Hooker 5351-75310 Handleiding

Hooker Stoel 5351-75310

Lees hieronder de ๐Ÿ“– handleiding in het Nederlandse voor Hooker 5351-75310 (2 pagina's) in de categorie Stoel. Deze handleiding was nuttig voor 24 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/2
1/2
ASSEMBLY INSTRUCTION
Item#: - - 5351 75310 Fretback Side Chair 2 per ctn
** Please make sure you have all parts indicated below prior to assembly.
Assembly Steps:
There are two K/D chairs in one box. Please follow numbers on one chair and letters on the other chair
during assembly.
1. Place chair back (G . ) on a clean surface
2. T ighten seat frame (I) to chair back (G) by using bolt ), lock washer (B) and flat washer (A) at the (C
center location. (see diagram 2) ) to ) ),T , Ihen tighten seat frame ( chair back (G by using bolt s (E
lock washers (B) ). (See diagram 1), flat washers (A
3. Assemble front legs (I)(F) with front corner blocks of seat frame , using 4 bolts ( 4 C), lock washers
(B) and 4 flat washers (A). Tighten all bolts by hand. 2) (See diagram
4. After all bolts are attached and hand tightened, turn the chair upright.
5. Level the chair following the โ€œchair leveling instructionโ€ as below.
6. Make sure the chair is level and then tighten all bolts completely by using allen wrench . (D)
Diagram 2
Diagram 1
2/2
PLEASE READ THESE INSTRUCTIONS PRIOR TO ASSEMBLING THE
CHAIRS
CHAIR LEVELING INSTRUCTION SUPPLEMENT
Chair leveling procedures:
To make the assembly process easy and efficient, please read the entire instruction sheet prior to
assemb of the chair. Make sure all hardwareling listed is included. To properly assemble the chair, none of
the bolts should be fully tightened until all components are attached to the chair. This will allow an
opportunity to level the chair and prevent any unnecessary โ€œrockingโ€.
1. Place the loosely assembled chair on a hard flat surface.
2. Apply gentle downward pressure on the seat. This step eliminates rocking and ensures the chair to
be level.
3. Once the chair is level, tighten all bolts and nuts.
Note:
Most floors have slight irregularities that can affect chair leveling. If your chair is uneven when placed
in its desired location, perform the following steps:
1. Loosen front legs to finger tight.
2. Extend both front legs upward to their fullest length.
3. Gently push downward on the front edge of the seat until all four legs rest on the floor.
4. - Re tighten all bolts and nuts.
Cleaning Instruction: Clean finished parts with a damp cloth using a mild dishwashing liquid and water solution.
Polish the finish with soft cloth and an industry recognized furniture polish.


Product specificaties

Merk: Hooker
Categorie: Stoel
Model: 5351-75310

Heb je hulp nodig?

Als je hulp nodig hebt met Hooker 5351-75310 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Stoel Hooker

Handleiding Stoel

Nieuwste handleidingen voor Stoel