Hotpoint AQC9 BF7 E1 (UK) Handleiding

Hotpoint Wasdroger AQC9 BF7 E1 (UK)

Lees hieronder de đź“– handleiding in het Nederlandse voor Hotpoint AQC9 BF7 E1 (UK) (20 pagina's) in de categorie Wasdroger. Deze handleiding was nuttig voor 33 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/20
1
GB
English
GB
TUMBLE DRYER
AQUALTIS
AQC9 BF7
Instruction booklet
Contents
Installation, 2
Where to put your dryer
Ventilation
Electrical connection
Levelling the tumble dryer
Before you start using your dryer
Warnings and Suggestions, 4
General safety
Save energy and respect the
Environment
Maintenance and Care, 6
Switching off the electricity
Clean the filter after each cycle
Check the drum after each cycle
Empty the Water Container after each cycle
Cleaning the Heat Pump Filter
Cleaning the dryer
Dryer Description, 8
Open the door
The Features
Control Panel
The Display, 9
Start and Programmes, 10
Choosing a Programme
Special Programmes
Table of Programmes
The Controls
Laundry, 16
Sorting your laundry
Wash care labels
Drying times
Troubleshooting, 17
Service, 18
Spare parts
Disposal
! This symbol reminds you to read this
instruction manual.
! Keep this manual at hand for immediate reference whenever
necessary. Always store this manual close to the tumble dryer and
remember to pass it on to any new owners when selling or tran-
sferring the appliance, so they may familiarise with the warnings
and suggestions herein contained.
! Read these instructions carefully: the following pages contain
important information on installation and useful suggestions for
operating the appliance.
www.hotpoint.co.uk
To activate you free* 5 years parts guarantee
Call free on 0800 519 2102
*Labour charges not included. Terms and conditions apply. Lines open 364 days a year.
Calls are free from a BT landline. Charges from other providers and mobiles may apply.
2
GB
Where to install the tumble dryer
• Install the dryer far
from gas ranges, stoves,
radiators or hobs, as
flames may damage it.
If the dryer is installed
below a worktop, en-
sure there are 10 mm
between the upper pa-
nel of the dryer and any
objects above it, and 15
mm between the sides of the machine and
the walls or furniture units adjacent to it. This
ensures adequate air circulation.The applian-
ce must be installed with the rear surface
placed against a wall.
Ventilation
• The room must be adequately ventilated while the dryer is
running. Make sure that the dryer is installed in a room free
of humidity and with adequate air circulation. The flow of air
around the dryer is essential to allow water to condense du-
ring drying; the dryer will not function properly if it is placed
in an enclosed space or inside a cabinet.
! Some condensation may form if the dryer is used in a small
or cold room.
! We do not recommend that the dryer is installed in a
cupboard but the dryer must never be installed behind a
lockable door, a sliding door or a door with a hinge on the
opposite side to that of the dryer door.
!
We do not recommend that the dryer is
installed in a cupboard but the dryer must never
be installed behind a lockable door, a sliding
door or a door with a hinge on the opposite
side to that of the dryer door.
Water drain
If your dryer is installed next to a drain the water can be
plumbed into this drain. This does away with the need to
empty the water container. If the dryer is stacked onto or
installed next to a washing machine it can share the same
drain. The height of the drain must be less than 3’ (1 m) from
the bottom of the dryer.
Remove existing hose from position shown in picture A and fit
a suitable length of hose and connect as shown in picture B.
! Make sure that the hose is not squashed or kinked
when the dryer is in its final location.
Electrical connections
Before plugging the appliance into the socket,
check the following:
• Make sure your hands are dry.
• The socket must have an earth connection.
• The socket must be able to withstand the
machine’s maximum power output as indi-
cated on the rating plate (see Description
of the tumble dryer).
• The power supply voltage must fall within
the values indicated on the data plate (see
Description of the tumble dryer).
• The socket must be compatible with the
dryer’s plug. Should this not be the case,
replace the plug or the socket.
! Do not use extension cords.
! The dryer must not be installed outdoors,
even if the space is sheltered. It can be very
dangerous if exposed to rain or storms.
! Once installed, the dryer’s electrical wire
and plug must be within reach.
! The power cord must not be bent or
squashed.
! The power cord is supplied fitted with a
BS1363 plug and with a 13 amp BS1362 fuse.
If it is necessary to fit a replacement fuse, it must
be a 13 Amp ASTA approved to BS1362 type.
WARNING: The plug must not be used without
a fuse cover. If a replacement fuse holder/cover
is required, it must be of the same colour coding
or wording as shown on the base of the plug.
Replacements are available from authorised
dealers.
Changing the plug
The wires in the power cord are coloured in
accordance with the following.
! If the plug being replaced is a non-
rewirable type, then the cut-off plug
must be disposed of safely. DO NOT
leave it where it can be inserted into a
socket and create a shock hazard.
! The power must be regularly che-
cked. If the supply cord is damaged, it
1
2
2
1
Less than 1m
Picture APicture B
Installation
10 mm
15 mm 15 mm
3
GB
This household tumble drier is a Condenser
The weighted Annual Energy Consumption (AEc)* kWh 1) 615.8
This household tumble drier is a Automatic
Energy consumption full load; Edry - kWh 2) 5.19
Energy consumption partial load; Edry½ - kWh 2) 2.83
Power consumption: off-mode (Po) - Watts 0.14
Power consumption: left-on mode (Pl) - Watts 2.68
Prog. Time - weighted (Tt) full & partial load - minutes 3) 113
Full load (Tdry) - minutes 151
Partial load (Tdry½) - minutes 84
weighted (Ct) full & partial load 3) 83
full load (Cdry) 86
partial load (Cdry½) 81
Airborne acoustical noise emissions - dB(A) re 1 pW 69.0
Programme time in minute, for program “Synthetics” full load 65
Partial load for program “Synthetics” N/A
Average condensation efficiency - %
1) The "standard cotton” at full and partial load are the standard programmes to
which the information in the label and the fiche relates. The standard cotton
program is suitable to dry at cupboard level (0%) cotton laundry and is the most
efficient programme in terms of energy consumption. Partial load is half the rated
load.
2) based on 160 drying cycles of the standard cotton programme at full and partial
load, and the consumption of the low-power modes. Actual energy consumption
will depend on how the appliance is used.
3) Weighted average of 3 cycles at full load and 4 cycles at half load.
Regulation 932/2012.
Energy consumption in kWh, for program “Synthetics” full load 1.39
Energy efficiency class on a scale from A+++ (low consumption)
to D (high consumption) B
Duration of the 'left-on mode' for power management system -
minutes 30
Condensation efficiency class on a scale from G (least efficient) to
A (most efficient) B
Product Fiche - Regulation 392/2012.
Brand
HOTPOINT
Model
AQC9 BF7 I1(UK)
Rated capacity of cotton laundry for the "standard cotton
programme" at full load - kg 9.0
Moulded plug
GREEN &
YELLOW
BROWN
BLUE
13 amper fusee
CROSS-BAR
CORD GRIP
Green and Yellow (Earth)
wire to terminal marked
“E”, symbol x, or coloured
green and yellow.
Blue (Neutral) wire to
terminal marked ”N” or
coloured black.
13A ASTA approved fuse
to BS 1362.
Brown (live) wire to
teminal marked “L” or
coloured red.
must be replaced by the manufacturer,
its service agent or similarly qualified
persons in order to avoid a hazard.
(see Assistance). New or longer elec-
tric cords are supplied by authorised
dealers at a supplementary cost.
! The manufacturer denies any
responsibility should any of these rules
not be followed.
! If in doubt about any of the above
consult a qualified electrician.
Preliminary information
Once the tumble dryer is installed, clean the inside of the
drum before operating it and remove any dirt accumulated
during transportation.
Maximum load sizes: kg9

Product specificaties

Merk: Hotpoint
Categorie: Wasdroger
Model: AQC9 BF7 E1 (UK)

Heb je hulp nodig?

Als je hulp nodig hebt met Hotpoint AQC9 BF7 E1 (UK) stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Wasdroger Hotpoint

Hotpoint

Hotpoint EU NTDG92 SK IT Handleiding

2 December 2024
Hotpoint

Hotpoint NT M11 92WK IT Handleiding

2 December 2024
Hotpoint

Hotpoint NT M11 8X3SKY IT Handleiding

2 December 2024
Hotpoint

Hotpoint NTS M11 9X3E IT Handleiding

2 December 2024
Hotpoint

Hotpoint NT M11 82K IT Handleiding

2 December 2024
Hotpoint

Hotpoint NT M11 9X3SKY IT Handleiding

2 December 2024
Hotpoint

Hotpoint NT M11 8X3K IT Handleiding

2 December 2024
Hotpoint

Hotpoint NT M11 82XB IT Handleiding

2 December 2024
Hotpoint

Hotpoint NT M11 9X3E IT Handleiding

16 November 2024
Hotpoint

Hotpoint HTX26EASWWW Handleiding

18 April 2024

Handleiding Wasdroger

Nieuwste handleidingen voor Wasdroger

Svan

Svan SSB800A2DB Handleiding

21 December 2024
Haier

Haier HD100-A3959E-IT Handleiding

20 December 2024
Haier

Haier HD100-A3959RE-IT Handleiding

20 December 2024
Bosch

Bosch WTN832M1NL Handleiding

17 December 2024
Ufesa

Ufesa Pro Ionic-Shine Handleiding

17 December 2024
Ufesa

Ufesa Pro Ionic Style Handleiding

17 December 2024
Altus

Altus ADP80W Handleiding

17 December 2024
BEKO

BEKO B5T69233MG Handleiding

15 December 2024
AEG

AEG T65170AV Handleiding

12 December 2024
Haier

Haier HD90-A3979NU1 Handleiding

10 December 2024