Hooker 1618-75019-DKW Handleiding

Hooker Stoel 1618-75019-DKW

Lees hieronder de đź“– handleiding in het Nederlandse voor Hooker 1618-75019-DKW (2 pagina's) in de categorie Stoel. Deze handleiding was nuttig voor 34 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/2
1/2
ASSEMBLY INSTRUCTION
Item#:1618 75019- - DKW Upholstered Dining Bench
** Please make sure you have all prior to assembly.parts indicated below
Assembly Steps:
Please follow numbers on one chair and letters on the other chair during assembly.
1. Place chair back on a clean surface.
2. T ighten back frame s rail to chair back legs (G) and assemble back legs (G) to the corner block of
seat frame(I) by using 4 bolts ( lock washers (E 4 ), C) and 4 flat washers (D).
3. 4 E 4 CAssemble front legs (F) to corner blocks of seat frame (I), using bolts ( ), lock washers ( ) and
4 flat washers (D ).
4. 4 B 4 CScrew front and back (H) on center leg center using rail bolt ( ), lock washer ( ) and 4 flat
washer (D ).
5. Make sure the chair is level and then tighten all bolts completely by using wrench Allen (A).
6. Turn the chair upright. Level the chair following the “chair leveling instruction” as below.
Diagram 1
2/2
PLEASE READ THESE INSTRUCTIONS PRIOR TO ASSEMBLING THE CHAIRS
CHAIR LEVELING INSTRUCTION SUPPLEMENT
Chair leveling procedures:
To make the assembly process easy and efficient, please read the entire instruction sheet prior to
assembling the chair. Make sure all hardware listed is included. To properly assemble the chair, none of
the bolts should be fully tightened until all components are attached to the chair. This will allow an
opportunity to level the chair and prevent any unnecessary “rocking”.
1. Place the loosely assembled chair on a hard flat surface.
2. Apply gentle downward pressure on the seat. This step eliminates rocking and ensures the chair to
be level.
3. Once the chair is level, tighten all bolts and nuts.
Note:
Most floors have slight irregularities that can affect chair leveling. If your chair is uneven when placed
in its desired location, perform the following steps:
1. Loosen front legs to finger tight.
2. Extend both front legs ward to their fullest length.up
3. Gently push downward on the front edge of the seat until all four legs rest on the floor.
4. -Re tighten all bolts and nuts.
Cleaning Instruction: Clean finished parts with a damp cloth using a mild dishwashing liquid and water solution.
Polish the finish with soft cloth and an industry recognized furniture polish.


Product specificaties

Merk: Hooker
Categorie: Stoel
Model: 1618-75019-DKW

Heb je hulp nodig?

Als je hulp nodig hebt met Hooker 1618-75019-DKW stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Stoel Hooker

Handleiding Stoel

Nieuwste handleidingen voor Stoel