Honeywell HM750APCB Handleiding

Honeywell Luchtbevochtiger HM750APCB

Lees hieronder de 📖 handleiding in het Nederlandse voor Honeywell HM750APCB (60 pagina's) in de categorie Luchtbevochtiger. Deze handleiding was nuttig voor 44 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/60

INSTALLATION INSTRUCTIONS

33-00289EF-05

IMPORTANT

Read and save these instructions. This guide should be kept by the installer.

HM750A1000

ADVANCED ELECTRODE STEAM HUMIDIFIER

INTRODUCTION

The HM750 is the most advanced residential steam

humidifier available and provides steady and reliable

humidification for a home. The humidifier is designed for

connection directly to a supply air duct for humidity on

demand. The humidifier may be directly mounted to the air

duct, or remotely from the air duct, with a steam hose

connecting the humidifier to a distributor nozzle installed

at the air duct.

Included in the Box

— HM750 steam humidifier

— H6062 HumidiPRO

— Steam distributor nozzle

— Rubber drain hose

— LDPE water hose

— Baffle (duct mount only)

— Foam gasket (duct mount only)

— Steam hose (wall mount only)

— Fittings, hardware, and mounting template

— Installation Instructions, 33-00289EF (this document)

— Annual Operation and Maintenance Reminder

Tools Needed

— Flat-head screwdriver

— Phillips screwdriver

— Wrench

— Copper pipe (optional)

— Level

— Hole saw

Humidifier Configuration

The HM750 is configured at the factory to operate under

most conditions without the need to change its

configuration.

NOTE: Because the humidifier is factory configured for

optimal performance, Resideo strongly

discourages changes to the configuration of the

humidifier not described in these instructions.

Before Installation

1. Ensure that available voltage and phase

corresponds with humidifier voltage and phase as

indicated on humidifier’s specification label.

2. Ensure that the dedicated external fuse disconnect

is of sufficient size to handle the rated amps as

indicated on the specification label. Refer to local

codes.

3. Ensure sufficient clearances will be available as

described in the Location section on page 6.

4. If the humidifier will be wall mounted, ensure steam

lines can be routed to duct as described in the Steam

Line Instructions on page 7.

HM750A1000

33-00289EF—05 2

Table 1. Specifications.

Fig. 1. Specification label location.

CAUTION

Servicing

Disconnect main power before any servicing.

• The plumbing and electrical compartments

contain high voltage components and wiring.

Access should be limited to authorized

personnel only.

• During and following operation of the

humidifier, the steam and components in

contact with the steam such as the steam lines,

steam distributors, and condensate lines can

become hot and can burn if touched.

• Resideo does not accept any liability for

installations of humidity equipment installed by

unqualified personnel or the use of

parts/components/equipment that are not

authorized or approved by Resideo.

• To maintain warranty, only Resideo approved

parts and cylinders may be used in the

operation of the product.

CAUTION

Electrical

All electrical work should be done according to

local and national electrical code.

Electrical connection to be performed by a licensed

electrician.

Unit recommended to be powered by a dedicated

GFCI circuit.

CAUTION

Plumbing

Plumbing to be performed by a licensed plumber.

Drain water from humidifier can be very hot. Drain

water to floor drain. Do not drain to public sink.

All plumbing work should be done according to

local plumbing code.

CAUTION

Installation

Do not mount on surfaces hotter than 176 ºF

(80 ºC).

Do not mount in area where freezing can occur.

Do not mount on vibrating surface.

Do not mount on floor.

The HM750 produces steam at atmospheric

pressure. No devices which could block steam

output should be connected to the steam outlet.

Steam lines must be installed so that no restriction

can produce backpressure in the humidifier.

Do not mount outdoors without protection against

rain, snow, condensation or equivalent.

CAUTION

Water quality

The HM750 requires a cold water connection from

your home's main water supply between 15-

100 PSIG. A throttle valve may be necessary, and

a water shut-off valve is recommended for

safety. Reverse Osmosis (RO) and Deionized

(DI) water must not be used. Water conductivity

is important to ensure the electrode humidifier

operates effectively. Resideo recommends

125-1200 μS/cm (microsiemens/cm).

Volts

Steam Output

GPD KW Amps Phase

Max Ext.

Fuse

(Amps)

Standard

Cylinder

Net/Full

Weight

lbs. (kg)

Dimensions

W x H x D

110/120 11 1.5 12 1 15

HM750ACYL

10.5 / 18.5

(4.8 / 8.4)

10 x 18 x 7 in.

254 x 457 x 178 mm

220/240 22 3.0

HM750

Sta tus

Se rvic e

Po w e r

Idl e

Fil l i n g

Hu m i i n gid fy

Drai n i n g

Cyli n d er

Fau l t

Drai n

Fa u

lt C Iode s n Front e rCov

MODEL: HM 750A1000

PHASE: 1 HZ: 60

Country of origin: Canada

Pays d’origine : Cana da

Auto-Adaptive

Profe ssionally se rviced o nly.

Entretien par des prof es sionnels s eulement.

S/N DATECODE

205X

HUMIDIFIER

VOLT 110-120 220-240

AMP 12 12

GPD 11 22

KW 1.5 3.0

M37184A

ODEL : H M 750A

1000

PHAS

E: H Z1: 60

Cou ntry o f

origi

n Ca: na

Pa y

s d’origine

Can ada

to-Adap

ive

rofessiona ll

y servic

ed only.

Entretie

n pa

r des

profess ionn sel seulemen

S / N DAT EC ODE

205

H UM

IDI FI ER

110-120

20-

240

AMP 12

GPD 11

KW 1.5 3. 0

HM750A1000

3 33-00289EF—05

Parts and Accessories

The following parts and accessories are available and may have been included with your HM750 humidifier. The cylinder

is the only item that will need periodic replacement to maintain proper humidifier operation.

Table 2. Parts and accessories.

How the Humidifier Works

The HM750 is an atmospheric steam generator that uses

heat generated by electrical current flowing between

submerged electrodes to generate steam. The HM750 is

designed for on-demand air humidification via a steam

distributor nozzle.

STEAM GENERATION

• Once the humidistat terminals and the air proving

terminals are closed (AP on the control board), the

humidifier closes the power relay and measures the

electrical current.

• If current is lower than full load amperage, after a brief

delay the water fill valve will be activated and water will

flow into the fill cup. Water from the fill cup flows into

the bottom of the cylinder through a hose connected to

the drain valve housing.

NOTE: The cylinder is gravity fed from the fill cup. If

backpressure from the steam line is too high it

will cause water to back up in the fill cup and flow

down the overflow line to the drain.

• As soon as the water in the cylinder comes in contact

with the energized electrodes, current flows through

the water. The resistance of the water to the electrical

current generates heat and in turn steam. The electrical

current (and steam output) increases as the level of

water increases, as more of the electrode becomes

submerged. The unit continues to fill until the current

reaches full load amperage, or the high water sensor

detects a high water level.

• The water level and current draw in the cylinder

decreases from evaporation (through steam

generation).

• If the high water sensor was activated before full load

amperage is achieved, the water will boil down until the

high water sensor is no longer activated. If full load

amperage was achieved, the water will boil down to a

predefined amperage.

• The HM750 repeats the fill and boil down cycle

repeatedly to provide a constant steam output.

• Over time, minerals in the water will adhere to the

cylinder electrodes. The humidifier will automatically

fill to a higher water level to maintain full capacity

during the life of the cylinder. Eventually, because of

scale formation, it will no longer be possible for the

humidifier to reach its full capacity. The HM750

software monitors this condition and, when detected,

will stop operating and the Cylinder LED will be

illuminated.

DRAINS

• As steam is produced, minerals are left behind,

increasing the conductivity of the water. The HM750

auto-adaptive cycle will monitor the water conductivity

and perform drains to maintain the water at optimal

conductivity for peak performance.

• The auto-adaptive cycle ensures cylinder life is

maximized. It does this by keeping the tightest control

and most efficient use of water during the entire

cylinder life.

STEAM DISTRIBUTION

Steam generated by the humidifier may be introduced into

the air in two different ways. The humidifier may be

mounted directly onto the duct, to allow the steam

distributor nozzle to enter into the supply air duct.

Alternatively, the humidifier may be located remotely from

the air supply duct. It may be connected to the distributor

nozzle at the duct using a steam hose.

STEAM LINE

The steam line between the cylinder steam outlet and the

distributor nozzle serves two purposes: it is used as a

conduit to transfer the atmospheric steam from the

humidifier to the distributor nozzle, as well as providing a

means to remove condensate. See “Steam Line

Instructions” on page 7 for information on selecting steam

lines.

Whenever steam is distributed, condensate is formed in

the distribution system. Insulating steam lines is one

important way to reduce the amount of condensate

formed. Steam lines must also be sloped so that

condensate does not collect in the lines and create a

restriction to steam flow. As shown in the Plumbing

section, steam lines should maintain a slope back to the

humidifier of, as a minimum, 4 in. (10 cm) RISE per 12 in.

(30 cm) of RUN.

Part/Accessory Part Number

Replacement Cylinder HM750ACYL

HumidiPRO Humidistat H6062A1000

Drain and Fill Valve Kit HM750AVKIT

Remote and Duct Nozzle Kit HM750ANKIT

Replacement PC Board HM750APCB

15 ft. Steam Hose Kit HM750AHOSEKIT

Differential Pressure Switch for Air Proving 50027910-001

Product specificaties

Merk:	Honeywell
Categorie:	Luchtbevochtiger
Model:	HM750APCB

Heb je hulp nodig?

Als je hulp nodig hebt met Honeywell HM750APCB stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Luchtbevochtiger Honeywell

Honeywell HUT-300 Handleiding

8 November 2023

Honeywell HEV312 Handleiding

8 November 2023

Honeywell HE220 Handleiding

8 November 2023

Honeywell QuietCare HCM-6011i Handleiding

8 November 2023

Honeywell QuietCare HCM-6009 Handleiding

8 November 2023

Honeywell HCM-315 Handleiding

8 November 2023

Honeywell HUT-220 Handleiding

8 November 2023

Honeywell MistMate HUL520 Handleiding

8 November 2023

Honeywell H8908B Handleiding

8 November 2023

Honeywell HUL570 Handleiding

8 November 2023

Handleiding Luchtbevochtiger

Nieuwste handleidingen voor Luchtbevochtiger

Eldom Atma NU40 Handleiding

17 November 2024

Eldom Amar NU50 Handleiding

17 November 2024

Boneco U100 Handleiding

17 November 2024

Brune B 300 Handleiding

17 November 2024

Duux Beam 2 Handleiding

15 November 2024

Medescan WSV0124 Handleiding

6 November 2024

Philips HU1509 Handleiding

7 Oktober 2024

Philips HU5710 Handleiding

7 Oktober 2024

Panduit ACF10 Handleiding

2 Oktober 2024

Panduit ACF11 Handleiding

2 Oktober 2024