Hotpoint AQC94F7E1M Handleiding

Hotpoint Wasdroger AQC94F7E1M

Lees hieronder de 📖 handleiding in het Nederlandse voor Hotpoint AQC94F7E1M (20 pagina's) in de categorie Wasdroger. Deze handleiding was nuttig voor 23 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/20

English

Contents

Important Information, 2-3

Installation, 4

Where to put your dryer

Ventilation

Electrical connection

Levelling the tumble dryer

Before you start using your dryer

Dryer Description, 5

Open the door

The Features

Control Panel

The Display, 6

Start and Programmes, 7-12

Choosing a Programme

Special Programmes

Table of Programmes

The Controls

Laundry, 13-14

Sorting your laundry

Wash care labels

Special clothing items

Drying times

Warnings and Suggestions, 15

General safety

Save energy and respect the

Environment

Maintenance and Care, 16

Switching off the electricity

Clean the filter after each cycle

Check the drum after each cycle

Empty the Water Container after each cycle

Cleaning the Heat Pump Filter

Cleaning the dryer

Troubleshooting, 17

Service, 18

Spare parts

Disposal

Hotpoint Guarantee, 19

Hotpoint After Sales Service, 20

TUMBLE DRYER

AQUALTIS

AQC9 4F7

Instruction booklet

! This symbol reminds you to read this instruction manual.

! Keep this instruction booklet on hand in order to refer to it when

necessary. Take it with you when you move, and, should you sell this

appliance or pass it on to another party, make sure that this booklet

is supplied along with the dryer so that the new owner may be infor-

med about warnings and suggestions on how the dryer works.

! Read these instructions carefully; the following pages contain impor-

tant information on installation and suggestions on how the appliance

works

Important Information

For your Condenser dryer to operate efficiently,

you must follow the regular maintenance schedule

shown below:

Fluff Filter – You MUST Clean the fluff filter after

every drying cycle.

Step 1

Open the door of your dryer.

Step 2

Pull out the filter (using the two

finger grips).

Step 3

Open the filter by releasing the

clip.

Step 4

Clean any fluff deposits from the

inside surface of the filter mesh.

Step 5

Refit the filter – Never run the

dryer without a filter.

Failure to clean the filter after every drying cycle will

affect the drying performance of your machine – It

will take longer to dry and as a result will use more

electricity during drying.

Water Container – You must empty the water

container after every drying cycle.

Step 1

Pull the water container

towards you and remove it fully

from the dryer.

Step 2

Empty the Water from the

Container.

Step 3

Refit the Water Container

ensuring that it is pushed fully

back into position.

Failure to empty the Water Container will result in:

- The machine will stop heating (so the load may be

wet at the end of the cycle).

- The ”Empty Water” light will flash to tell you that

the Container is full.

! The water bottle/clean filter

light comes on when you select

a programme to remind you to

make sure that the water bottle

is empty and that the filter is

clean before starting a new

cycle’

Priming the Water Collection System

When your dryer is new, the Water Container will not

collect Water until the system is primed, this will take

1 or 2 drying cycles. Once primed it will collect Water

during every cycle.

Step 5

Refit the filter unit - ensure that the unit is pushed in fully, then

turn all 4 clips into the horizontal position to lock the cover.

Failure to clean Heat Pump Filter will reduce the

drying performance and could cause premature

failure of your dryer.

To maintain optimum drying performance we

recommend you clean this filter after every drying

cycle.

Heat Pump Filter Unit - You must clean the fluff

from the filter every five drying cycles to maintain

the correct functioning of your dryer !

However for optimum performance and to save

energy we recommend that it is cleaned before

each drying cycle.

Step 1

Open the heat pump filter

Cover.

- hold the handle and pull

towards you.

Step 2

Remove the filter unit by

rotating the 4 clips to the

vertical position then pulling

the filter unit towards you.

(There may be some water in

the filter this is normal).

! Warning: The front of the heat pump is made from thin

metal plates.

Take care that you do not damage these or cut yourself

when cleaning, removing or replacing the filter unit.

Step 3

If there is any build up of

fluff on the plates Carefully

clean this off with a damp

cloth, sponge or vacuum

cleaner.

Never use your Fingers.

Step 4

Seperate the two parts of

the filter unit, clean any fluff

deposits from the inside

surface of the filter mesh.

Clean the seals.

Assemble the two parts.

Product specificaties

Merk:	Hotpoint
Categorie:	Wasdroger
Model:	AQC94F7E1M
Apparaatplaatsing:	Vrijstaand
Soort bediening:	Buttons, Rotary
Kleur van het product:	Wit
Deurscharnieren:	Links
Ingebouwd display:	Ja
Warmtebron:	Electrisch
Gewicht:	48000 g
Breedte:	595 mm
Diepte:	630 mm
Hoogte:	850 mm
Type lader:	Voorbelading
Droogsysteem:	Warmtepomp
Trommelinhoud:	112 l
Uitgestelde start timer:	Ja
Kinderslot:	Ja
Aantal droogprogramma's:	16
Droogklasse:	B
Duur cyclus:	235 min
Geluidsniveau:	69 dB
Anti-kreuk functie:	Ja
Energie-efficiëntieklasse:	A+
Energie consumptie:	- kWu
Jaarlijks energieverbruik:	337 kWu
Breedte verpakking:	640 mm
Diepte verpakking:	670 mm
Hoogte verpakking:	890 mm
Draairichting deur verwisselbaar:	Ja
Waarschuwingssignaal:	Ja
Deur openingshoek:	180 °
Nominale capaciteit:	9 kg
Droogprogramma's:	Wool, Delicate/silk, Jeans/denim, Blouse/shirt, Cotton, Synthetics