Hotpoint HIO 3C22 WS C UK Handleiding

Hotpoint Vaatwasser HIO 3C22 WS C UK

Lees hieronder de 📖 handleiding in het Nederlandse voor Hotpoint HIO 3C22 WS C UK (8 pagina's) in de categorie Vaatwasser. Deze handleiding was nuttig voor 34 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/8
1
EN
DAILY REFERENCE
GUIDE
THANK YOU FOR BUYING A HOTPOINT PRODUCT.
In order to receive a more complete assistance, please
register your appliance on: www.hotpoint.eu/register
You can download the Safety Instructions and the Use
and Care Guide, by visiting our website
docs.hotpoint.eu and following the Instructions on the
back of this booklet.
Before using the appliance carefully read Health and Safety guide.
PRODUCT DESCRIPTION
APPLIANCE
1. Upper rack
2. Foldable flaps
3. Upper rack height adjuster
4. Upper spray arm
5. Lower rack
6. Cutlery basket
7. Lower spray arm
8. Filter Assembly
9. Salt reservoir
10. Detergent and Rinse Aid dispensers
11. Rating plate
12. Control panel
0000 000 00000
Service:
1
2
3
4
5
6
10
12
7
11
9
8
CONTROL PANEL
1. On-Off/Reset button with indicator light
2. Program selection button
3. Salt refill indicator light
4. Rinse Aid refill indicator light
5. Program number and remaining time indicator
6. Delay indicator light
7. Display
8. Zone Wash indicator light
9. Delay button
10.
Zone Wash
button
11. Tablet (Tab) button with indicator light
1 2 3 4 5 6 7 8 9 10 12 1311
1 2 3 4 5 6 7 8 9 10 12 1311
1 2 3 4 5 6 7 8 9 10 11
2
FIRST TIME USE
SALT, RINSE AID AND DETERGENT
ADVICE REGARDING THE FIRST TIME USE
After installation, remove the stoppers from the racks and the retaining
elastic elements from the upper rack.
FILLING THE SALT RESERVOIR
The use of salt prevents the formation of LIMESCALE on the dishes and
on the machine’s functional components.
It is important that the salt reservoir be never empty.
It is important to set the water hardness.
The salt reservoir is located in the lower part of the dishwasher (see
PROGRAMS DESCRIPTION) and should be filled when the SALT REFILL
indicator light in the control panel is lit.
1.Remove the lower rack and unscrew the
reservoir cap (anticlockwise).
2.Position the funnel
(see figure)
and fill the salt
reservoir right up to its edge (approximately 1 kg);
it is not unusual for a little water to leak out.
3.Remove the funnel and wipe any salt residue
away from the opening.
Make sure the cap is screwed on tightly, so that no detergent can get
into the container during the wash program (this could damage the
water softener beyond repair).
Whenever you need to add salt, we recommend carrying out the
procedure before the washing cycle is started.
SETTING THE WATER HARDNESS
To allow the water softener to work in a perfect way, it is essential that
the water hardness setting is based on the actual water hardness in
your house. This information can be obtained from your local water
supplier.
The factory setting is for average (3) water hardness.
Switch on the appliance by pressing the ON/OFF button.
Switch off the appliance by pressing the ON/OFF button.
Hold down button P for 5 seconds, until you hear a beep.
Switch on the appliance by pressing the ON/OFF button.
The current selection level number and the salt indicator light both flash.
Press button P to select the desired hardness level (see WATER
HARDNESS TABLE).
Switch off the appliance by pressing the ON/OFF button.
Setting is complete!
As soon as this procedure is complete, run a program without loading.
Only use salt that has been specifically designed for dishwashers.
After the salt has been poured into the machine, the SALT REFILL
indicator light switches off.
If the salt container is not filled, the water softener and the heating
element may be damaged as a result.
FILLING THE RINSE AID DISPENSER
Rinse aid makes dish DRYING easier. The rinse aid dispenser A should
be filled when the RINSE AID REFILL indicator light in the control
panel is lit.
1. Open the dispenser
B
by pressing and pulling up the tab on the lid.
2. Carefully introduce the rinse aid as far as the maximum (110 ml)
reference notch of the filling space - avoid spilling it. If this happens,
clean the spill immediately with a dry cloth.
3. Press the lid down until you hear a click to close it.
NEVER pour the rinse aid directly into the tub.
ADJUSTING THE DOSAGE OF RINSE AID
If you are not completely satisfied with the drying results, you can ad-
just the quantity of rinse aid used.
Switch the dishwasher on using the ON/OFF button.
Switch it off using the ON/OFF button.
Press button P three times - a beep will be heard.
Switch it on using the ON/OFF button.
The current selection level number and rinse aid indicator light flash.
Press button P to select the level of rinse aid quantity to be
supplied.
Switch it off using the ON/OFF button
Setting is complete!
If the rinse aid level is set to ZERO (ECO), no rinse aid will be supplied. The
LOW RINSE AID indicator light will not be lit if you run out of rinse aid.
A maximum of 4 levels can be set according to the dishwasher model.
The factory setting is for a medium level.
If you see bluish streaks on the dishes, set a low number (1-2).
If there are drops of water or limescale marks on the dishes, set a
high number (3-4).
FILLING THE DETERGENT DISPENSER
To open the detergent dispenser
use the opening device A. Introduce
the detergent into the dry dispenser
B only. Place the amount of
detergent for pre-washing directly
inside the tub.
1.When measuring out the detergent
refer to the
(see PROGRAMS TABLE)
to
add the proper quantity.
Compartment
B
comprises a level
showing the maximum quantity of liquid or powder detergent that
can be added to each cycle.
2. Remove detergent residues from the edges of the dispenser and
close the cover until it clicks.
3. Close the lid of the detergent dispenser by pulling it up until the
closing device is secured in place.
The detergent dispenser automatically opens up at the right time
according to the program.
If all-in-one detergents are used, we recommend using the
TABLET
button, because it adjusts the program so that the best washing and
drying results are always achieved.
Water Hardness Table
Level °dH
German degrees
°fH
French degrees
1 Soft 0 - 6 0 - 10
2 Medium 7 - 11 11 - 20
3 Average 12 - 17 21 - 30
4 Hard 17 - 34 31 - 60
5 Very hard 35 - 50 61 - 90
M
A
X
A
B
35
25
A
B
3
EN
PROGRAMS TABLE
ECO program data is measured under laboratory conditions according to European Standard EN 50242.
*) Not all options can be used simultaneously.
**) The duration of the program shown on the display or in the booklet is an estimate calculated on standard conditions. The actual time may vary
depending on many factors such as temperature and pressure of the incoming water, room temperature, amount of detergent, quantity and type of load,
load balancing, additional selected options and sensor calibration. The sensor calibration can increase program duration up to 20 min.
Standby consumption: Left-on mode consumption: 5 W - Off mode consumption: 0.5 W
Program
Drying
phase
Available options *)
Detergent
container Duration of
wash program
(h:min)**)
Water
consumption
(litres/cycle)
Energy
consumption
(kWh/cycle)
Tub B
1. Eco 50° 3:10 9 0.93
2. Auto Intensive 65° - 2:00 - 3:10 14 - 17 1.50 - 1.85
3. Auto Normal 55° 1:30 - 2:30 14.5 - 16 1.15 - 1.30
4. Auto Fast 50° - - 0:40 - 1:20 13 - 14.5 1.15 - 1.25
5. Express 30’ 50° - - 0:30 9 0.50 - 0.55
6. Good Night 50° - 3:30 15 1.15
7. Sanitizing 65° - 1:40 10 1.30
8. Soak - - - - 0:12 4.5 0.01
9. Self- Clean 65° - - 0:50 8 0.80 - 0.85
PROGRAMS DESCRIPTION
Instructions on wash cycle selection.
ECO
Normally soiled crockery. Standard program, the most efficient in terms
of its combined energy and water consumption.
AUTO INTENSIVE
Heavily soiled dishes and pans (not to be used for delicate items).
AUTO NORMAL
Automatic program for normally soiled pans and dishes.
AUTO FAST
Limited quantity of daily soiling (ideal for 4 place settings).
EXPRESS 30’
Program to be used for lightly-soiled dishes with no dried food
residues. (Ideal for 2 place settings).
GOOD NIGHT
Suitable for night-time operation of the appliance. Optimum
performance ensured.
SANITIZING
Normally or heavily soiled crockery, with additional antibacterial wash.
SOAK
Crockery to be washed later. No detergent to be used with this
program.
SELF-CLEAN
Program to be used to perform maintenance of the dishwasher. It
cleans the interior of the appliance using hot water.
Notes:
Optimum performance levels when using the “1 Hour” and “Rapid
programs can be achieved by observing the maximum amounts of
specified place settings.
To reduce consumption even further, only run the dishwasher
when it is full.


Product specificaties

Merk: Hotpoint
Categorie: Vaatwasser
Model: HIO 3C22 WS C UK
Apparaatplaatsing: Volledig ingebouwd
Soort bediening: Knoppen
Gewicht: 35500 g
Breedte: 598 mm
Diepte: 555 mm
Hoogte: 820 mm
Netbelasting: 1900 W
Aantal couverts: 14 couverts
Deurkleur: Niet van toepassing
Snoerlengte: 1.3 m
Uitgestelde start timer: Ja
Startvertraging: 12 uur
Droogklasse: A
Duur cyclus: 190 min
Geluidsniveau: 41 dB
Jaarlijks energieverbruik: 266 kWu
Gewicht verpakking: 37500 g
Energie-efficiëntieklasse (oud): A++
Installatie compartiment breedte: 600 mm
Installatie compartiment diepte: 560 mm
Installatie compartiment hoogte: 900 mm
Waterconsumptie per cyclus: 9.5 l
Wasklasse: A
Stroom: 13 A
Installatie compartiment hoogte (min): 820 mm
Zelfreinigend: Ja
Inverter technologie: Ja
Verstelbare voeten: Ja
Productafmeting: Volledige grootte (60 cm)
Kleur bedieningspaneel: Zilver
Bestek compartiment type: Mand
Zout indicator: Ja
Glansmiddel indicator: Ja
Afwasprogramma's: Eco, Intensive, Normal, Quick, Silent, Soak
Energieverbruik per cyclus: 0.934 kWu
Jaarlijks waterverbruik: 2660 l
Lengte afvoerslang: 1.5 m
Lengte watertoevoerslang: 1.55 m
Bovenste mand verstelbare hoogte: Ja
Installatie compartiment hoogte (max): 900 mm
Maximale warmwatertoevoertemperatuur: 60 °C
Temperatuur (max): - °C
Stroomverbruik (ingeschakeld houden): 6 W
Stroomverbruik (indien uit): 0.5 W
AC-ingangsspanning: 220 - 240 V
AC-ingangsfrequentie: 50 Hz
Energie-efficiëntieschaal: A+++ tot D

Heb je hulp nodig?

Als je hulp nodig hebt met Hotpoint HIO 3C22 WS C UK stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Vaatwasser Hotpoint

Handleiding Vaatwasser

Nieuwste handleidingen voor Vaatwasser