Hotpoint HSFO 3T223 W X UK Handleiding

Hotpoint Vaatwasser HSFO 3T223 W X UK

Lees hieronder de đź“– handleiding in het Nederlandse voor Hotpoint HSFO 3T223 W X UK (8 pagina's) in de categorie Vaatwasser. Deze handleiding was nuttig voor 24 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/8
EN
1
Before using the appliance carefully read Health and Safety guide.
APPLIANCE
PRODUCT DESCRIPTION
THANK YOU FOR BUYING A HOTPOINT PRODUCT.
In order to receive a more complete assistance, please
register your appliance on: www.hotpoint.eu/register
You can download the Safety Instructions and the
Use and Care Guide, by visiting our website
docs.hotpoint.eu and following the Instructions on
the back of this booklet.
1. Upper rack
2. Foldable aps
3. Upper rack height adjuster
4. Upper spray arm
5. Lower rack
6. Space Zone
7. Cutlery basket
8. Lower spray arm
9. Filter Assembly
10. Salt reservoir
11. Detergent and Rinse Aid dispensers
12. Rating plate
13. Control panel
1. On-O/Reset button with indicator light
2. Program selection button with indicator light
3. Zone Wash 3D button with indicator light
4. Short Time button with indicator light / Key lock
5. Eco program indicator light
6. Key lock indicator light
7. Display
8. Program number and remaining time indicator
DAILY REFERENCE
GUIDE
CONTROL PANEL
9. Tablet (Tab) indicator light
10. Closed water tap indicator light
11. Rinse Aid rell indicator light
12. Salt rell indicator light
13. Extra Dry button with indicator light
14. Tablet (Tab) button with indicator light
15. Delay button with indicator light
16. Start/Pause button with indicator light / Drain out
1
2
3
4
57
8
10
9
13
0000 000 00000
S i :erv ce
1112
6
4
1
3
2
9 16
14 15
65 7 8 11 12 1310
3 ’’
2
FIRST TIME USE
SALT, RINSE AID AND DETERGENT
ADVICE REGARDING THE FIRST TIME USE
After installation, remove the stoppers from the racks and the reta-
ining elastic elements from the upper rack.
FILLING THE SALT RESERVOIR
The use of salt prevents the formation of LIMESCALE on the dishes and
on the machine’s functional components.
• It is important that the salt reservoir be never empty.
• It is important to set the water hardness.
The salt reservoir is located in the lower part of the dishwasher
(see PRODUCT DESCRIPTION) and should be lled when the SALT REFILL
indicator light in the control panel is lit .
1. Remove the lower rack and unscrew the
reservoir cap (anticlockwise).
2. -Only the rst time you do this: ll the salt re
servoir with water.
3. Position the funnel (see gure) and ll the salt
reservoir right up to its edge (approximately
1 kg); it is not unusual for a little water to leak
out.
4. Remove the funnel and wipe any salt residue
away from the opening.
Make sure the cap is screwed on tightly, so that no detergent can get
into the container during the wash program (this could damage the
water softener beyond repair).
Whenever you need to add salt, it is mandatory to complete the
procedure before the beginning of the washing cycle.
SETTING THE WATER HARDNESS
To allow the water softener to work in a perfect way, it is essential that
the water hardness setting is based on the actual water hardness in
your house. This information can be obtained from your local water
supplier.
The factory setting is for average (3) water hardness.
• Switch on the appliance by pressing the button.ON/OFF
• Switch o the appliance by pressing the button.ON/OFF
• Hold down button START/Pause for 5 seconds, until you hear a beep.
• Switch on the appliance by pressing the button.ON/OFF
• The current selection level number and the salt indicator light both ash.
• Press button P to select the desired hardness level (see WATER HARD-
NESS TABLE).
• Switch o the appliance by pressing the button.ON/OFF
Setting is complete!
As soon as this procedure is complete, run a program without loading.
Only use salt that has been specically designed for dishwashers.
After the salt has been poured into the machine, the SALT REFILL indi-
cator light switches o.
If the salt container is not lled, the water softener and the
heating element may be damaged as a result.
Water Hardness Table
Level °dH
German degrees
°fH
French degrees
1 Soft 0 - 6 0 - 10
2 Medium 7 - 11 11 - 20
3 Average 12 - 17 21 - 30
4 Hard 17 - 34 31 - 60
5 Very hard 35 - 50 61 - 90
FILLING THE RINSE AID DISPENSER
Rinse aid makes dish DRYING easier. The rinse aid dispenser should A
be lled when the indicator light in the control RINSE AID REFILL
panel is lit.
1. Open the dispenser B by pressing and pulling up the tab on the lid.
2. Pour in the rinse aid (max.110 ml), making sure it does not overow
from the dispenser. If this happens, clean the spill immediately with
a dry cloth.
3. Press the lid down until you hear a click to close it.
NEVER pour the rinse aid directly into the appliance tub.
ADJUSTING THE DOSAGE OF RINSE AID
If you are not completely satised with the drying results, you can ad-
just the quantity of rinse aid used.
• Switch the dishwasher on using the button.ON/OFF
• Switch it o using the button.ON/OFF
• Press button START/Pause three times - a beep will be heard.
• Switch it on using the button.ON/OFF
• The current selection level number and rinse aid indicator light ash.
• Press button P to select the level of rinse aid quantity to be supplied.
• Switch it o using the buttonON/OFF
Setting is complete!
If the rinse aid level is set to 1 (ECO), no rinse aid will be supplied. The
LOW RINSE AID indicator light will not be lit if you run out of rinse aid.
A maximum of 4 levels can be set according to the dishwasher model.
The factory setting is specic to the model, please follow instruction
above to check this for your machine.
• If you see bluish streaks on the dishes, set a low number (2-3).
• If there are drops of water or limescale marks on the dishes, set a
mid-range number (4-5).
FILLING THE DETERGENT DISPENSER
To open the detergent dispenser use the opening device A.
Introduce the detergent into the dry dispenser B only. Place the
amount of detergent for pre-washing directly inside the tub.
1. When measuring out the detergent
refer to the mentioned earlier infor-
mation to add the proper quantity.
Inside the dispenser there are B
indications to help the detergent
dosing.
2. Remove detergent residues from
the edges of the dispenser and clo-
se the cover until it clicks.
3. Close the lid of the detergent
dispenser by pulling it up until the
closing device is secured in place.
The detergent dispenser automatically opens up at the right time
according to the program.
If all-in-one detergents are used, we recommend using the TABLET
button, because it adjusts the program so that the best washing and
drying results are always achieved.
A
B
A
B
EN
3
ECO program data is measured under laboratory conditions according to European Standard EN 50242.
Note for Test Laboratories:
For information on comparative EN testing conditions, please send an email to the following address: assistenza_en_lvs@indesitcompany.com
Pre-treatment of the dishes is not needed before any of the programs.
*) Not all options can be used simultaneously.
**) The duration of the program shown on the display or in the booklet is an estimate calculated on standard conditions. The actual time may vary
depending on many factors such as temperature and pressure of the incoming water, room temperature, amount of detergent, quantity and type of load,
load balancing, additional selected options and sensor calibration. The sensor calibration can increase program duration up to 20 min.
Standby consumption: Left-on mode consumption: 5 W - O mode consumption: 0.5 W
Program
Drying
phase
Available
options *)
Detergent
container Duration
of wash
program
(h:min)**)
Water
consumption
(litres/cycle)
Energy
consumption
(kWh/cycle)
Tub B
1Eco 50° 4:00 9.0 0.74
2Auto
Intensive 65° - 2:20 - 3:00 16.0 - 18.0 1.20 - 1.40
3Auto
Normal 65° 2:10 - 2:50 14.5 - 16.0 1.05 - 1.25
4Delicates
45°
- 1:40 12.0 1.00
5Express 30’ 50° - - 0:30 9.0 0.50
6Good Night 50° - 3:35 16.5 1.00
7Sanitizing 70° - 1:40 12.0 1.30
8Soak - - --0:10 4.5 0.01
9Self Clean 65° - -0:50 9.5 0.70
PROGRAMS TABLE
PROGRAMS DESCRIPTION
Instructions on wash cycle selection.
1 ECO
Normally soiled crockery. Standard program, the most ecient in
terms of its combined energy and water consumption.
2 AUTO INTENSIVE
Automatic program for heavily soiled dishes and pans (not to be used
for delicate items).
3 AUTO NORMAL
Automatic program for normally soiled pans and dishes.
4 DELICATES
Program for delicate items, which are more sensitive to high tempera-
tures, for example glasses and cups.
5 EXPRESS 30’
Program to be used for lightly-soiled dishes with no dried food
residues.
6 GOOD NIGHT
Suitable for night-time operation of the appliance. Ensures optimal
cleaning and drying performance with the lowest noise emission.
7 SANITIZING
Normally or heavily soiled crockery, with additional antibacterial wash.
Can be used to perform maintenance of the dishwasher.
8 SOAK
Use to refresh crockery planned to be washed later. No detergent to be
used with this program.
9 SELF-CLEAN
Program to be used to perform maintenance of the dishwasher.
It cleans the interior of the appliance using hot water.
Notes:
Please note that cycles like Express or Fast are most eective for lightly so-
iled dishes.
To reduce consumption even further, only run the dishwasher
when it is full.


Product specificaties

Merk: Hotpoint
Categorie: Vaatwasser
Model: HSFO 3T223 W X UK
Apparaatplaatsing: Vrijstaand
Soort bediening: Knoppen
Ingebouwd display: Ja
Gewicht: 39500 g
Breedte: 450 mm
Diepte: 590 mm
Hoogte: 850 mm
Netbelasting: 1900 W
Aantal couverts: 10 couverts
Droogsysteem: Statisch
Deurkleur: Roestvrijstaal
Snoerlengte: 1.3 m
Uitgestelde start timer: Ja
Startvertraging: 24 uur
Resterende tijd indicatie: Ja
Kinderslot: Ja
Afneembaar bovenkant: Ja
Wi-Fi-besturing: Nee
Droogklasse: A
Duur cyclus: 240 min
Geluidsniveau: 43 dB
Jaarlijks energieverbruik: 212 kWu
Gewicht verpakking: 41500 g
Energie-efficiëntieklasse (oud): A++
Geschikt voor paneelaanpassing: Nee
Installatie compartiment breedte: 450 mm
Installatie compartiment diepte: 590 mm
Waterconsumptie per cyclus: 9 l
Wasklasse: A
Stroom: 13 A
Installatie compartiment hoogte (min): 820 mm
Zelfreinigend: Ja
Inverter technologie: Ja
Tijdsduur tot uitschakelen: 12 min
Aantal wasprogramma's: 9
Verstelbare voeten: Ja
Productafmeting: Slimline (45 cm)
Kleur bedieningspaneel: Roestvrijstaal
Bestek compartiment type: Mand
Zout indicator: Ja
Glansmiddel indicator: Ja
Afwasprogramma's: Eco 50°C, Intensive, Normal, Silent, Soak
Energieverbruik per cyclus: 0.74 kWu
Jaarlijks waterverbruik: 2520 l
Lengte afvoerslang: 1.5 m
Lengte watertoevoerslang: 1.55 m
Bovenste mand verstelbare hoogte: Ja
Installatie compartiment hoogte (max): 900 mm
Maximale warmwatertoevoertemperatuur: 60 °C
Temperatuur (max): 70 °C
Manden verstelbare plaatsing: Lower, Upper
Stroomverbruik (ingeschakeld houden): 5 W
Stroomverbruik (indien uit): 0.5 W
AC-ingangsspanning: 220 - 240 V
AC-ingangsfrequentie: 50 Hz
Energie-efficiëntieschaal: A+++ tot D

Heb je hulp nodig?

Als je hulp nodig hebt met Hotpoint HSFO 3T223 W X UK stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Vaatwasser Hotpoint

Handleiding Vaatwasser

Nieuwste handleidingen voor Vaatwasser