Hotpoint AQD1171D 697ID EU/A Handleiding

Hotpoint Wasmachine AQD1171D 697ID EU/A

Lees hieronder de 📖 handleiding in het Nederlandse voor Hotpoint AQD1171D 697ID EU/A (84 pagina's) in de categorie Wasmachine. Deze handleiding was nuttig voor 21 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/84

English,1

! This symbol reminds you to read this

instruction manual.

Contents

Installation, 2-3

Unpacking and levelling

Connecting the electricity and water supplies

Technical data

Care and maintenance, 4

Cutting off the water and electricity supplies

Cleaning the machine

Cleaning the detergent dispenser drawer

Caring for your appliance drum

Cleaning the pump

Checking the water inlet hose

Precautions and advice, 5

General safety

Disposal

Opening the porthole door manually

Description of the machine, 6-7

Touch control panel

How to run a wash cycle or a drying

cycle, 8

Wash cycles and options, 9

Table of wash cycles

Wash options

Detergents and laundry, 10

Detergent

Preparing the laundry

Washing recommendations

Load balancing system

Trouble shooting, 11

Assistance, 12

WASHER-DRYER

AQUALTIS

AQD1171D 697ID

Instructions for

installation and use

Italiano,13

IT DE

Deutsch,25

Svenska,37

Dansk,61

Norsk,73

Suomi,49

Installation

! This instruction manual should be kept in a

safe place for future reference. If the Washer-

dryer is sold, given away or moved, please

ensure the manual is kept with the machine,

so that the new owner may benefit from the

advice contained within it.

! Read these instructions carefully: they

contain vital information relating to the safe

installation and operation of the appliance.

! Inside the pack containing this manual, you

will also find the guarantee and all the details

necessary for installation.

Unpacking and levelling

Unpacking

1. Once you have removed all the packaging

from the Washer-dryer, make sure it has not

been damaged during transportation.

If it has been damaged, contact the retailer

and do not proceed any further with the

installation process.

2. Remove the 4

protective screws

(used during

transportation) and

the corresponding

spacer, located on

the rear part of the

appliance ( ). see figure

3. Close off the holes using the plastic plugs

supplied in the pack.

4. Keep all the parts in a safe place; they will

be needed again if the Washer-dryer is moved

to another location, to prevent the inside of the

appliance being damaged.

! Packaging materials should not be used as

toys for children.

Levelling

1. Place the Washer-

dryer on a flat sturdy

floor, without resting

it up against walls or

cabinets.

2. If the floor is

uneven, the front feet

of the machine may

be adjusted until it

reaches a horizontal

position (the angle of

inclination must not exceed 2 degrees).

! If the appliance is levelled correctly, it will

be more stable and much less likely to cause

vibrations and noise while it is operating,

particularly during the spin cycle.

! If it is placed on carpet or a rug, adjust the

feet in such a way as to allow a sufficient

ventilation space underneath the Washer-dryer.

Connecting the electricity and

water supplies

Connecting the water inlet hose

! Before connecting the inlet hose to the water

supply, run the water until it is perfectly clear.

1. Connect the inlet

hose to the machine

by screwing it onto

the cold water inlet of

the appliance, which

is situated on the top

right-hand side of

the rear part of the

appliance . (see figure)

2. Connect the inlet

hose by screwing it to

a cold water tap using

a 3/4 gas threaded

connection (see

figure).

3. Make sure that the hose is not folded over

or bent.

! The water pressure at the tap must fall within

the values indicated in the Technical data table

(see next page).

! If the inlet hose is not long enough, contact a

specialised shop or an authorised technician.

! Never use second-hand or old inlet hoses;

use the products supplied with the machine.

Connecting the drain hose

Connect the drain

hose to drain duct

piping or a wall drain

located between 65

and 100 cm above

the floor, making sure

it is not bent at all.

Alternatively, place

the drain hose

over the edge of

a washbasin or

bathtub, by fastening

the guide (which

can be purchased

at the technical

assistance centre) to

the tap (see figure).

The free end of the

hose should not be underwater.

! We advise against the use of hose extensions;

if it is absolutely necessary, the extension must

have the same diameter as the original hose

and must not exceed 150 cm in length.

Electrical connections

Before plugging the appliance into the

electricity socket, make sure that:

• thesocketisearthedandcomplieswithall

applicable laws;

• thesocketisabletowithstandthemaximum

power load of the appliance as indicated in

the Technical data table (see opposite);

• thepowersupplyvoltagefallswithinthe

values indicated in the Technical data table

(see opposite);

• thesocketiscompatiblewiththeplugofthe

appliance. If this is not the case, have the

socket or the plug replaced.

! The machine must not be installed outdoors,

even in covered areas. It is extremely

dangerous to leave the appliance exposed to

rain, storms and other weather conditions.

! The mains socket must remain within

easy reach after the Washer-dryer has been

installed.

! Do not use extension cords or multiple

sockets.

! The cable should not be bent or compressed.

! The power supply cable and plug must only

be replaced by authorised technicians.

Warning! The company shall not be held

responsible in the event that these regulations

are not respected.

65 - 100 cm

Technical data

Model AQD1171D 697ID

Dimensions

width 59.5 cm

height 85 cm

depth 64.5 cm

Capacity

from 1 to 11 kg for the wash

programme

from 1 to 7 kg for the drying

programme

Electrical

connections

please refer to the technical

data plate fixed to the machine

Water con-

nections

maximum pressure

1 MPa (10 bar)

minimum pressure

0.05 MPa (0.5 bar)

drum capacity 71 litres

Spin speed up to 1600 rotations per

minute

Energy ra-

ted

programmes

according to

regulation

EN 50229

Wash: programme

60°/40°

; tem-

perature 60°C; using a load

of 11 kg.

Drying: the major load (7kg)

must be dried by selecting

the “EXTRA” dryness level;

the remainder of the load

must be dried by selecting

the “EXTRA” dryness level,

the load must consist of 3

sheets and 7 pillowcases.

This appliance conforms to

the following EC Directives:

- EMC 2014/30/EU (Electro-

magnetic Compatibility)

- LVD 2014/35/EU (Low

Voltage)

- 2012/19/EU - (WEEE)

Product specificaties

Merk:	Hotpoint
Categorie:	Wasmachine
Model:	AQD1171D 697ID EU/A
Apparaatplaatsing:	Vrijstaand
Kleur van het product:	Wit
Deurscharnieren:	Rechts
Ingebouwd display:	Ja
Gewicht:	75600 g
Breedte:	595 mm
Diepte:	616 mm
Hoogte:	850 mm
Type lader:	Voorbelading
Energie-efficiëntieklasse (oud):	A
Energieverbruik wassen:	1.1 kWu
Wasklasse:	A
Jaarlijkse energieverbruik wassen:	226 kWu
Geluidsniveau (wassen):	53 dB
Aanpasbare centrifugesnelheid:	Ja
Maximale centrifugesnelheid:	1600 RPM
Droogcapciteit:	7 kg
Geluidsniveau bij centrifugeren:	83 dB
Geluidsniveau (drogen):	59 dB
Jaarlijks waterverbruik wassen:	12400 l
Jaarlijks engergieverbruik wassen & drogen:	1346 kWu
Energiegebruik bij wassen & drogen:	6.7 kWu
Waterverbruik wassen & drogen:	120 l
Water verbruik wassen:	62 l
Restvochtpercentage:	44 procent
Kijkglas:	Ja
Programmaduur wassen & drogen:	645 min
Spoelen Plus functie:	Ja
Nominale capaciteit (wassen):	11 kg
Type beeldscherm:	LCD
Wasprogramma's:	Hygiene/anti-allergy, Blouse/shirt, Cotton, Wool, Synthetics, Delicate/silk
Droogprogramma's:	Delicate/silk, Blouse/shirt, Cotton, Synthetics