95044-01-000
M
L
75184-01-133
97956-01-000
K65219-01-000
J77521-01-000
E95029-01-000
A
x4
F77481-01-000
G03242-07-133
I
H
74508-03-133
98037-03-000
N97958-01-000
O77537-01-199
Check all the parts.
If damaged, call
1-888-880-3267
for replacements.
Tools Needed.
Estimated assembly time: 30 to 60 minutes
Included.
B
*
C
*
3/8” Cable Connector
Extra Screws
I
x2
*
NOTE: Strain relief cable connector must be installed. Not Included.

Product specificaties

Merk: Hunter
Categorie: Ventilator
Model: Victorian 81021

Heb je hulp nodig?

Als je hulp nodig hebt met Hunter Victorian 81021 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Ventilator Hunter

Hunter

Hunter Anslee 59269 Handleiding

16 November 2024
Hunter

Hunter Bennett Handleiding

11 November 2024
Hunter

Hunter Gravity Handleiding

11 November 2024
Hunter

Hunter Minimus Handleiding

11 November 2024
Hunter

Hunter Neuron Handleiding

11 November 2024
Hunter

Hunter Phenomenon Handleiding

11 November 2024
Hunter

Hunter Rogers Handleiding

11 November 2024
Hunter

Hunter Rhinebeck Handleiding

11 November 2024
Hunter

Hunter Hardwick Handleiding

11 November 2024
Hunter

Hunter Swanson Handleiding

11 November 2024

Handleiding Ventilator

Nieuwste handleidingen voor Ventilator

Svan

Svan SVP401600MOBA Handleiding

20 December 2024
Svan

Svan SVP401600OBA Handleiding

20 December 2024
Livoo

Livoo DOM510 Handleiding

20 December 2024
Orava

Orava SF-13 Handleiding

18 December 2024
EMOS

EMOS P56PR2 Handleiding

14 December 2024
Midea

Midea FTS30-13AR Handleiding

14 December 2024
Midea

Midea FTS35-9AR Handleiding

14 December 2024
Midea

Midea FTS30-9AR Handleiding

14 December 2024
Aspes

Aspes AVT453100ON Handleiding

13 December 2024
Aspes

Aspes AVP401600OVBA Handleiding

13 December 2024