Honeywell HHT-013-HD Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Honeywell HHT-013-HD (23 pagina's) in de categorie Luchtreiniger. Deze handleiding was nuttig voor 49 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/23
IMPORTANT SAFETY
INSTRUCTIONS
READ AND SAVE THESE
SAFETY INSTRUCTIONS
BEFORE USING THIS
AIR PURIFIER
When using electrical appliances, basic
precautions should always be followed to
reduce the risk of re, electric shock, and
injury to persons, including the following:
1. Read all instructions before operating the air
purier.
2. Place air purier where it is not easily knocked
over by persons in the household.
3. OFFAlways turn the air purier controls to the
position and unplug from the wall outlet when
not in use.
4. To disconnect the air purier, rst turn the
control to the OFF position, grip the plug and
pull it from the wall outlet when not in use.
Never pull by the cord.
5. Do not use an product with a damaged cordy
or plug or if product malfunctions, is dropped
or damaged in any manner. Keep the cord
away from heated surfaces.
6. Do not use air purier outdoors.
7. Never use air purier unless it is fully
assembled.
8. Do not run power cord under carpets, and do
not cover with throw rugs. Arrange cord such
that it will not be tripped over.
9. Do not use air purier where combustible
gases or vapors are present.
10. Do not expose the air purier to rain, or use
near water in a bathroom, laundry area or
other damp location.
11. The air purier must be used in its upright or
horizontal position only.
12. Do not allow foreign objects to enter ventilation
or exhaust opening as this may cause electric
shock or damage to the air purier. Do not
block air outlets or intakes.
13. Loca voidte air purier near the outlet and a
using an extension cord.
14. This appliance has a polarized plug (one blade
is wider than the other). To reduce the risk of
shock, this plug is intended to t only one way
in a polarized outlet. If the plug does not t
fully in the outlet, reverse the plug. If it still
does not t, contact a qualied electrician.
DO NOT a ture.ttempt to defea this safety feat
15. A loose t between the outlet (receptacAC le)
and plug may cause overheating and a
distortion of the plug. Contact a qualied
electrician to replace loose or worn outlet.
16. Do not sit, stand or place heavy objects on the
air purier.
17. Disconnect power supply before servicing.
18. SAVE THESE INSTRUCTIONS
WARNING: To Reduce The Risk of Fire or
Electric Shock, Do Not Use This Air Purier
With Any Solid-State Speed Control Device.
PET CLEAN AIR™
AIR PURIFIER
Air Purier for Pet Owners
Model HHT-013-HD
The Honeywell trademark is used by Kaz, Inc. under license from Honeywell International Inc.
Honeywell International Inc. makes no representation or warranties with respect to this product.
HHT-013-HD_OM 020810.qxd 2/8/10 2:54 PM Page 1
INSTALL MAIN HEPA-TYPE FILTER
The HEPA-Type Filter is supplied within the air purier.
It is wrapped to ensure purity.
• Unplug the air purier. While pressing on the two
notches along the front grille, pull the grille towards
you and remove it (see Fig. 2).
Gently push down on the top of the lter frame and
pull forward.
• Remove the protective wrap from the HEPA-type lter.
• Place HEPA-type lter back into the air purier
housing, following the directions of the arrows on the
lter cartridge. front lter grille back into place.Snap
HOW YOUR AIR PURIFIER WORKS
This model air purier incorporates a 3-stage cleaning
system to help clean the air that passes through the
lter in the unit (Fig. 1).
Stage 1: Odor Absorbing Pre-Filter
Stage 2: 95% HEPA-Type Filter
Stage 3: Electronic Ionizer (optional on/o)
Dirty
Room Air In
HEPA-type Filter
*
Optional on/o
Ionizer Field
Odor Absorbing
Pre-Filter
3-Stage Filter System
Cleaner Air
Out
Fig. 1
Fig. 2
SET-UP
• Select a rm, level and at location. For best airow, locate the unit at least 3 feet (1 M) from
any wall.
• When operating, large volumes of air are drawn toward the air purier. Surrounding areas should be
cleaned and/or vacuumed frequently to prevent build-up of dust and other contaminates. This may help
prolong the life of the lter. If the unit is placed on a light colored carpet, a small mat or rug should be
used underneath to prevent permanent staining. This is especially important in homes with
contamination from smoking or replaces.
HHT-013-HD_OM 020810.qxd 2/8/10 2:54 PM Page 2
OPERATION
• Ensure the air purier is plugged into a working electrical outlet and the Power Knob and Ionizer Knob
are OFF (pointed to location marked (O).
• Turn the Power Knob to the High (III) position for several minutes and then rotate the Power Knob to the
desired cleaning level ( I = Low, II = Medium, III = High).
It is recommended you run your air purier 24 hours a day to ensure continuous cleaning.
Portable air puriers are more eective in rooms where all doors and windows are closed.
IONIZER FEATURE
The Ionizer helps boost the performance of the
air purier.
• Turn the Ionizer Control Knob to the ON ( I ) (see
Fig. 3) position. This will power the Ionizer on. To
turn the Ionizer feature o, simply turn the knob
to the OFF (O) position.
NOTE: If you have asthma symptoms or other
breathing disorders that can be triggered by the
presence of an ionizer, we recommend that you
do not activate the ionization feature.
NIGHTLIGHT FEATURE
The nightlight provides soft illumination.
• To turn the night light on, press the nightlight button (see Fig. 3).
• To turn it o, press the nightlight button again.
ELECTRONIC FILTER CLEAN REMINDER
This model air purier has an electronic lter check
to remind you when to replace the HEPA-Type lter
based on the air purier’s hours of use.
A red LED light will illuminate when it is time to
check the lter.
You should periodically check the lter. Depending
on operating conditions, the Filter should be
replaced every 6 months for best performance.
REPLACE WITH HEPA-TYPE FILTER P
TO RESET THE ELECTRONIC FILTER CHECK:
When the lter monitor light remains on, it is time to check the HEPA-Type lter and reset the lter
monitor, if needed. With the unit powered on, insert the tip of a ball-point pen or paperclip next to the LED
lter check light and hold for approximately 5 seconds until the light turns o (see Fig. 4). Depending upon
your individual usage (environment and hours used), you may need to replace the lter more or less
frequently. Each time you replace your lter, you should re-set the lter monitor reset button.
Fig. 3
Ionizer Control
Knob
Power/Speed
Knob
Nightlight
Button
Fig. 4
Filter Monitor
Reset Light
HHT-013-HD_OM 020810.qxd 2/8/10 2:54 PM Page 3


Product specificaties

Merk: Honeywell
Categorie: Luchtreiniger
Model: HHT-013-HD

Heb je hulp nodig?

Als je hulp nodig hebt met Honeywell HHT-013-HD stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Luchtreiniger Honeywell

Handleiding Luchtreiniger

Nieuwste handleidingen voor Luchtreiniger