GE ZISW420DR Handleiding

GE Koelkast ZISW420DR

Lees hieronder de 📖 handleiding in het Nederlandse voor GE ZISW420DR (20 pagina's) in de categorie Koelkast. Deze handleiding was nuttig voor 44 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/20
Side by Side Refrigerators
Design Guide
With Installation Instructions
If you have questions,call 800.626.2000 or visit our website at: www.monogram.com
Installation
Instructions
Safety Information
Skill Level Installation of this refrigerator
requires basic mechanical, carpentry and plumbing
skills. Proper installation is the responsibility of the
installer. Product failure due to improper installation
is not covered under the GE Appliance Warranty.
See the Owners Manual for warranty information.
WARNING:
• These refrigerators are top-heavy and must
be secured to prevent the possibility of tipping
forward. Anti-Tip protection is required. See
page 12 for details.
• Use this appliance only for its intended purpose.
• Immediately repair or replace electric service cords
that become frayed or damaged.
• Unplug the refrigerator before cleaning or making
repairs.
• Repairs should be made by a qualified service
technician.
AVERTISSEMENT
• Ces réfrigérateurs sont lourds en haut et il faut les
arrimer pour éviter leur basculement. Il faut avoir
un système de protection contre le renversement.
Voir les détails page 12.
• Il ne faut utiliser cet appareil que pour l’utilisation
appropriée.
• Réparer ou remplacer immédiatement tout cordon
électrique effiloché ou endommagé.
• Il faut débrancher le réfrigérateur avant le
nettoyage ou toute intervention.
• Les réparations doivent être faites par un
technicien qualifié.
For Monogram local service in your area, call
1.800.444.1845.
For Monogram service in Canada, call
1.888.880.3030
For Monogram Parts and Accessories, call
1.800.626.2002.
www. monogram.com
2
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT Save these instructions
for local inspector’s use. Observe all governing codes
and ordinances.
Note to Installer – Be sure to leave these
instructions with the Consumer.
Note to Consumer Keep these instructions
with your Owners Manual for future reference.
WARNING:
This appliance must be properly grounded. See
“Grounding the Refrigerator,” page 10.
AVERTISSEMENT
Cet appareil doit être correctement mis à la terre.
Consulter « Mise à la terre du réfrigérateur », page 10.
If you received a damaged refrigerator, you should
immediately contact your dealer or builder.
CAUTION:
Due to the weight and size of this refrigerator, and
to reduce the risk of personal injury or damage to
the product – THREE PEOPLE ARE REQUIRED
FOR PROPER INSTALLATION OF A 36" WIDE
UNIT. FOUR PEOPLE ARE REQUIRED FOR
INSTALLATION OF A 42" OR 48" WIDE MODEL.
PRUDENCE
À cause du poids et de la taille de ce réfrigérator et
pour réduire le risque de blessure et de dommages,
IL FAUT TROIS PERSONNES POUR INSTALLER
CORRECTEMENT D’UN APPAREIL DE 91 cm (36 po)
DE LARGE. IL FAUT QUATRE PERSONNES POUR
L’INSTALLATION D’UN MODÈLE DE 107 OU 122 cm
(42 OU 48 po) DE LARGE.
CONTENTS
Planning Guide
The Installation Space ....................................3
Dimensions and Clearances ..........................3
130° Door Swing ..............................................4
90° Door Swing ................................................5
Customization Basics ......................................6
1/4" Framed Panel Dimensions ......................7
3/4" Overlay Panel Dimensions ......................8
Raised Overlay Panel Design ........................9
Side Panels......................................................10
Installation Instructions
Tools, Hardware, Materials ........................10
Grounding the Refrigerator ..........................10
Step 1, Remove Packaging ..........................11
Step 2, Install Water Line ............................11
Step 2A, RO Water Line ................................12
Step 3, Install Side Panels ..........................12
Step 4, Install Anti-Tip Brackets ................12
Step 5, Level Refrigerator ............................13
Step 6, Alternate Anti-Tip Procedure ........13
Step 7, Secure Refrigerator to Cabinetry ..14
Step 8, Adjust Door Swing ..........................14
Step 9, Install Grille Panel ............................14
Step 10, Install Framed Panels ....................15
Step 10A, Install Overlay Panels ..........16–17
Step 11, Install Dispenser Trim ....................18
Step 12, Connect Water Supply ..................18
Step 13, Connect Power ..............................19
Step 14, Start Icemaker ................................19
Step 15, Install Toekick ................................19
B
A
Design Guide
THE INSTALLATION SPACE
Water And Electrical Locations
The opening must be prepared with the electrical
and water supply located as shown.
The cutout depth must be 24"
The refrigerator will project forward, slightly beyond
adjacent cabinetry, depending on your installation.
Cutout depth beneath a soffit:
When installed beneath a soffit, the soffit cannot
exceed the 24" installation depth shown. The top case
trim overlaps the bottom of the soffit.
Additional Specifications
• A 115 volt 60Hz., 15 or 20 amp power supply is
required. An individual properly grounded branch
circuit or circuit breaker is recommended. Install
a properly grounded 3-prong electrical receptacle
recessed into the back wall. Electrical must be
located on rear wall as shown.
NOTE: GFI (ground fault interrupter) is not
recommended.
• Water line can enter the opening through the floor
or back wall. The water line should be 1/4" O.D.
copper tubing or GE SmartConnectkit between
the cold water line and water connection location,
long enough to extend to the front of the
refrigerator. Installation of an easily accessible
shut off valve in the water line is required.
DIMENSIONS AND CLEARANCES
* Shipping height. The
refrigerator can be
adjusted to fit into a
cutout that is 83-1/2"
min. to 84-1/2" max.
height. Note that the
top case trim at the
front is 1/2" higher
and will overlap
upper cabinetry or
soffit. Use leveling
legs and wheels for a
maximum 1” height
adjustment.
Product Clearances
These refrigerators are equipped with a 2 position
door stop. The factory set 130° door swing can be
adjusted to 90° if clearance to adjacent cabinets or
walls is restricted.
3
*The finished cutout width must be:
35-1/2" for 36" models
41-1/2" for 42" models
47-1/2" for 48" models
90° Door Swing130° Door Swing
*Finished Width
6"
5"
Electrical
Area
84 1/2" max
83 1/2" min
Finished
Opening 75" From Floor
to Bottom
of Electrical
Area
24"
5" 5" 3 1/2"
Water Supply
3 1/2"
36" Models 12"
42" Models 18"
48" Models 20"
Allow minimum clearances for freezer door
(Dimension A) and fresh food door (Dimension B)
for a full 130° door swing and to allow for pan
removal.
For a 90° door swing, allow 4" min. clearance
to a wall, for framed and stainless steel models.
Allow 5" min. clearance for professional series models.
If the 90° door stop position is used, pan access is
maintained, but pan removal is restricted.
See illustrations pages 4 and 5 to determine
door swing interaction with adjacent cabinets or
countertops.
23-7/8"
Behind
Frame
C
90° Door Swing
*Min. Distance
to Wall
Models A B C
36" 13" 15" 20-5/8"
42" 13" 19" 26-5/8"
48" 15" 20" 28-5/8"
*84" From
Floor to
Top Frame
25-3/8" Framed Models
25-3/4" Stainless Steel Models
Depth Including Handles:
26-7/8" Framed Models
27-3/4" Stainless Steel Models
28-11/16" Professional Models
36", 42" or 48"
Frame to Frame
35", 41", or 47"
Case Width
*83-1/2"
at
Rear
*4" Stainless and
Trimmed Models.
5" Pro Series


Product specificaties

Merk: GE
Categorie: Koelkast
Model: ZISW420DR

Heb je hulp nodig?

Als je hulp nodig hebt met GE ZISW420DR stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Koelkast GE

Handleiding Koelkast

Nieuwste handleidingen voor Koelkast