GE Profile JGSP48WHWW Handleiding

GE Fornuis Profile JGSP48WHWW

Lees hieronder de 📖 handleiding in het Nederlandse voor GE Profile JGSP48WHWW (32 pagina's) in de categorie Fornuis. Deze handleiding was nuttig voor 20 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/32
TOOLS YOU WILL NEED
MATERIALS YOU MAY NEED
1
229C4053P535
31-10552 06-03 JR
Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: www.GEAppliances.com
In Canada, call 1.800.361.3400 or Visit our Website at: www.geappliances.ca
Installation
Gas Slide-In Range
Instructions JGSP48, JGS968
BEFORE YOU BEGIN
Read these instructions completely
and carefully.
IMPORTANT Save these
instructions for local inspectors use.
IMPORTANT Observe all
governing codes and ordinances.
Note to Installer Be sure to leave these
instructions with the Consumer.
Note to Consumer Keep these
instructions for future reference.
Product failure due to improper installation
is not covered under the Warranty.
WARNING This appliance must
be properly grounded.
IMPORTANT Leak testing of the
appliance shall be conducted according to
the manufacturer’s instructions.
Proper installation is the responsibility
of the installer and product failure due to
improper installation is NOT covered under
warranty.
IN THE COMMONWEALTH OF
MASSACHUSETTS:
This product must be installed by a
licensed plumber or gas fitter.
When using ball-type gas shut-off valves,
they shall be the T-handle type.
A flexible gas connector, when used, must
not exceed 3 feet.
PARTS INCLUDED
Anti-Tip Bracket
Shut Off ValvePipe Fittings
CSA-Approved Flexible Gas Line
3/8Min. ID, 1/2NPT Connection,
3-foot Maximum Length (Massachusetts Only)
Joint Sealant
Wrench or Pliers
(for 1-7/16” Nut)
Level
1/4” Nut Driver
Safety Glasses Drill
Tape Measure
Screws
Rear Filler
2 Screws
Phillips Head
Screwdriver
Pipe Wrench
FOR YOUR SAFETY:
WARNING If the information in
this manual is not followed exactly, a fire,
explosion or gas leak may result causing
property damage, personal injury or death.
Do not store or use gasoline or other
flammable vapors and liquids in the vicinity
of this or any other appliance!
WHAT TO DO IF YOU
SMELL GAS:
Do not try to light any appliance. Do not
touch any electrical switch; do not use any
phone in your building.
Immediately call your gas supplier from a
neighbors phone. Follow the gas supplier’s
instructions.
If you cannot reach your gas supplier, call
the fire department.
Installation and service must be performed by
a qualified installer, service agency or the gas
supplier.
2
Installation Instructions
IMPORTANT SAFETY INSTRUCTIONS
This range has been design certified by
UNDERWRITERS LABORATORIES for use in
the United States and Canada. You’ll find
safety precautions in your Owner’s Manual.
Read them carefully.
Installation of this range must conform with
local codes or in the absence of local codes
with the National Fuel Gas Code, ANSI
Z223.1–Latest edition.
Be sure your range is installed properly by
a qualified installer or service technician.
To eliminate reaching over surface burners,
cabinet storage above burner should be
avoided.
Do not install the unit near an outside door
or where a draft may affect its use.
3
Installation Instructions
ANTI-TIP DEVICE
WARNING To reduce the risk
of tipping, the appliance must be secured by
properly installed Anti-Tip bracket packed
with this appliance.
To check if the bracket is installed and
engaged properly, carefully tip the range
forward. The anti-tip bracket should engage
and prevent the range from tipping over.
WARNING
All ranges can tip
Injury to persons could result
Install Anti-Tip bracket packed
with range
See Installation Instructions
If you pull the range out and away from the
wall for any reason, make sure the Anti-Tip
bracket is engaged when the range is pushed
back against the wall.
ELECTRICAL REQUIREMENTS
This appliance must be supplied with the
proper voltage and frequency and connected
to an individual, properly grounded branch
circuit, protected by a circuit breaker or fuse
having amperage as noted on the rating
plate. (Rating plate is located above the
storage drawer below the oven frame).
We recommend you have the electrical wiring
and hookup of your range connected by a
qualified electrician. After installation, have
the electrician show you where your main
range disconnect is located.
Check with your local utilities for electrical
codes which apply in your area. Failure to
wire your range according to governing
codes could result in a hazardous condition.
If there are no codes, your range must be
wired and fused to meet the requirements of
the National Electrical Code, ANSI/NFPA No.
70–Latest edition. You can get a copy by
writing:
National Fire Protection Association
Batterymarch Park
Quincy, MA 02269
In Canada your range must be wired
and fused to meet the requirements of the
Canadian Electrical Code.
Be sure the installation of this product
in a mobile home conforms with the
Manufactured Home Construction and
Safety Standard, Title 24 CFR, Part 3280.
If this standard does not apply, you must
follow the standard for Manufactured Home
Installations, ANSI A225.1 and Manufactured
Home Installations, Sites and Communities
and ANSI/NFPA 501A or with local codes.
You can get a copy of the Federal Standard
by Writing:
Office of Mobile Home Standards
HUD Building
451 7th Street, S.W.
Washington, D.C. 24010


Product specificaties

Merk: GE
Categorie: Fornuis
Model: Profile JGSP48WHWW

Heb je hulp nodig?

Als je hulp nodig hebt met GE Profile JGSP48WHWW stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Fornuis GE

Handleiding Fornuis

Nieuwste handleidingen voor Fornuis