Hanwha TNU-6320 Handleiding

Hanwha Bewakingscamera TNU-6320

Lees hieronder de 📖 handleiding in het Nederlandse voor Hanwha TNU-6320 (67 pagina's) in de categorie Bewakingscamera. Deze handleiding was nuttig voor 18 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/67

NETWORK CAMERA

User Manual

TNU-6320

Trademark

Each of trademarks herein is registered. The name of this product and other trademarks mentioned in this manual are the registered trademark of their

respective company.

Restriction

Copyright of this document is reserved. Under no circumstances, this document shall be reproduced, distributed or changed, partially or wholly, without

formal authorization.

Disclaimer

Hanwha Techwin makes the best to verify the integrity and correctness of the contents in this document, but no formal guarantee shall be

provided. Use of this document and the subsequent results shall be entirely on the user’s own responsibility. Hanwha Techwin reserves the

right to change the contents of this document without prior notice.

Design and speciﬁcations are subject to change without prior notice.

The initial administrator ID is “admin” and the password should be set when logging in for the ﬁrst time.

Please change your password every three months to safely protect personal information and to prevent the damage of the information

theft.

Please, take note that it’s a user’s responsibility for the security and any other problems caused by mismanaging a password.

Network Camera

User Manual

English _3

●●OvERviEW

iMpORTANT SAfETy iNSTRuCTiONS

1. Before installation, read all manuals thoroughly and proceed with the installation according to

the directions.

2. When connecting a power cable or signal line, check the external connection port ﬁrst.

Incorrectly connecting the power supply may cause ﬁre, electric shock or damage to the

product.

3. If you notice any unusual smells or smoke coming from the unit, stop using the product.

If this occurs, immediately disconnect the power source and contact the service center.

Continued use may cause ﬁre or electrical shock.

4. Do not disassemble while the power is on.

5. Before the power is supplied, conﬁrm that all power cords have been properly connected.

An insecure connection may result in ﬁre.

6. If the system has been in a high or low temperature environment, you may be injured by high

heat or low chill of the surface.

7. Before turning the power on, conﬁrm that the power supply supports 24Vac/6A 50/60Hz.

Power in excess of the rated voltage may cause a ﬁre.

8. Lightning or thunder may cause damage to the device.

When installing the product, consider taking measures that will minimize damage to the

product in the event of lightning.

9. When the system is installed, it should be tightly anchored on a ﬂoor that can suﬃciently

sustain its weight against any strong wind.

The ﬁxing method and material used must be able to sustain at least 4 times the system’s

weight.

10. Since the system is remotely controlled and sometimes changes its position, it should be so

carefully installed that it does not create any harmful environment, i.e., its moving part does

not injure people.

11. Do not attach anything to the system.

12. When installing in a dangerous environment, remove the equipment from the power supply

to reduce the possibility of ignition.

13. Do not install near a heater or motor.

Install the system in a place with good ventilation.

14. You can receive installation support from engineers who are qualiﬁed to handle technical

services.

15. Do not install the product in a location that is humid, or where the product will be exposed

to dust or soot.

16. Do not drop objects on the product, or apply strong impact to it.

Keep away from locations where there is excessive vibration or magnetic interference.

17. Do not install in an operating environment with extreme temperatures.

The camera will operate at temperatures of -40°C or higher.

18. Keep out of direct sunlight, and away from heat radiation sources.

19. If you want to relocate a product that has already been installed, be sure to turn oﬀ the

power and then move or reinstall it.

Failure to turn oﬀ the power may result in ﬁre or electric shock.

20. Install the product in a location with good ventilation.

When connecting a power cable or signal line, check the external connection port ﬁrst.

21. The rubber part of the camera wiper is expendable. Replace with a new one if performance

is degraded.

22. Before cleaning the system, disconnect it from the power supply.

CAuTiON

RiSK Of ELECTRiC SHOCK.

DO NOT OpEN

CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK.

DO NOT REMOVE COVER (OR BACK).

NO USER SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

overview

Product specificaties

Merk:	Hanwha
Categorie:	Bewakingscamera
Model:	TNU-6320
Kleur van het product:	Wit
Gewicht:	14000 g
Breedte:	219 mm
Diepte:	528 mm
Hoogte:	460 mm
Soort:	IP-beveiligingscamera
Materiaal behuizing:	Aluminium
Internationale veiligheidscode (IP):	IP66
Ondersteund audioformaat:	ADPCM, G.711, G.726
Ondersteunde videoformaten:	AVC, H.264, M-JPEG, MPEG4
Vormfactor:	Doos
Automatisch scherpstellen:	Ja
Connectiviteitstechnologie:	Bedraad
Ethernet LAN:	Ja
Maximum resolutie:	1920 x 1080 Pixels
Totaal aantal megapixels:	2.38 MP
Type stroombron:	AC
Minimale belichting:	0.03 Lux
Aantal cameras:	1
Geïntegreerde geheugenkaartlezer:	Ja
Compatibele geheugenkaarten:	SD, SDHC, SDXC
Nachtvisie:	Nee
Video bewegings-detectie:	Ja
Audiosysteem:	2-weg
Zoomcapaciteit:	Ja
Aantal Ethernet LAN (RJ-45)-poorten:	1
Focus:	Handmatig
Brandpuntbereik:	4.44 - 142.6 mm
Vermogensverbruik (max):	100 W
Certificering:	UL, KC-SDOC, (FCC, CE, VCCI, RCM, KC
Omvang optische sensor:	1/2.8 "
Beeldstabilisator:	Ja
Type beeldsensor:	CMOS
Digitale zoom:	16 x
Optische zoom:	32 x
Camera sluitertijd:	2 - 1/12000 s
Witbalans:	ATW, AWC, Indoor, Manual, Mercury lamp, Outdoor
Type camerasluiter:	Elektronisch
Ondersteunde grafische resoluties:	320 x 180,320 x 240,640 x 360,640 x 480 (VGA),720 x 576,800 x 450,800 x 600 (SVGA),1024 x 768 (XGA),1280 x 1024 (SXGA),1280 x 720 (HD 720),1280 x 960,1920 x 1080 (HD 1080)
Webbrowser:	Ja
Ruisonderdrukking:	Ja
Ondersteunt Windows:	Windows 7, Windows 8
Aantal gebruikers:	10 gebruiker(s)
Temperatuur bij opslag:	-45 - 60 °C
Maximaal 30 frames per seconde:	60 fps
Ondersteunde netwerkprotocollen:	TCP/IP, UDP/IP, RTP (UDP), RTP (TCP), RTCP, RTSP, NTP, HTTP, HTTPS, SSL/TLS, DHCP, PPPoE, FTP, SMTP, ICMP, IGMP, SNMPv1/v2c/v3 (MIB-2), ARP, DNS, DDNS, QoS, UPnP, Bonjour
Ondersteunt Mac-besturingssysteem:	Mac OS X 10.7 Lion
Luchtvochtigheid bij opslag:	0 - 90 procent
IP-adresfilter:	Ja
Progressive scan:	Ja
Composiet video-uitgang:	1
Ethernet interface type:	Fast Ethernet
Signaal/ruis-verhouding:	50 dB
Quality of Service (QoS):	Ja
Sample rate:	8 kHz
Dichtstbijzijnde focus afstand:	1.5 m
Pan bereik:	0 - 360 °
Dag/nacht modus:	Ja
Aantal lenzen:	1
Maximum aperture number:	4.4
Minimum aperture number:	1.6
Controle camerapanning:	Ja
Kantelfunctie camera:	Ja
Draai-snelheid:	40 °/sec
Pan snelheid:	120 °/sec
Methode voor streaming:	Multicast, Unicast
Aantal sensoren:	1
Videostreaming:	Ja
Achtergrondverlichting compensatie:	Ja
Aantal effectieve pixels (H x V):	1944 x 1104 Pixels
Op afstand bekijken:	Ja
Bitratecontrole:	Constant Bit Rate (CBR), Variable Bit Rate (VBR)
Wide Dynamic Range (WDR):	Ja
AC-ingangsspanning:	24 V
Stroomverbruik (typisch):	25 W
Bedrijfstemperatuur (T-T):	-40 - 55 °C
Relatieve vochtigheid in bedrijf (V-V):	0 - 90 procent
Bereik kantelhoek:	-90 - 40 °
Systeemfuncties intelligente videobewaking (IVS):	Gezichtsherkenning
Mistbestendig:	Ja
Kijkhoek lens, horizontaal:	62.8 °
Type waarschuwingsnotificatie:	E-mail
Ruisonderdrukkingstechnologie:	3D-ruisonderdrukking
Anti-flikkering:	Ja
Kijkhoek lens, verticaal:	36.8 °
Actieve ombevoegde demontage alarm:	Ja
Tekstoverlay:	Ja
Audio detectie:	Ja