Hanwha HCP-6230 Handleiding

Hanwha Bewakingscamera HCP-6230

Lees hieronder de 📖 handleiding in het Nederlandse voor Hanwha HCP-6230 (93 pagina's) in de categorie Bewakingscamera. Deze handleiding was nuttig voor 22 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/93

HCP-6230/HCP-6230H

AHD SPEED DOME CAMERA

User Manual

Trademark

Each of trad arks hereem in is registered The me o. na f thi product and other trads emarks mentioned in this manual are the registered

trademark of their respective company.

Restrict nio

Copyright of this document is reserved. Under n rcumstances this documento ci , shall be reproduced, distributed or ed, partiall or chang y

w llyho , with t for l auth ization. ou ma or

Disclaimer

Hanwha Techwin kes the best to verify the ntegrity anma i d correctness o th content thif e s in s document, but no for l g rantee ma ua

shall be provided. Use o this document and the subsequent resultf s shall be entirely on the user’s own respo ib ity. ns il

Hanwha Techwin reserves the right to change the contents of this document with t prior notice.ou



AHD SPEED DOME CAMERA

User Manual

English - 3

●safety information

safety information

CAUTION

RISK OF ELECTRIC SHOCK.

DO NOT OPEN

CAUTION:

TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK) NO USER

SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

This symbol indicates that dangerous voltage consisting a risk of electric shock is present within

this unit.

This symbol indicates that there are important operating and maintenance instructions in the

literature accompanying this unit.

WARNING

•To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture.

•To prevent injury, this apparatus must be securely attached to the floor/wall in accordance with the installation instructions.

- Do NOT use power sources other than Class 2 power source.

- REPLACE WITH SAME TYPE 250V T3.15AL FUSE(F1)

WARNING

1. Be sure to use only the standard adapter that is specified in the specification sheet.

Using any other adapter could cause fire, electrical shock, or damage to the product.

2. Incorrectly connecting the power supply or replacing battery may cause explosion, fire, electric shock, or

damage to the product.

3. Do not connect multiple cameras to a single adapter. Exceeding the capacity may cause abnormal heat

generation or fire.

4. Securely plug the power cord into the power receptacle. Insecure connection may cause fire.

5. When installing the camera, fasten it securely and firmly. The fall of camera may cause personal injury.

6. Do not place conductive objects (e.g. screwdrivers, coins, metal parts, etc.) or containers filled with water

on top of the camera. Doing so may cause personal injury due to fire, electric shock, or falling objects.

7. Do not install the unit in humid, dusty, or sooty locations. Doing so may cause fire or electric shock.

8. If any unusual smells or smoke come from the unit, stop using the product. In such case, immediately

disconnect the power source and contact the service center. Continued use in such a condition may cause

fire or electric shock.

If this product fails to operate normally, contact the nearest service center. Never disassemble or modify this product

in any way. (Hanwha Techwin is not liable for problems caused by unauthorized modifications or attempted repair.

10.When cleaning, do not spray water directly onto parts of the product. Doing so may cause fire or electric

shock.

CAUTION - Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.

CAUTION

1. Do not drop objects on the product or apply strong blows to it. Keep away from a location subject to

excessive vibration or magnetic interference.

2. Do not install in a location subject to high temperature (over 55°C), low temperature (below -50°C), or high

humidity. Doing so may cause fire or electric shock.

If you want to relocate the already installed product, be sure to turn off the power and then move or reinstall it.

4. Remove the power plug from the outlet when there is a lighting storm. Neglecting to do so may cause fire

or damage to the product.

Product specificaties

Merk:	Hanwha
Categorie:	Bewakingscamera
Model:	HCP-6230
Kleur van het product:	Ivoor
Gewicht:	2200 g
Hoogte:	218 mm
Soort:	CCTV-bewakingscamera
Materiaal behuizing:	Metal, Plastic
Bluetooth:	Nee
Vormfactor:	Dome
Automatisch scherpstellen:	Ja
Ondersteuning voor plaatsing:	Binnen & buiten
Connectiviteitstechnologie:	Bedraad
Ethernet LAN:	Nee
Montagewijze:	Plafond/muur
Maximum resolutie:	1920 x 1080 Pixels
Totaal aantal megapixels:	2 MP
Diameter:	152 mm
Minimale belichting:	0.01 Lux
Aantal cameras:	1
Video bewegings-detectie:	Ja
Zoomcapaciteit:	Ja
Focus:	Gemotoriseerde/handmatig
Brandpuntbereik:	4.44 - 101.2 mm
Vermogensverbruik (max):	20 W
Aantal ingestelde programma's:	255
Volledige HD:	Ja
Omvang optische sensor:	1/2.8 "
Type beeldsensor:	CMOS
Digitale zoom:	16 x
Optische zoom:	23 x
Camera sluitertijd:	2 - 1/12000 s
Witbalans:	ATW, AWC, Indoor, Manual, Mercury lamp, Outdoor, Sodium lamp
Ondersteunde grafische resoluties:	1920 x 1080 (HD 1080)
Ruisonderdrukking:	Ja
Temperatuur bij opslag:	-50 - 60 °C
Maximaal 30 frames per seconde:	30 fps
Progressive scan:	Ja
Signaal/ruis-verhouding:	50 dB
Power over Ethernet (PoE):	Nee
IK code:	IK10
PTZ control:	Ja
Dag/nacht modus:	Ja
Maximum aperture number:	3.63
Vooringestelde snelheid pan:	700 °/sec
BNC output ports:	1
Achtergrondverlichting compensatie:	Ja
Aantal effectieve pixels (H x V):	1944 x 1104 Pixels
Alarm ingang/uitgang:	Ja
Highlight Compensation (HLC) (compensatie voor sterke belichting):	Ja
Wide Dynamic Range (WDR):	Ja
Wifi:	Nee
Bedrijfstemperatuur (T-T):	-10 - 55 °C
Privézone maskeren:	Ja
Mistbestendig:	Ja
Draaien & spiegelen:	Ja