Godox LED170II Handleiding

Godox Flitser LED170II

Lees hieronder de 📖 handleiding in het Nederlandse voor Godox LED170II (4 pagina's) in de categorie Flitser. Deze handleiding was nuttig voor 38 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Download PDF

Pagina 1/4

LLE

EED V

D V

D VD V

iid

dde

eeo L

o L

o Lo L

iig

ggh

hht

型号/Model:

Instruction manual | 说明手册

Chinese English Bilingual | 中英文双语

705-LED170-09

地址/Add: 深圳市宝安区福永镇福洲大道西新和村华发工业园A4栋

Building A4, Xinhe Huafa Industrial Zone, Fuzhou RD West, Fuyong

Town, Baoan District, Shenzhen 518103, China

电话/Tel: +86-755-29609320(8062) Fax: +86-755-25723423传真/

邮箱/E-mail: godox@godox.com

深圳市神牛摄影器材有限公司

GODOX Photo Equipment Co., Ltd.

5.滤色片更换

● 用手轻轻按住滤色片( 向右推。02)

● 听到“咔”声后，抽出滤色片( 。02)

● 将新滤色片直接插入，向左推移，听到“咔”声

后表示锁紧，更换完毕。

* 设计和规格如有变更，恕不另行通知。

产品型号

灯珠数量

电池供电

DC电源供电

功率

亮度

锂电池供电

色温

调光方式

使用时长(以碱性电池为参考)

色片

工作环境温度

产品尺寸(不包含转轴尺寸)

净重

五、产品参数

LED170 II

170个

8*AA电池

6~12V

<10W

>2700Lux (0.5 米)

SONY NP-F970 ：( 数码摄像机/相机充电电池）

5500~6500K

无级调光

约小时1

柔光片、黄色滤色片各张1

- 度10~55

172*108.6*42.5mm

350g

Thank you for purchasing this Godox Product!

This LED video light is excellent for macrophotography, product shooting,

photojournalistic and video recording, etc. This lightweight and portable

light provides high brightness and accurate color temperature. It comes

with a diffusion filter and a yellow filter, and also supports multiple power

supply modes. You can flexibly control the light brightness by using the

dimmer and change the illumination direction by using the angle adjusting

knobs.

Foreword:

Always keep this product dry. Do not use in rain or in damp conditions.

Do not disassemble. Should repairs become necessary, this product

must be sent to an authorized maintenance center.

Keep out of reach of children.

As this product do not have waterproof function, please take measures

of waterproof in rainy or damp environment.

Do not use or store the product if the ambient temperature reads over

50°C.

Do not use the flash unit in the presence of flammable gases,

chemicals and other similar materials. In certain circumstance, these

materials may be sensitive to the strong light emitting from this flash

unit and fire or electromagnetic interference may result.

Observe precautions when handling batteries

● Do not put batteries into a fire or apply direct heat to them.

● Batteries are prone to leakage when fully discharged. To avoid

damage to the product, be sure to remove batteries when the

product is not used for a long time or when batteries run out of

charge.

● Should liquid from the batteries come into contact with skin or

clothing, rinse immediately with fresh water.

Warning:

01. LED Beads

02. Color Filters

03. Power Switch

04. Brightness Controller

05. Battery Level Indicator

06. DC Power Jack

07. Battery Compartment Lock

08. Battery Compartment

09. Lithium Battery Container

10. Angle Adjusting Knob A

11. Angle Adjusting Knob B

12. Locking Ring

13. Camera Hotshoe Connection

14. 1/4″ Bracket Mounting Hole

15. Reflector

Parts:

1.Power Supply

Three power supply modes are available:

2.Installing the Video Light

● Screw the Locking Ring (12) to the highest point

and insert the Camera Hotshoe Connection (13)

horizontally into the hotshoe of a camera or a

camcorder.

● Tighten the Locking Ring (12).

* When using AA batteries or lithium battery, the Battery

Level Indicator (05) turns green, meaning battery power is

sufficient. When the indicator turns red, the battery power

is low.

* When the indicator turns red and blinks, the lithium battery

power is low. Please recharge it immediately before use in

order to avoid forceful auto off.

* When using DC power supply, the indicator shows green.

● Using batteries: This

light uses AA-sized

alkaline or Ni-MH

rechargeable batteries.

● Using lithium battery:

This light uses SONY

NP-F970 model lithium

battery.

● Using DC power jack:

This light can be powered

by DC power supply. Use

an adapter (purchased

separately) to connect the

light with the AC power

supply. LED126 uses a

6V-9V adapter and

LED170 uses a 6-12V

adapter.

Installation and Operation

Note: If your camcorder has no hotshoe connection,you

are advised to purchase a connecting bracket for camcorder.

The video light has a 1/4″Bracket Mounting Hole as your

camcorder does. Therefore, you can easily connect both the

light and the camcorder to the purchase a connecting bracket

for camcorder.The video light has a 1/4″ Bracket

Product specificaties

Merk:	Godox
Categorie:	Flitser
Model:	LED170II
Kleur van het product:	Zwart
Aan/uitschakelaar:	Ja
Flitsvermogen (max):	- Ws
Flitsvermogen (min):	- Ws
Flitsduratie (max vermogen):	- s