Hitachi CV-S890 Handleiding

Hitachi Stofzuiger CV-S890

Lees hieronder de 📖 handleiding in het Nederlandse voor Hitachi CV-S890 (10 pagina's) in de categorie Stofzuiger. Deze handleiding was nuttig voor 48 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF
Pagina 1/10
CV-S880/CV-S890/CV-T885
INSTRUCTION MANUAL Vacuum Cleaner
РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ Пылесос
J1861_COVER 11/11/03, 10:57 AM1
English
ACCESSORIES (Fig.1)
A Flexible crush proof hose
B Extension pipe
C Curved joint pipe
D Joint pipe
E Cloth bag
F Dusting brush (stored in tool
G Crevice nozzle storage space)
H Rug and floor tool (for CV-S880, CV-T885)
I Rug and floor tool (for CV-S890)
J Rug and floor tool (Y31)
K Rug and floor tool (D321-D)
HOW TO OPERATE
TO ASSEMBLE HOSE (Fig. 2)
The hose and joint pipe are packaged separately. To put them together,
insert the curved joint pipe and joint pipe into each end of the
hose until the claws of the stopper rings click into the holes
of the curved joint pipe and joint pipe.
TO ATTACH HOSE (Fig. 3)
Insert the joint pipe into the suction inlet of the cleaner. When you
remove the hose , pull the joint pipe while pressing the button .
TO ATTACH EXTENSION PIPES (Fig. 4)
Fit the extension pipes , and the selected suction attachment by
twisting together.
TO DETACH EXTENSION PIPES (Fig. 5)
Twist and pull the extension pipe , upward.
RUG AND FLOOR TOOL (Fig. 6) (for CV-S890)
To clean smooth surfaces, depress the switch " " to in line with
" " . To clean rugs or carpets depress the switch " " to in line
with " " .
RUG AND FLOOR TOOL (Fig. 21)
The tool is fitted with a brush at the back which can either be used in
the “withdrawn” or “projected” position. These positions are operated
by the pedal on the tool marked " " (Carpet) and " " (Floor)
For cleaning rug or carpet, keep the brush in its “withdrawn”
position, i.e., with the pedal marked " " pressed down with your
toe. If you feel the tool is heavy to slide on the carpet, please reduce
the suction power by adjusting the suction control. (Fig. 9)
ON-OFF SWITCH (Fig. 7)
Turn cleaner on or off by pushing downward on the power switch .
ELECTRONIC POWER CONTROL (for CV-S890, Fig. 8)
Suction power may be regulated electronically using the dial on the
unit . For stronger suction (thick carpets or hard floors) rotate the
dial to the right. Rotate it to the left for reduced suction (curtains,
delicate fabrics).
SUCTION CONTROL (Fig. 9)
Suction pressure is reduced by moving the adjustment ring on the
curved joint pipe to expose a hole.
The more hole area exposed the lower the suction.
Low suction pressure is recommended for cleaning curtains, blinds,
delicate fabrics etc,.
BAG FULL INDICATOR (Fig. 10)
When the orange sign appears in the large window continuously,
change the cloth bag.
Check the bag full indicator (with the highest power of electronic power
control for CV-S890) by lifting cleaning head from the surface being
cleaned or removing the crevice nozzle when it has been used.
NOTE: If the cleaner is used in such a condition as the orange sign
appears in the large window, air to the motor will be reduced
and the motor will eventually burn out.
AUTOMATIC CORD REWIND (Fig. 11)
The power cord is stored neatly inside the cleaner using an automatic
cord rewind.
When cleaning is completed unplug from the mains and depress the
rewind pedal , the cord will automatically rewind.
NOTE: Should the cord not fully rewind, pull out a short length and
press the pedal again.
For smooth rewinding, turn the cord inlet toward the same direction
as the cord pulled out.
TOOL STORAGE SPACE (Fig. 12)
The crevice and brush tools snap into the rear storage rack for
safekeeping and easy access.
TO USE ATTACHMENTS (Fig. 13,14)
TO STORE ACCESSORIES (Fig. 15)
Hose, extension pipe and rug and floor tool can be attached in
assembled condition to the cleaner by using the nozzle hook of
the rug and floor tool.
This combination allows you a space storage.
1. Place the cleaner upright.
2. Slide the nozzle hook of the rug and floor tool into the hook
supporter at the rear of the cleaner as shown in Fig. 15.
3. Turn the hose around pipes to make it compact and stable.
NOTE:
Do not hold the hose and the joint pipe to transport the cleaner.
TO DISCONNECT CURVED JOINT PIPE (Fig. 16)
Blockages may be cleared by separating the curved joint pipe
from the hose. To separate the curved joint pipe depress the two
claws which are located in the holes on both sides of curved joint
pipe and pull apart.
When needed, the hose collar can be removed from the hose end
by turning it (left-handed screw).
To re-connect push hose back into curved joint pipe and twist until
two claws locate with holes .
Likewise you can disconnect the hose joint on the other end of the hose.
HOW TO REMOVE DUST
TAKING OUT DUST BAG (Fig. 17)
1. Remove the plug from the electrical outlet. Open the bag
compartment lid by pulling up the clamp .
2. Pull out the dust bag gently.
3. Slide off the bag clip from the dust bag and dispose of dust in the
dust bag.
SETTING DUST BAG (Fig. 18)
1. Before setting the dust bag, be sure to slide back the bag clip.
2. Place the dust bag by opening its inner lid .
3. Position the top edges of the collar to the inner lid concave, and
fit the hole at the lower edge to the guide pins of the case.
NOTE
To avoid using the cleaner without the cloth bag, the clamp system of
your cleaner prevents the bag compartment lid from being clamped
when the cloth bag has not been replaced, or has not been set properly
in place.
CARE OF AIR FILTERS
MOTOR PROTECTION AIR FILTER (Fig. 19)
Once or twice a year, or when it becomes visibly soiled, the motor
protection filter located behind the cloth bag may need cleaning.
1. Take out the cloth bag, then remove the filter from the cleaner as
shown in Fig. 19 and wash in warm water.
2. After washing the filter, dry thoroughly away from direct sunlight
and fit back into the cleaner.
5
1
J1861_CV-S880(E) 15/07/2004, 4:07 PM2
NOTE: If the air filter is used when wet, suction is impaired and the
motor may be damaged.
HYGIENIC AIR FILTER (for CV-S890, Fig. 20)
Periodically check the condition of the exhaust air filter. To replace it:
1. Remove the bag compartment lid .
2. Pull out the filter by its top tab and discard it .
3. Push in a new filter .
4. Close the bag compartment lid .
HOW TO MAINTAIN CLEANING
EFFICIENCY AND AVOID ACCIDENTS
●The plug of the power supply cord should be removed from the
socket outlet before cleaning the appliance or under-taking
maintenance operations.
●If the supply cord is damaged, it must be replaced by the
manufacturer or its service agent or a similarly qualified person in
order to avoid a hazard.
●Be sure to replace a new cloth bag after disposing of the full one.
There is a device which prevents the bag compartment lid from
being closed when the cloth bag has not been replaced. Do not
tamper with this to use without bags as dust will be sucked directly
into the mechanical parts and may damage the motor.
●Do not use the cleaner to pick up wet dirt, and avoid using the
cleaner in a wet and moist place as moisture may damage the
motor and other mechanical parts.
●Do not pick up sharp objects, eg. nails, to prevent damage to the
vacuum cleaner.
●Do not block the air flow.
Any blockages or obstructions to the suction inlet, rug-and-floor
tool, extension pipe, hose, etc. or the exhaust air outlet can cause
loss of power and motor overheating.
●Do not pick up matches, fireplace ashes, or smoking material
with cleaner, as a possible fire hazard may result.
●To clean the cleaner body and attachments, wipe them with a
soapsuds-soaked cloth, and avoid using spirits.
●Avoid cleaning the switch part with a wet cloth and splashing water
on it as moisture may cause a short circuit.
●The carbon brushes of the motor are of special composition.
When replacing the defaced carbon brushes, it is necessary to
use the Hitachi special carbon brushes for the Hitachi Vacuum
Cleaner.
●Your vacuum cleaner is not a toy. Do not allow children to play
with the cleaner. Do not leave cleaner connected to an electrical
outlet and leave it unattended.
●Warning; Electric shock could occur if used outdoors or on wet
surfaces.
This product conforms with the protection requirements of
council directives 89/336/ECC relating to electromagnetic
compatibility and 73/23/ECC relating to electrical equipment
designed for use within certain voltage limits.
2
J1861_CV-S880(E) 15/07/2004, 4:07 PM3

Product specificaties

Merk: Hitachi
Categorie: Stofzuiger
Model: CV-S890

Heb je hulp nodig?

Als je hulp nodig hebt met Hitachi CV-S890 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Stofzuiger Hitachi

Hitachi

Hitachi CV-400PRO Handleiding

21 Februari 2024
Hitachi

Hitachi WDE 1200 Handleiding

25 Januari 2023
Hitachi

Hitachi CV950BJ Handleiding

16 Juni 2023
Hitachi

Hitachi CV-SC220V Handleiding

10 Juni 2023
Hitachi

Hitachi PV-XD200 Handleiding

31 Mei 2023
Hitachi

Hitachi PV-XE90 Handleiding

26 Mei 2023
Hitachi

Hitachi R 7D Handleiding

25 Mei 2023
Hitachi

Hitachi CV-SE22V Handleiding

22 Mei 2023
Hitachi

Hitachi R 18DSL Handleiding

22 Mei 2023
Hitachi

Hitachi CV-82D BS RE Handleiding

13 Mei 2023

Handleiding Stofzuiger

Nieuwste handleidingen voor Stofzuiger

Hanseatic

Hanseatic VC-T4020ES-2 Handleiding

3 December 2024
Taurus

Taurus Iconic Digital Advance Handleiding

2 December 2024
Taurus

Taurus Inedit 29.6 Wash Handleiding

2 December 2024
Ecovacs

Ecovacs Deebot U3 Handleiding

2 December 2024
Shark

Shark Wandvac WV362BLUKT Handleiding

1 December 2024
Sencor

Sencor SVC 0741YL Handleiding

1 December 2024
Sencor

Sencor SRV 9150WH Handleiding

1 December 2024
Sencor

Sencor SVC 8725GD Handleiding

1 December 2024
Sencor

Sencor SVC 682VT Handleiding

1 December 2024
Sencor

Sencor SVC 7822TQ Handleiding

1 December 2024