GE ZDBR240PBS Handleiding

GE Koelkast ZDBR240PBS

Lees hieronder de 📖 handleiding in het Nederlandse voor GE ZDBR240PBS (8 pagina's) in de categorie Koelkast. Deze handleiding was nuttig voor 34 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/8
Design Guide with
Installation
Instructions
monogram.com
Wine Chiller, Wine Reserve
and Beverage Center
Safety Information
2
CONTENTS
Design Guide
The Installation Space .............................. 3
Side-by-Side Installations ..................... 4
Product Clearances ................................... 4
Installation Instructions
Tools Required..............................................5
Grounding the Product ........................... 5
Staining Wood Drawer Fronts ............. 5
Installing the Custom Frame Panel ... 5
Step 1, Remove Packaging .................... 5
Step 2, Reverse Door Swing ................... 6
Step 3, Level .................................................. 7
Step 4, Connect Power ............................. 7
Step 5, Slide Product into Cutout ......... 7
Step 6, Install Nameplate ........................ 7
Step 7, Set Temperature Controls ....... 7
Custom Frame Panel Models ................ 7
Template for Nameplate .... Back Cover
BEFORE YOU BEGIN:
Read these instructions completely and carefully.
IMPORTANT Save these instructions
for local inspector’s use.
IMPORTANT Observe all governing codes
and ordinances.
Note to Installer – Be sure to leave these
instructions with the Consumer.
Note to Consumer – Keep these instructions with
your Owners Manual for future reference.
WARNING This appliance must
be properly grounded. See page 5.
AVERTISSEMENT
Cet appareil doit être correctement mis à la terre.
Consultez page 5.
If you received a damaged wine chiller, wine reserve
or beverage center, you should immediately contact
your dealer or builder.
Skill Level Installation requires basic mechanical
skills. Proper installation is the responsibility of the
installer. Product failure due to improper installation
is not covered under the GE Appliance Warranty.
WARNINGS:
• Use this appliance only for its intended purpose.
• Immediately repair or replace electrical service cords
that become frayed or damaged.
• Unplug the unit before cleaning or making repairs.
• Repairs should be made by a qualied service
technician.
AVERTISSEMENT :
• Il ne faut utiliser cet appareil que pour l’usage pour
lequel il a été construit.
• Il faut réparer ou remplacer immédiatement tout
cordon d’alimentation électrique efloché ou
endommagé.
• Débrancher le bar ou le réfrigérateur a vin avant
le nettoyage ou toute intervention.
• Les réparations doivent être faites par un technicien
qualié.
For Monogram local service in your area, call
1.800.444.1845
For Monogram service in Canada, call
1.800.561.3344
For Monogram Parts and Accessories, call
1.800.626.2002.
www.monogram.com
Design Guide
THE INSTALLATION SPACE
*For a standard installation of Custom-Framed unit: The
product must be installed so that the front face will project 2"
forward of adjacent cabinets. This position will allow a full door
swing and prevent interference with adjacent cabinetry. The
opening between cabinets must be 23-3/4" minimum.
*For a standard installation of Stainless Steel unit: The product
must be installed so that the front face will project 1-3/4"
forward of adjacent cabinets. This position will allow a full door
swing and prevent interference with adjacent cabinetry. The
opening between cabinets must be 23-3/4" minimum.
**For a flush installation of Stainless Steel unit: Install a
1/2"-wide ller strip on the hinge side. The ller strip will act as
a spacer between the door case and adjacent cabinets and will
prevent interference with the cabinet door swing. Recess the
ller strip 2" back from the front face of the unit, or even with
the front edge of the product case (behind the gasket). The width
of the opening must be 24-1/4" (including the 1/2"ller strip).
*** For a flush installation of Custom-Framed unit: Install a
1"-wide ller strip on the hinge side. The ller strip will act as
a spacer between the door case and adjacent cabinets and
will prevent interference with the cabinet door swing. Recess
the ller strip 2" back from the front face of the unit, or even with
the front edge of the product case (behind the gasket). The width
of the opening must be 24-3/4" (including the 1" ller strip).
• The wine chiller, wine reserve and beverage center can
be installed freestanding.
Additional Specifications
A 120 volt 60Hz., 15 or 20 amp power supply is required.
An individual properly grounded branch circuit or circuit
breaker is recommended. Install a properly grounded
3-prong electrical receptacle recessed into the back wall
as shown. Electrical must be located on rear wall as shown.
NOTE: GFI (ground fault interrupter) is not recommended.
3
NOTE:
Handle and handle
standoff depth is 1-3/4"
THE INSTALLATION SPACE (cont.)
These products will t ush to
adjacent cabinets when installed
with a Dim. A-width ller panel
or cleat. The ller panel should
be recessed or set back behind
the door and even with the front
edge of the product case.
Product Dim. A
ZDWI240, ZDBI240 1"
ZDWC240, ZDWR240 1/2"
ZDBC240, ZDBR240 1/2"
In a standard installation,
the product will project forward
of adjacent cabinets. See Dim. A.
Flush
Installation
CABINET
CABINET
CABINET
CABINET
Dim. A
Dim. A
120°
120°
110°
110°
Filler panel or cleat
to be set back even
with front of case.
Front edge of product case
Front face
Front face
Front edge of product case
Standard
Installation
Product Dim. A
ZDWI240, ZDBI240 2"
ZDWC240, ZDWR240 1-3/4"
ZDBC240, ZDBR240 1-3/4"


Product specificaties

Merk: GE
Categorie: Koelkast
Model: ZDBR240PBS

Heb je hulp nodig?

Als je hulp nodig hebt met GE ZDBR240PBS stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Koelkast GE

Handleiding Koelkast

Nieuwste handleidingen voor Koelkast