Honeywell HCE311 Handleiding

Honeywell Kachel HCE311

Lees hieronder de 📖 handleiding in het Nederlandse voor Honeywell HCE311 (21 pagina's) in de categorie Kachel. Deze handleiding was nuttig voor 70 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/21
IMPORTANT SAFETY
INSTRUCTIONS
WARNINGREAD AND SAVE THESE OPERATING
AND SAFETY INSTRUCTIONS BEFORE USING THIS
HEATER. IF YOU DO NOT UNDERSTAND THESE
INSTRUCTIONS OR PRODUCT LABELS PLEASE
CALL OUR CUSTOMER REPRESENTATIVES AT
(800) 477-0457 FOR ASSISTANCE BEFORE USING
THIS PRODUCT.
WarningFailure to follow any of these safety
instructions could result in fire, injury, or death.
YOUR RESPONSIBILITIES
Electrical appliances may expose people to hazards
that can cause severe injury as well as death.
The use of electrical products may create hazards
that include, but are not limited to, injury, fire,
electric shock and electrical system damage. These
instructions are intended to provide you with the
information you need to use the product correctly
and to avoid such hazards.
When using electrical appliances, basic
precautions should always be followed to
reduce risk of fire, electric shock, and injury
to persons including the following:
1. WarningRead all instructions before using
this heater.
2. WarningThis heater is hot when in use.
To avoid burns, DO NOT let bare skin touch
hot surfaces. Use handles when moving this
heater. Keep combustible materials, such as
furniture, pillows, bedding, papers, clothes,
and curtains at least 3 feet (0.9 m) from the
front of the heater and keep them away from
all sides of the heater.
3. WarningExtreme caution is necessary
when any heater is used by or near children
or invalids, and whenever the heater is left
operating and unattended.
4. WarningALWAYS unplug heater when not
in use.
5. WarningDO NOT operate any heater with
a damaged cord or plug, any heater that
malfunctions, or any heater that has been
dropped or damaged in any manner. Discard
heater or return heater to authorized service
facility for examination and/or repair.
6. WarningFor residential use only.
7. WarningDO NOT use outdoors.
8. WarningThis heater is not intended for use
in bathrooms, laundry areas, and similar indoor
locations. DO NOT locate heater where it may
fall into a bathtub or other water container.
9. WarningDO NOT run cord under carpeting.
DO NOT cover cord with throw rugs, runners,
or similar coverings. DO NOT route cord under
furniture or appliances. Arrange cord away
from traffic areas and where it will not be a
tripping hazard.
CeramiC Tower HeaTer
HCe300 SerieS
Honeywell is a trademark of Honeywell International Inc., used under license by Helen of Troy Limited.
Honeywell International Inc., makes no representation or warranties with respect to this product.
2
ABOUT CERAMIC TECHNOLOGY
10. Warning – This appliance has a polarized plug
(one blade is wider than the other). To reduce
the risk of electric shock, this plug is intended
to fit in a polarized outlet only one way. If the
plug does not fit fully in the outlet, reverse the
plug. If it still does not fit, contact a qualified
electrician. DO NOT attempt to defeat this
safety feature.
11. WarningThis heater draws 12.5 amps
during operation. To prevent overloading a
circuit, DO NOT plug the heater into a circuit
that already has other appliances working.
12. WarningIt is normal for the plug to feel
warm to the touch; however, a loose fit
between the AC outlet (receptacle) and plug
may cause overheating and distortion of the
plug. Contact a qualified electrician to replace
loose or worn outlet.
13. WarningTo disconnect the heater, first turn
off the product, then grip the plug body and
pull it from the wall outlet. DO NOT pull by the
cord.
14. WarningDO NOT insert or allow foreign
objects to enter any ventilation or exhaust
opening as this may cause electric shock,
fire, or damage to the heater.
15. WarningTo prevent a possible fire, DO NOT
block air intakes or exhaust in any manner.
DO NOT use on soft surfaces, like a bed, or
where openings may become blocked.
16. WarningA heater has hot and arcing or
sparking parts inside. DO NOT use it in areas
where gasoline, paint or flammable liquids are
used or stored.
17. WarningUse this heater only as described in
this manual. Any other use not recommended
by the manufacturer may cause fire, electric
shock, or injury to persons.
18. WarningALWAYS plug heater directly into
a wall outlet/receptacle. DO NOT use with an
extension cord or relocatable power tap
(outlet/power strip).
19. WarningNEVER tamper with this product
or attempt to fix it. Any tampering with, or
modification of this product can result in
serious injury, death, or fire. DO NOT open.
Risk of electric shock. There are no user
serviceable parts inside.
20. WarningDO NOT remove product labels
that contain warnings or safety instruction.
21. CautionThe output of this heater may vary
and its temperature may become intense
enough to burn exposed skin. Use of this
heater is not recommended for persons with
reduced sensitivity to heat or an inability to
react to avoid burns.
22. CautionBefore cleaning, or storage, or when
not in use, turn the product’s controls to the
OFF position and unplug the heater from the
electrical outlet and allow to cool.
23. CautionPlace the heater on a firm, level,
open surface free from obstructions and at
least 3 feet (0.9 m) away from any combustible
materials. DO NOT use on an unstable surface
such as bedding or deep carpeting. Be sure
the heater is not in a position where it may be
tripped over by small children or pets.
24. CautionIf your home has aluminum
wiring have a licensed electrician check your
receptacle’s connections. When using a 1500
watt heater, aluminum wire connections can
cause a safety issue.
25. SAVE THESE
INSTRUCTIONS
Ceramic heaters generate heat by passing electricity through heating wires embedded in ceramic plates.
In the Honeywell Ceramic Tower Heater, air is drawn into the back of the heater by a fan, through the ceramic element and out
the front of the heater to gently introduce warm air into the room.
This type of heating technology provides consistent, even heating.
For best results, place heater on the oor and allow heater to run for 5-10 minutes to reach maximum heat output.
3
SET UP
MOVING THE HEATER
The Honeywell Ceramic Tower Heater requires no assembly. Simply unpack heater and save all packaging materials for o-
season storage.
Place the heater on a rm, level, open surface free from obstructions and at least 3 feet (0.9m) away from any wall or
combustible material.
DO NOT use on an unstable surface such as bedding or deep carpeting.
BE SURE THE HEATER IS NOT IN A POSITION WHERE IT MAY BE TRIPPED OVER BY CHILDREN OR PETS.
This heater is equipped with a Cool Touch handle for your convenience.
Turn o the heater.
Allow it to cool for ten minutes.
Unplug heater and move.
OPERATION
NOTE: NEVER LEAVE AN OPERATING UNIT UNATTENDED
With heater in the OFF position ( ), plug the heater into
a polarized 120V outlet. DO NOT FORCE THE POLARIZED
PLUG INTO THE OUTLET; it will only t one way.
With 80° oscillation, the Honeywell Ceramic Tower Heater
is versatile and designed to be placed in the center of the
room or closer to the wall (at least 3 feet way) for maximum
convection room heating.
Turn heater on by pressing the Power Button ( ).The Power
Indicator will illuminate and the heater will start in the
Constant On HI Level Setting ( ).
The heater has two operational modes – continuous heating
or heating with a thermostat setting where the heater cycles
on and o according to the selected temperature setting.
To set a Continuous Heat Setting, press ( ): - Choose Low ( ) to use 900 watts of power (750 watts on the HCE317 Series only)
- Choose High ( ) to use 1500 watts of power
NOTE: Because the Low setting does not require as much electricity to operate, it is more energy ecient and may be a better
option if you are concerned about saving energy.
In the continuous heat mode, make sure to manually turn the heater OFF when done using this appliance.
To set the Thermostat, press the Thermostat Control Buttons ( ) and choose your Desired Temperature. The Desired
Temperature will ash ve times and then the Current Temperature in the room will display as a steady red. On the HCE305/HCE309
unit models only, there are 4 pre-set comfort settings from which to choose: 65°, 70°, 75°, 80°. These are your desired
room temperature settings.
NOTE: If the Current Temperature is higher than your Desired Temperature, the heater will be o until the room temperature falls
below this setting or until the Desired Temperature is changed.
Press the Timer Button ( ) to select 1, 2, 4, or 8 hour setting. The heater will run for that chosen period in the selected mode,
counting down the hours and automatically shutting the heater o after the selected time has passed.
If unit has an oscillation feature, press the Oscillate Button ( ) to turn on or o the oscillation function.
To shut the heater o, press the Power Button ( ) and the heater will begin Powering Down. The heater will shut o after counting
down 6 seconds in the Temperature Display to cool down the internal components.
It is important to allow the heater to run through the cool down phase. DO NOT unplug the heater until it has completed the cool
down cycle.
Oscillate Button
Fig. 1
Power
Button
Timer
Thermostat
Control Buttons
Current Temperature/
Desired Temperature Display
Heat Level Settings
Power
Indicator
Note: Controls/features will vary slightly by model


Product specificaties

Merk: Honeywell
Categorie: Kachel
Model: HCE311

Heb je hulp nodig?

Als je hulp nodig hebt met Honeywell HCE311 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Kachel Honeywell

Handleiding Kachel

Nieuwste handleidingen voor Kachel