GE JV337XWH Handleiding

GE Afzuigkap JV337XWH

Lees hieronder de 📖 handleiding in het Nederlandse voor GE JV337XWH (12 pagina's) in de categorie Afzuigkap. Deze handleiding was nuttig voor 20 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/12
Use and Care of Recirculation Hood Model JN327
and Ventilating Hood Models JV327, JV337 & JV347
IMPORTANT SAFETY
INFORMATION
READ ALL INSTRUCTIONS
BEFORE USING.
WARNING—TO REDUCE THE RISK
OF FIRE, ELECTRIC SHOCK OR
INJURY TO PERSONS, OBSERVE
THE FOLLOWING:
A. Use this unit only in the manner intended by
the manufacturer. If you have any questions,
contact the manufacturer.
B. Before servicing or cleaning unit, switch
power off at service panel and lock the service
disconnecting means to prevent power from
being switched on accidentally. When the service
disconnecting means cannot be locked, securely
fasten a prominent warning device, such as a tag,
to the service panel.
CAUTION—For general ventilating use only.
Do not use to exhaust hazardous or explosive
materials and vapors.
When you get your new hood…
• Have it installed and properly grounded by
a qualied technician in accordance with the
installation instructions.
• Have the installer show you the location of
the hood circuit breaker or fuse and mark it
for easy reference.
• Take the time to read our suggestions for best use.
WARNING—TO REDUCE THE RISK
OF FIRE, ELECTRIC SHOCK OR
INJURY TO PERSONS, OBSERVE
THE FOLLOWING:
A. Installation work and electrical wiring must be
done by qualified person(s) in accordance with
all applicable codes and standards, including
fire-rated construction.
B. Sufficient air is needed for proper combustion
and exhausting of gases through the flue
(chimney) of fuel burning equipment to prevent
back drafting. Follow the heating equipment
manufacturer’s guidelines and safety standards
such as those published by the National Fire
Protection Association (NFPA), and the
American Society for Heating, Refrigeration
and Air Conditioning Engineers (ASHRAE),
and the local code authorities.
C. When cutting or drilling into wall or ceiling,
do not damage electrical wiring and other
hidden utilities.
D. Ducted fans must always be vented to the
outdoors.
WARNING—To reduce the risk of fire,
use only metal ductwork.
When using your hood…
• Never leave surface units unattended at high
settings. Boilover causes smoking and greasy
spillovers that may ignite and spread if hood is
used. Use surface unit heat settings recommended
by the manufacturer and adequate-size utensils.
• Never use your cooking appliance for warming
or heating the room. The electrical wiring of
your range hood may not withstand the resulting
excessive heat.
• Keep the hood clean and clean grease lter
or replace charcoal lter as recommended to
maintain good venting and to avoid grease res.
WARNING—TO REDUCE THE RISK
OF A RANGE TOP GREASE FIRE:
A. Never leave surface units unattended at high
settings. Boilovers cause smoking and greasy
spillovers that may ignite. Heat oils slowly on
low or medium settings.
B. Always turn hood ON when cooking at high
heat or when cooking aming foods.
C. Clean ventilating fans frequently. Grease should
not be allowed to accumulate on fan or filter.
D. Use proper pan size. Always use cookware
appropriate for the size of the surface element.
(continued next page)
GE Quality Product
IMPORTANT SAFETY
INSTRUCTIONS (continued)
WARNING—TO REDUCE THE RISK
OF INJURY TO PERSONS IN THE
EVENT OF A RANGE TOP GREASE
FIRE, OBSERVE THE FOLLOWING:
*
A. SMOTHER FLAMES with a close-fitting lid,
cookie sheet, or metal tray, then turn off the burner.
BE CAREFUL TO PREVENT BURNS. If the
flames do not go out immediately, EVACUATE
AND CALL THE FIRE DEPARTMENT.
B. NEVER PICK UP A FLAMING PAN—
You may be burned.
C. DO NOT USE WATER, including wet dishcloths
or towels—a violent steam explosion will result.
D. Use an extinguisher ONLY if:
1. You know you have a Class ABC extinguisher,
and you already know how to operate it.
2. The re is small and contained in the area
where it started.
3. The re department is being called.
4. You can ght the re with your back to an exit.
*Based on “Kitchen Firesafety Tips” published by NFPA.
WARNING: The electrical wiring and fan
motor in this range hood are not intended
for use with, or provided with, a solid state
speed control. Any such alteration from
original factory wiring concept could result
in damage to the unit and/or create an
electrical safety hazard.
READ AND SAVE THESE
INSTRUCTIONS
Models: JN327 & JV347—non-ducted installations only
Your hood is equipped with a replaceable charcoal lter.
When the fan is operated, air is drawn through the filter
and discharged into the room through the hood.
Model: JV327—ducted installations only
Your hood is equipped with a metal grease lter.
When the fan is operated, air is drawn through the
lter and discharged to the outside.
Models: JV337 & JV347—ducted installations only
Your hood is equipped with a reusable metal grease
lter. When the fan is operated, air is drawn through
the lter and discharged to the outside.
CAUTION—before operating the hood:
•Install the lamp bulb (not provided). See the
Lamp Replacement instructions.
If You Need Service…
• Do not attempt to repair or replace any part of
your hood unless it is specifically recommended
in this book. All other servicing should be referred
to a qualified technician.
• Disconnect hood circuit breaker or fuse before
performing any service.
2
Replaceable charcoal lter
Grease
lter
(Model JV347 has a lamp cover.)
Lamp
holder
Grease lter
(Model JV347 has a lamp cover.)
Lamp
holder
Lamp
holder
To Operate
Lamp Switch
Models: JN327, JV327, JV337
Press for OFF and ON.
Lamp Switch
Model: JV347
Rotate clockwise, rst position for NIGHT LIGHT,
second position for BRIGHT LIGHT.
Fan Switch
Models: JN327, JV327, JV337
CENTER position OFF, DOWN position LOW SPEED,
TOP position HIGH SPEED.
Model: JV347
Rotate Clockwise, FIRST position HIGH, SECOND
position MEDIUM, THIRD position LOW.
Care and Cleaning
Replaceable Charcoal Filter—Used in
non-ducted installations only.
Models: JN327, JV347—non-ducted installations only
The charcoal lter cannot be cleaned. It must be
replaced.
DO NOT RINSE OR PLACE THE CHARCOAL
FILTER IN A DISHWASHER.
The efficiency of your hood depends upon a clean filter.
The frequency of filter replacement depends on hood
use and the type of cooking you do. See replacement
guidelines below for your non-ducted model installation.
NEVER OPERATE THE HOOD WITHOUT THE
FILTER IN PLACE.
When to replace the lter:
JN327 and JV347 (non-ducted installations only)—The
lter should be replaced after 6 to 12 months. Order and
replace with genuine GE part: WB02X10700.
To remove: Pull down on the center of the front edge of
the lter. The lter will then slip out of the retaining tabs
on the back.
To replace:
Slip the back edge of the filter into the retaining
tabs and push the front edge up until it snaps in place.
Reusable Metal Grease Filter—Used in
ducted installations only.
Models: JV327, JV337, JV347—ducted installations only
The eciency of your hood depends on a clean lter.
Frequency of cleaning depends on hood use and the type
of cooking you do. HOWEVER, THE GREASE FILTER
SHOULD BE CLEANED AT LEAST ONCE A MONTH.
NEVER OPERATE THE HOOD WITHOUT THE
FILTER IN PLACE.
To remove: Pull down on the center of the front edge of
the lter. The lter will then slip out of the retaining tabs
on the back.
To clean: Soak and then agitate it in a hot water and
detergent solution. Light brushing can be used to remove
embedded dirt. Rinse, shake and let it dry before replacing.
To replace: Slip the back edge of the lter into the
retaining tabs and push the front edge up until it snaps
into place.
With careful handling, the metal lter will last for years.
If a new replacement becomes necessary, order the part
from your dealer. Order genuine GE part: WB02X8391.
Hood
Clean grease laden surfaces of the hood frequently.
Use warm detergent solution. About 1 tablespoon of
ammonia may be added to the water. TAKE CARE TO
NOT COME IN CONTACT WITH FILTERS AND
OTHER NON-ENAMELED SURFACES. The hood
shell can be washed, rinsed and dried with a soft cloth.
Motor and Fan
To Clean Motor and Fan
1. DISCONNECT THE HOOD POWER SUPPLY AT
THE HOUSEHOLD DISTRIBUTION PANEL BY
REMOVING THE FUSE OR SWITCHING OFF
THE CIRCUIT BREAKER.
2. Remove the lter.
3. Wipe the fan blade and motor with cloth, dampened
only in ammonia and warm water solution.
4. Replace the lter.
5. Reconnect the hood power supply.
CAUTION: Be certain when cleaning the hood
surfaces you do not touch the lamp bulb with moist
hands or cloth. A warm or hot lamp bulb may break
if touched with a moist surface. ALWAYS let lamp
cool COMPLETELY before cleaning around it.
3
Vents (JN327 & JV347)
Fan switch Lamp switch


Product specificaties

Merk: GE
Categorie: Afzuigkap
Model: JV337XWH

Heb je hulp nodig?

Als je hulp nodig hebt met GE JV337XWH stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Afzuigkap GE

Handleiding Afzuigkap

Nieuwste handleidingen voor Afzuigkap

Miele

Miele DA 6520 D Handleiding

21 November 2024
Miele

Miele DA 420-4 Handleiding

21 November 2024
Miele

Miele DA 2660 Handleiding

21 November 2024
XO

XO R230W Handleiding

21 November 2024
Ilve

Ilve AGK90 Handleiding

20 November 2024
Ilve

Ilve AGQ90 Handleiding

20 November 2024
Ilve

Ilve AGQ60 Handleiding

20 November 2024
Ilve

Ilve AGQ120 Handleiding

20 November 2024
Ilve

Ilve AGK120 Handleiding

20 November 2024