Hoover DMC D1013BC-80 Handleiding

Hoover Wasdroger DMC D1013BC-80

Lees hieronder de 📖 handleiding in het Nederlandse voor Hoover DMC D1013BC-80 (6 pagina's) in de categorie Wasdroger. Deze handleiding was nuttig voor 25 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/6
INSTRUCTION BOOK
INSTRUCTION BOOK
INSTRUCTION BOOK
INSTRUCTION BOOKINSTRUCTION BOOK
English 2
Condenser Tumble Dryer
• Adequate ventilation must be provided in the room where the tumble
dryer is located to prevent gases from appliances burning other fuels,
including open fires, being drawn into the room during operation of the
tumble dryer.
• Installing the rear of the appliance close to a wall or vertical surface.
•There should be a gap of at least 12 mm between the machine and any
obstrubtions.The inlet and outlet should be kept clear of obstruction.To
ensure adequate ventilation the space between the bottom of the
machine and the floor must not be obstructed.
• Check regularly that the air flowing through the dryer is not restricted.
• Check frequently the fluff filter after use, and clean, if necessary.
•Prevent items from falling or collecting behind the dryer as these may
obstruct the air inlet and outlet
• NEVER install the dryer up against curtains.
• In cases where the dryer is installed on top of a washing machine, a
suitable stacking kit must be used according to the follow configuration.
-Stacking kit Mod 35100019: for minimum washing machine depth 49 cm
-Stacking kit Mod 35900120: for minimum washing machine depth 51 cm
The stacking kit shall be one of that above, obtainable from our spare
service.
The stacking kit shall be one of that above, obtainable from our spare
service.
The instructions for installation and any fixing attachments, are provided
with the staking kit.
Ventilation
0 EN6
Do not install the product in a low temperature room or
in a room where there is a risk of frost occurring. At
temperature around freezing point the product may not be
able to operate properly: there is a risk of damage if the
water is allowed to freeze in the hydraulic circuit (valves,
hoses, pumps). For a better product performance the
ambient room temperature must be between +2°C and
+35°C. Please note that operating in cold condition
(between +2 and +15°C) might simply some water
condensation and water drops on floor.
DRAIN HOSE : FITTING INSTRUCTIONS
0 EN8
WARNING! Switch off and remove the
tumble dryer plug from the electricity supply
before carrying out any work.
Fit he s Follows:t Hose a
1.Tilt the machine
backwards.
2. The waste water
pipe is situated at the
left -hand side of the
ma chi ne (see the
picture). A grey hose
connects to the bridge
at the left hand side of
the machine. Using
pliers, remove the pipe
retaining clip from the
bridge.
3. Pull the hose off the
bridge connection.
4. blackAttach the
hose from the kit,
( using the connector
a n d p i p e c l i p s
supplied , to the hose )
rem ove d fro m the
bridge connection.
5 . P la c e t he t ap
supplied by the kit to
close the remain g
hose.
6. Once the machine is
in place the feet should
be adjusted to ensure
that the new hose does
not kink when pushing
the tumble dryer into
position.
7. Connect the new
drain hose to the waste
Water pipe.
8. Connect to the
m a in s e l e c t r i c i t y
supply.
To avoid emptying the water container after
each drying cycle, the water can be
discharged directly to a waste water drain pipe
(the same drainage system as household
sinks). Water Bye-Laws prohibit connection to
a surface water drain. The waste water drain
pipe should be located adjacent to the tumble
dryer.
The kit consists of:1 hose and 1 tap.


Product specificaties

Merk: Hoover
Categorie: Wasdroger
Model: DMC D1013BC-80

Heb je hulp nodig?

Als je hulp nodig hebt met Hoover DMC D1013BC-80 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Wasdroger Hoover

Handleiding Wasdroger

Nieuwste handleidingen voor Wasdroger