GE Profile JS998BKBB Handleiding

GE Fornuis Profile JS998BKBB

Lees hieronder de 📖 handleiding in het Nederlandse voor GE Profile JS998BKBB (16 pagina's) in de categorie Fornuis. Deze handleiding was nuttig voor 62 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/16
1
229C4053P547-4
31-10558-4 05-04 JR
Installation
Self-Cleaning Radiant Trivection
Instructions Electric Slide-In Range JS998
BEFORE YOU BEGIN
Read these instructions completely
and carefully.
IMPORTANT Save these
instructions for local inspectors use.
IMPORTANT Observe all
governing codes and ordinances.
Note to Installer Be sure to leave these
instructions with the Consumer.
Note to Consumer Keep these
instructions for future reference.
Skill level Installation of this appliance
requires basic mechanical and advanced
electrical skills.
Completion time 1 to 3 hours
Proper installation is the responsibility of
the installer.
Product failure due to improper installation
is not covered under the Warranty.
WARNING This appliance must
be properly grounded.
Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: www.GEAppliances.com
FOR YOUR SAFETY:
WARNING For personal safety,
do not use an extension cord with this
appliance. Remove house fuse or open circuit
breaker before beginning installation. Failure
to do so could result in serious injury or
even death.
All rough-in and spacing dimensions
must be met for safe use of your range.
Electricity to the range can be disconnected
at the outlet without moving the range if
the outlet is in the preferred location
(remove lower drawer).
FOR YOUR SAFETY: (cont.)
To reduce the risk of burns or fire when
reaching over hot surface elements, cabinet
storage space above the cooktop should be
avoided. If cabinet storage space is to be
provided above the cooktop, the risk can
be reduced by installing a range hood that
protrudes at least 5” beyond the front of
the cabinets. Cabinets installed above a
cooktop must be no deeper than 13”.
Be sure your appliance is properly installed
and grounded by a qualified technician.
To prevent damage to the door and to
prevent excessive microwave leakage,
do NOT remove the door on the oven.
ANTI-TIP DEVICE
WARNING To reduce the risk
of tipping, the appliance must be secured by
properly installed Anti-Tip bracket packed
with this appliance.
If the Anti-Tip device supplied with the
range does not fit this application, use the
universal Anti-Tip device WB2X7909.
WARNING
All ranges can tip
Injury to persons could result
Install Anti-Tip bracket packed
with range
See Installation Instructions
If you pull the range out and away from the
wall for any reason, make sure the Anti-Tip
bracket is engaged when the range is
pushed back against the wall.
Installation Instructions
PREPARE TO INSTALL THE RANGE
TOOLS YOU WILL NEED
Adjustable Wrench
(for 1-7/16Nut)
Level
1/4” Nut Driver
Hand or Saber Saw
1/8” Drill Bit and
Electric or Hand Drill
(Extension May Be
Required)
Pencil
Safety Glasses
Tape Measure
Pliers
Straight Edge
or Square
Gloves
MATERIALS NEEDED
Anchor SleevesLag Bolts
(For Concrete Floors Only)
3-Wire Cord
4‘ Long
with Strain Relief
4-Wire Cord
4‘ Long
with Strain Relief
(UL Approved 40 or 50 AMP)
OR
PARTS INCLUDED
Anti-Tip BracketScrewsRear Filler,
2 Screws
2
PRE-INSTALLATION CHECKLIST
INSPECT INSTALLATION LOCATION
Counter opening extends to the wall:
Maintop Filler (supplied with the range).
(See Alternate Construction section for
Installation Instructions) or Backguard Kit
(Kit JXS37XX) (See Alternate Construction
section)
Counter height greater than 36-3/4:
Lower Trim Slide-In Kit (Kit JXS56XX)
One side is not enclosed by a cabinet:
Bodyside Kit (Kit JXS76XX)
Island Installation:
To provide an optimum installation, the
top surface of the countertop must be level
and flat (lie on the same plane) around the
3 sides that are adjacent to the range
cooktop. Proper adjustments to make the
top flat should be made or gaps between
the countertop and range cooktop may
occur. Forcing the cooktop to fit may cause
excessive gaps and could break the glass
and void the warranty.
To obtain kits, visit the GE Website or call
the GE Answer Center (800.432.2737), or
contact your dealer.
Move range indoors in front of cabinet
opening.
(Do not use hand trucks when moving the
unpackaged range. Cooktop glass may be
broken.)
Protect the kitchen floor! Flatten and place
a piece of the shipping carton in front of the
installation location to protect the flooring.
1
3
Installation Instructions
PRE-INSTALLATION CHECKLIST
(cont.)
Do not remove the protective channel from
the sides of the glass cooktop until later
in the installation.
Carefully, tilt the range to access the range
leveling legs. Use an adjustable wrench to
screw leveling legs out so that glass support
flanges clear the top of the countertop.
Remove packing materials. Remove plastic
on trim and panel, and all tape around the
range.
NOTE: To prevent damage to the door and
to prevent excessive microwave leakage,
do NOT remove the range door. DO NOT LIFT
THE RANGE BY THE HANDLE!
STORAGE DRAWER REMOVAL
Pull the drawer out until it stops.
Lift the front of the drawer until the stops
clear the guides.
Pull forward and remove the drawer.
1
Stop
Rail
Guide
Stop
Protective channel


Product specificaties

Merk: GE
Categorie: Fornuis
Model: Profile JS998BKBB

Heb je hulp nodig?

Als je hulp nodig hebt met GE Profile JS998BKBB stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Fornuis GE

Handleiding Fornuis

Nieuwste handleidingen voor Fornuis